#60295 TOOL ORGANIZERASSEMBLY INSTRUCTIONS

MM061212

It will take just a few minutes to prepare yourTool Organizer for use. Only a pencil is needed.

340 Snyder Avenue

Berkeley Heights, NJ 07922

Tech Support: 908-464-1094,  1pm–5pm ET

www.micromark.com MMTechService@micromark.com

D D D D D D D D

C C C C C C C

AB B B B A

2. Insert two large tubes (2-1/2” long) into holes marked A in

the photo below.

3. Insert four small tubes (2-1/2” long) into holes marked B.

4. Insert seven small tubes (4” long) into holes marked C.

5. Insert eight small tubes (5” long) into holes marked D.

Position the bottom of each tube between the guide rails

molded into the inside of the bottom cover: Insert the eraser

end of a pencil into the tube and use as a tool to shift the

bottom end into position.

1. Peel and stick one rubber foot to each of the circles molded

into each corner of the bottom cover.

#60295 TOOL ORGANIZERASSEMBLY INSTRUCTIONS

MM061212

It will take just a few minutes to prepare yourTool Organizer for use. Only a pencil is needed.

340 Snyder Avenue

Berkeley Heights, NJ 07922

Tech Support: 908-464-1094,  1pm–5pm ET

www.micromark.com MMTechService@micromark.com

D D D D D D D D

C C C C C C C

AB B B B A

2. Insert two large tubes (2-1/2” long) into holes marked A in

the photo below.

3. Insert four small tubes (2-1/2” long) into holes marked B.

4. Insert seven small tubes (4” long) into holes marked C.

5. Insert eight small tubes (5” long) into holes marked D.

Position the bottom of each tube between the guide rails

molded into the inside of the bottom cover: Insert the eraser

end of a pencil into the tube and use as a tool to shift the

bottom end into position.

1. Peel and stick one rubber foot to each of the circles molded

into each corner of the bottom cover.

#60295 TOOL ORGANIZERASSEMBLY INSTRUCTIONS

MM061212

It will take just a few minutes to prepare yourTool Organizer for use. Only a pencil is needed.

340 Snyder Avenue

Berkeley Heights, NJ 07922

Tech Support: 908-464-1094,  1pm–5pm ET

www.micromark.com MMTechService@micromark.com

D D D D D D D D

C C C C C C C

AB B B B A

2. Insert two large tubes (2-1/2” long) into holes marked A in

the photo below.

3. Insert four small tubes (2-1/2” long) into holes marked B.

4. Insert seven small tubes (4” long) into holes marked C.

5. Insert eight small tubes (5” long) into holes marked D.

Position the bottom of each tube between the guide rails

molded into the inside of the bottom cover: Insert the eraser

end of a pencil into the tube and use as a tool to shift the

bottom end into position.

1. Peel and stick one rubber foot to each of the circles molded

into each corner of the bottom cover.