12 Tyre Change

1
Chock truck, ensure safety first. Use conventional safety systems. These instructions relate to AIR CTI only. WARNING; THE INSIDE OF THE TYRE AND RIM MUST BE CLEAN. WIPE INSIDE OF TYRE TO ENSURE CLEANLINESS. ANY DIRT WILL DAMAGE ROTATORS AND NEGATE ANY WARRANTY. 1. Turn off all wheel taps. 2. Quick Connect Fittings: Push button on quick connect tyre hose fittings, hold button in fully, and remove. Otherwise the o ring may be damaged Nut and Tail: Clamp hose to limit air loss with a tubing clamp. Undo nut using two spanners (wrenches), one on nut, and one on nipple. Do not allow the nipple or tap to rotate, as this will cause a leak. 3. Undo and remove the two rotator mounting bolts. 4. Swing rotator assembly, with drop pipe, up and out of the way. Secure as needed. 5. Change tyre, aligning the Schrader valve in the identical spot. Schrader valves must be on opposite sides, to ensure correct wheel balance, and for hose fitment. 6. Tyre hoses can be installed prior to tyre install if needed. Do not over tighten tyre hose fitting onto the Schrader valve. 7. Always remove the valve core in the new tyres’s Schrader valve. CTI AIR PH: (03) 5127 6128 MOB: 0427 110203 120 Walhalla Rd. Push and hold quick connect but- Use 2 spanners on Tighten crimp TYRE CHANGING INSTRUCTIONS

Transcript of 12 Tyre Change

Page 1: 12 Tyre Change

Chock truck, ensure safety first. Use conventional safety systems. These instructions

relate to AIR CTI only.

WARNING; THE INSIDE OF THE TYRE AND RIM MUST BE CLEAN. WIPE INSIDE OF TYRE

TO ENSURE CLEANLINESS. ANY DIRT WILL DAMAGE ROTATORS AND NEGATE ANY

WARRANTY.

1. Turn off all wheel taps.

2. Quick Connect Fittings: Push button on quick connect tyre hose fittings, hold button

in fully, and remove. Otherwise the o ring may be damaged

Nut and Tail: Clamp hose to limit air loss with a tubing clamp. Undo nut using two

spanners (wrenches), one on nut, and one on nipple. Do not allow the nipple or tap to

rotate, as this will cause a leak.

3. Undo and remove the two rotator mounting bolts.

4. Swing rotator assembly, with drop pipe, up and out of the way. Secure as needed.

5. Change tyre, aligning the Schrader valve in the identical spot. Schrader valves must

be on opposite sides, to ensure correct wheel balance, and for hose fitment.

6. Tyre hoses can be installed prior to tyre install if needed. Do not over tighten tyre

hose fitting onto the Schrader valve.

7. Always remove the valve core in the new tyres’s Schrader valve.

C T I A I R

PH: (03) 5127 6128

MOB: 0427 110203

120 Walhalla Rd.

Push and hold

quick connect but-

Use 2 spanners on

Tighten crimp

TYRE CHANGING INSTRUCTIONS