lexia 3: SP08-C

http://www.diyobd2.fr/wholesale/lexia-3-pp2000-citroen-peugeot-diagnostic-inter

face.html

diagbox:

http://www.diyobd2.fr/wholesale/diagbox-v724-software-for-lexia-3-pp2000-peugeot-citroen-di

agnostic-tool.html

How Peugeot 508 2011 BSI connect on table

I have

This car: Peugeot 508 2011 with BSI: 9664992380 I need the gnd, power and can

lines to connect on the table.

Solved:

2 pin black connector 2VNR pin 1 and 2 +bat.

60 pin blue connector 60VBE pin 32 +15(ignition), pin 16 Can high(wire nr. 9017A),

pin 18 Can low(wire nr. 18)

16 pin grey connector 16VGR pin 16 - gnd

60 pin black connector 60VNR pin 26- gnd

Question: I see in the navi screen eco modus ON. Can I switch this off?

Answer: Give more than 12v. Like 14 make it think alternator is workins so it will go

out of ecomode.

Question: I go to a local Peugeot dealer and look in there dealer tool ( lexia 3) and it seems you

can put BSI in show room mode this will put BSI out eco modus.

I connect BSI on table and connect lexia tool to it:

OBD socket on lexia:

4 and 5 ground

PIN 16 12v

pin 6 can high to BSI bleu connector pin 16

pin 14 can low to bleu connector pin 18

Problem is i cant see BSI @ tarts do i need K-LINE from obd pin 11 to BSI?

or can i trigger the BSI with some wire that he think the car is running?

Answer: change the fuse gris to user mode, then with diagbox go to car preparation and select

user mode.

Question: how to speak on table with BSI CAN OR K-LINE?

I can’t see BSI thats my problem with lexia.

Answer: use the k line, 11 bsi and 7 on obd lexia.

The pin of the K-LINE on the BSI, schematics