Configuration Guide for Panasonic KX-NS1000

1 | P a g e XO Communications Confidential

Panasonic KX-NS1000 V.4.2 Configuration Guide

Configuration Guide for Panasonic KX-NS1000

2 | P a g e XO Communications Confidential

Table of Contents 1 Introduction .................................................................................................... 3 2 Executive Summary ....................................................................................... 4

3 Software and Hardware Equipment Requirements for Testing ...................... 5 4 Test Configurations ........................................................................................ 6 4.1 Lab Configuration 6 5 Panasonic Configuration ................................................................................ 7

Configuration Guide for Panasonic KX-NS1000

3 | P a g e XO Communications Confidential

1 Introduction

This document contains the test results of the SIP Trunking used to certify Panasonic IP PBX. This test verified the basic interoperability, features of the appliance, and the integration of the architecture framework. This certification test plan is to be executed in XO’s Plano Certification Laboratory (Plano Lab) which is equipped with different test equipments and is capable to simulate XO’s VoIP network environment.

Configuration Guide for Panasonic KX-NS1000

4 | P a g e XO Communications Confidential

2 Executive Summary

This report provides the test results found to date for the Panasonic IP PBX SIP Trunking evaluation. The following is a summary addressed the issues and limitation found while performing the test.

“Diversion” header is not working properly so that the Call Forward originated from PSTN and forwarded back to another PSTN number, the 3rd party can only see the 2nd party calling ID instead of the 1st party.

Call Transfer with or without REFER works fine. But the Blind Call Transfer with REFER works but has to use a specific dialing : When the 1st party is talking to the 2nd party, the 2nd party must do the following to make Blind Transfer working - <press Transfer Key>, <press *61 when hearing dial tone>, <press a PSTN number>, <press #>.

Due to no analog port in the machine under test, fax and analog calls are not tested.

Registration Method

Static registration is utilized between the Panasonic IP phones and the XO call agent.

XO SIP Service Packages Supported

Pkg Codec DTMF Fax

1 G.711 RFC 2833 / in-band DTMF T.38 / G.711 pass-through

2 G.729a/G.711 RFC 2833 / in-band DTMF T.38 / G.711 pass-through

Configuration Guide for Panasonic KX-NS1000

5 | P a g e XO Communications Confidential

3 Software and Hardware Equipment Requirements for Testing

1. Panasonic KX-NS1000 Software version : 4.2

2. 2 Panasonic IP Phones

Model no.: KX-NT 551, KX-NT 556

Configuration Guide for Panasonic KX-NS1000

6 | P a g e XO Communications Confidential

4 Test Configurations

4.1 Lab Configuration

The following diagram is the configuration used during lab testing.

4693873331

IP Phone – 192.168.0.20

Panasonic

Signal

192.168.0.101

IAD FE 0/1205.158.163.82

255.255.255.248

XO Network

4693873330

IP phone 192.168.0.10

XO Lab Setup for

Panasonic IPPBx Testing

Media

192.168.0.102

192.168.0.199

207.155.151.90

Note: Above lab setup only shows main lab network elements. Above setup shows NAT configuration is required on XO router (IAD) when IPPBX and IP phones have private IPs.

For detail, please refer to the attachment of IAD configuration.

Configuration Guide for Panasonic KX-NS1000

7 | P a g e XO Communications Confidential

5 Panasonic Configuration

Main screen

Configuration Guide for Panasonic KX-NS1000

8 | P a g e XO Communications Confidential

Virtual slot

Configuration Guide for Panasonic KX-NS1000

9 | P a g e XO Communications Confidential

Virtual Port - (Virtual SIP Gateway – Shelf Property)

*Make sure SIP Client port number should be 5060.

Configuration Guide for Panasonic KX-NS1000

10 | P a g e XO Communications Confidential

IP Address for Signaling IP Address of IPPBX - (NAT) internal: 192.168.0.101, external: 207.155.151.90 IP Address for Media IP Address of IPPBX – 192.168.0.102 Default Gateway -> IP Address of XO Router (IAD) – 192.168.0.1

Configuration Guide for Panasonic KX-NS1000

11 | P a g e XO Communications Confidential

VOIP port setting – Main IP Address -> XO NBS IP Address

Configuration Guide for Panasonic KX-NS1000

12 | P a g e XO Communications Confidential

VOIP port setting - Account

Configuration Guide for Panasonic KX-NS1000

13 | P a g e XO Communications Confidential

VOIP port setting – Registration (Disable – due to static SIP)

Configuration Guide for Panasonic KX-NS1000

14 | P a g e XO Communications Confidential

VOIP port setting - Option

Configuration Guide for Panasonic KX-NS1000

15 | P a g e XO Communications Confidential

VOIP port setting - Calling party

Configuration Guide for Panasonic KX-NS1000

16 | P a g e XO Communications Confidential

VOIP port setting - RTP/RTCP (DSCP bit configuration)

Configuration Guide for Panasonic KX-NS1000

17 | P a g e XO Communications Confidential

VOIP port setting - Codec settings:

Configuration Guide for Panasonic KX-NS1000

18 | P a g e XO Communications Confidential

VOIP port setting - Codec settings (continue): (shows Fax / DTMF configuration)

Configuration Guide for Panasonic KX-NS1000

19 | P a g e XO Communications Confidential

VOIP port setting - “Supplementary Service” – CNIP (receive) – ‘Yes’ to display inbound CNAM; Blind/Attended Transfer (REFER) is enabled.

Configuration Guide for Panasonic KX-NS1000

20 | P a g e XO Communications Confidential

Trunk settings:

Configuration Guide for Panasonic KX-NS1000

21 | P a g e XO Communications Confidential

COS settings for trunk:

Configuration Guide for Panasonic KX-NS1000

22 | P a g e XO Communications Confidential

DID settings:

Configuration Guide for Panasonic KX-NS1000

23 | P a g e XO Communications Confidential

Group priority setting

Configuration Guide for Panasonic KX-NS1000

24 | P a g e XO Communications Confidential

Numbering plan

Incoming call distribution group (Hunt group)

Configuration Guide for Panasonic KX-NS1000

25 | P a g e XO Communications Confidential

Normal “Hunt Group”

“Extension No Answer Redirection Timer” to find next member

Configuration Guide for Panasonic KX-NS1000

26 | P a g e XO Communications Confidential

“Overflow No Answer”

Configuration Guide for Panasonic KX-NS1000

27 | P a g e XO Communications Confidential

Extension settings:

Configuration Guide for Panasonic KX-NS1000

28 | P a g e XO Communications Confidential

Call forward settings done from extension: (below screen shot was for call forward always to 9725786857)

Intercept (to VM)

Configuration Guide for Panasonic KX-NS1000

29 | P a g e XO Communications Confidential

Intercept time (‘0’ indicates ‘default system time’ = 10 sec for lab)

Voice Mail

Configuration Guide for Panasonic KX-NS1000

30 | P a g e XO Communications Confidential

CLIP

Configuration Guide for Panasonic KX-NS1000

31 | P a g e XO Communications Confidential

Auto Attendant

Panasonic Software Version under test :