Post on 24-Dec-2015
Chock truck, ensure safety first. Use conventional safety systems. These instructions
relate to AIR CTI only.
WARNING; THE INSIDE OF THE TYRE AND RIM MUST BE CLEAN. WIPE INSIDE OF TYRE
TO ENSURE CLEANLINESS. ANY DIRT WILL DAMAGE ROTATORS AND NEGATE ANY
WARRANTY.
1. Turn off all wheel taps.
2. Quick Connect Fittings: Push button on quick connect tyre hose fittings, hold button
in fully, and remove. Otherwise the o ring may be damaged
Nut and Tail: Clamp hose to limit air loss with a tubing clamp. Undo nut using two
spanners (wrenches), one on nut, and one on nipple. Do not allow the nipple or tap to
rotate, as this will cause a leak.
3. Undo and remove the two rotator mounting bolts.
4. Swing rotator assembly, with drop pipe, up and out of the way. Secure as needed.
5. Change tyre, aligning the Schrader valve in the identical spot. Schrader valves must
be on opposite sides, to ensure correct wheel balance, and for hose fitment.
6. Tyre hoses can be installed prior to tyre install if needed. Do not over tighten tyre
hose fitting onto the Schrader valve.
7. Always remove the valve core in the new tyres’s Schrader valve.
C T I A I R
PH: (03) 5127 6128
MOB: 0427 110203
120 Walhalla Rd.
Push and hold
quick connect but-
Use 2 spanners on
Tighten crimp
TYRE CHANGING INSTRUCTIONS