Post on 13-Jan-2020
Step 1. Connect your strips to controller (take
WS2812B for example)
I just connect strip to one port, you can connect as
many port as you want based on your project.
Step 2. Program with LED Build
LED Build Software Download Link:
https://drive.google.com/open?id=1DUF7TwbdJ-
k_RLnPPTMX3rhHBc1x6EYA
LED Build Software Tutorial Video(especially for
H803SA): https://drive.google.com/open?
id=1scuoAgFEXGQSubIM6dblVSMdj20xuBy7
Test file download:
https://drive.google.com/open?
id=0B1gzqyV6hfOgcE1DbDNKVG5uZmM (8 ports,
each port 300 pixels, for WS2811, WS2812 and
other single line chips, just put these files in sd
card)
Basically, you can learn everything you need to
make H803SA work from the video. The
following is some text explanation.
Place Pixels
Light Setting
Tips
(1) . In sculpt window, you can press “Ctrl” as
dragging a rectangle from a point, you can set
size as you want.
(2) . when you choose color in color plate, click
one color, press “Ctrl” as clicking another
color(or the same color), one color will gradually
change to another color.
Step3. Output controller data and put it into SD
card
Step 4. Configure controller with three buttons
Work with DMX Console
This mode also needs SD card. SD card stores files.
When H803SA is connected to DMX console, you can
use DMX console to switch files, change speed and
brightness.
For example if DMX address is 1, channel 1,2,3 on
console are available.
If DMX address is 2, channel 4,5,6 on console are
available, etc. You can also connect DMX console to
multiple H803SAs together.