Post on 19-Jul-2015
lexia 3: SP08-C
http://www.diyobd2.fr/wholesale/lexia-3-pp2000-citroen-peugeot-diagnostic-inter
face.html
diagbox:
http://www.diyobd2.fr/wholesale/diagbox-v724-software-for-lexia-3-pp2000-peugeot-citroen-di
agnostic-tool.html
How Peugeot 508 2011 BSI connect on table
I have
This car: Peugeot 508 2011 with BSI: 9664992380 I need the gnd, power and can
lines to connect on the table.
Solved:
2 pin black connector 2VNR pin 1 and 2 +bat.
60 pin blue connector 60VBE pin 32 +15(ignition), pin 16 Can high(wire nr. 9017A),
pin 18 Can low(wire nr. 18)
16 pin grey connector 16VGR pin 16 - gnd
60 pin black connector 60VNR pin 26- gnd
Question: I see in the navi screen eco modus ON. Can I switch this off?
Answer: Give more than 12v. Like 14 make it think alternator is workins so it will go
out of ecomode.
Question: I go to a local Peugeot dealer and look in there dealer tool ( lexia 3) and it seems you
can put BSI in show room mode this will put BSI out eco modus.
I connect BSI on table and connect lexia tool to it:
OBD socket on lexia:
4 and 5 ground
PIN 16 12v
pin 6 can high to BSI bleu connector pin 16
pin 14 can low to bleu connector pin 18
Problem is i cant see BSI @ tarts do i need K-LINE from obd pin 11 to BSI?
or can i trigger the BSI with some wire that he think the car is running?
Answer: change the fuse gris to user mode, then with diagbox go to car preparation and select
user mode.
Question: how to speak on table with BSI CAN OR K-LINE?
I can’t see BSI thats my problem with lexia.
Answer: use the k line, 11 bsi and 7 on obd lexia.
The pin of the K-LINE on the BSI, schematics