Post on 31-Dec-2015
VARCO PRUDEN’S Self Curbing Day Lighting Solution
PrisMAX SL for SSR & HWR Roof’s
PrisMAX SL GUIDES
There are many versions of PrisMAX SL Installation Guides. It is important to review the guide that is sent with the “For Construction Package” before installation. Before installation, contact Varco Pruden if guide is lost or missing. This Presentation show the Basic installation on SSR. Installation on HWR is similar, but many parts will be different.
PrisMAX SL MODEL
PrisMAX SL DIVERTER
Current Model Lens has top mounted screws vs side installed.
PrisMAX SL CROSS SECTION
BE SAFE!
TOOLS
Note: A Rivet Tool for a 9/32” Olympic Rivet will be required for installing side rail rivets.
PARTS
PARTS
PARTS
PARTS
BEGIN
Locating the PrisMAX Unit
Cutting the Rib
Locating the PrisMAX Unit
Cutting Access Hole
Preparing Diverter
Sealing the Closures
Preparing the Support Plate and the diverter
Preparing the Support Plate and the diverter(cont.)
Installing the Support Plate and the diverter
Installing the Support Plate and the diverter
Installing the Side Rails
Multiple Units
Installing Side Rails
Upper Diverter Closure
Lower Diverter Closure & CuttingAccess Hole
Lower Diverter Closure & CuttingAccess Hole
Cutting The RoofPanels
Insulation
Insulation
Foam Tape
Insulation Trim
Insulation Trim
Accessories
Accessories
Tape WhenAccessoriesAre Used
Preparing for Lens
Attaching the Lens
THE END of PrisMAXInstallation
Installed “PrisMAX SL” Trim Kits
Installation of the “PrisMAX SL” Install first 10’-0” Lowside Unit for
“multi-unit” systems
Installed “PrisMAX SL”
Installed “PrisMAX SL”
Installed “PrisMAX SL”
“PrisMAX SL”
“PrisMAX SL”