Photovoltaics Technology Components and Systems Applications Clemson Summer School 4.6. – 6.6.2007 Dr. Karl Molter FH Trier molter [email protected].
16722 [email protected] Mo:20090302+Tu:04light sensing & sensors167+1 light sensing & sensors.
Homogeneous Semiconductors Dopants Use Density of States and Distribution Function to: Find the Number of Holes and Electrons.
Modeling of an interface between two solids Ashcroft and Mermin Ch. 18 Sze Ch.3 1987 Review Chapter by Tersoff.
Bohr quantized the atom… An atom has a set of energy levels Some (but not all) occupied by electrons Not really dealing with isolated atoms, but 3D solids.
[email protected] ENGR-45_Lec-09_ElectProp-Semi.ppt 1 Bruce Mayer, PE Engineering-45: Materials of Engineering Bruce Mayer, PE Licensed Electrical.
Univ Toronto, Nov 4, 2009 Topological Insulators J. G. Checkelsky, Y.S. Hor, D. Qu, Q. Zhang, R. J. Cava, N.P.O. Princeton University 1.Introduction 2.Angle.
Solid State Electrical Conductivity & Reactivity Edward A. Mottel Department of Chemistry Rose-Hulman Institute of Technology.
Principle of Photovoltaic Energy city – Sehir University, Istanbul – September 2013 Dr Mohamed Zayed.
Organic Photovoltaic: Challenges and Opportunities Dr. Kallol Mohanta PSG Institute of Advanced Studies Coimbatore, Tamilnadu.
Solar Power Hot Hot Heat. Did you know? Covering just 4% of the Earth’s desert area with photovoltaic cells could supply all the world’s energy needs.
3 12.2 Ohm's Law: V = I R in most cases V = V = V 2 – V 1 voltage drop (volts)resistance (Ohms) current (amps) Resistivity, and Conductivity, : --geometry-independent.