Lost In Paradise (Black)

Kaleidoscope Quilt

~ Finished Size 33”x44” ~

Supply List:

• 1 Set of 6—10” Pre Cut Kaleidoscope Blocks

• 1 Yard Accent Fabric (sashing, inner border & binding)

• 1/2 Yard Focus Fabric (outer border)

** PLEASE READ DIRECTIONS THOROUGHLY BEFORE BEGINNING **

If you do not already have directions to construct your pre cut

Kaleidoscope Blocks, you can find them on our website

www.labfabrics.com in our pattern download section.

Step 1: Construct your 6 Kaleidoscope Blocks, once constructed, square each block to 10.5”

Step 2: From the accent fabric, cut 6 strips at 2”xwof,

using 4 of those strips, sub-cut each into a 10.5” piece

and a 22” piece. Then using 3 of the 10.5” pieces as

sashing, connect two blocks as shown in Fig. 1,

make a total of 3 sets of these.

Step 3: Using the 4 22” pieces, now connect these 3 sets of blocks together shown in Fig. 2. Then add one

to the top and one to the bottom, these will be the top and bottom

of the inner border.

Step 4: Measure your quilt lengthwise, then cut your remaining 2 strips

to this measurement and sew to both sides to complete your inner

border.

Step 5: From the focus fabric, cut 4 strips at 3.5”, then measure your

quilt width wise, use this measurement to cut your top and bottom

outer borders pieces, sew to top and bottom. Then measure your quilt

lengthwise, again use that measurement to cut your side outer borders,

(you many need to piece with leftover pieces to get to desired length).

Step 6: Quilt as desired.

Step 7: From the remaining accent fabric, cut 5 strips at 2.5” and bind your quilt!!

Fig. 1

22” Pieces

Fig. 2

Thank you again for your purchase, we hope you had fun making this beautiful quilt.

Visit us at

www.labfabrics.com

For more of our pre-cut Kaleidoscope Kits, blocks, patterns and more.