by PETER M. BOWERS / AOPA 54408
YESTEROAV'S WINGS
other aircraft firms that became part ofDetroit Aircraft were Lockheed, Ryan,and Great Lakes.
The Eastman E-2 had originally beenadvertised as the Eastman "FlyingYacht," but this name was quicklychanged to "Sea Rover" because of thesimilarity of the original name to thatof the earlier Loening "Air Yacht."
The E-2 was a unique departurefrom most of the traditional singleengine flying boats that had been builtsince 1912, in that its between-thewings engine was installed as a tractorinstead of as a pusher, A further departure from tradition was the lowerwing, which was shorter than, and hadless than half the chord of, the upperwing. This qualified the E-2 as a sesquiplane, a relatively rare configurationhalfway between a monoplane and aproper biplane.
The monoplane aspect was emphasized by the use of V-struts to carry theflight loads of the upper wing. COQventional biplane-type N-struts braced. thelower wing, making the E-2 a "wireless"design that eliminated the traditionalbiplane flying and landing wires.
The E-2 was somewhat of an anachronism because of its open-cockpitdesign at a time when competing mod-
:--= -
Anzani engine of dubious reliability,plus the weight and drag handicaps inherent in flying boats, the new modeldidn't perform well enough to make animpression on the market. Consequently, it was redesigned as a largerthree- to four-place model with a 185-hpCurtiss Challenger radial engine.
The redesigned model was put intoproduction in 1929 by the newly formedEastman Aircraft Corp., which soonbecame a division of a holding company known as the Detroit AircraftCorp. Detroit Aircraft was a multimanufacturer organization establishedto compete with two other aeronauticalgiants, the Curtiss-Wright Corp. and theGeneral Aviation Corp. Some of the
The EastmanSea Rover
Gorst's Sea Rover on the step in lake Union. The craft was used on the air·ferry run to Bremerton, 14miles across Puget Sound, and made the trip in 11 minutes. Photo by Gordon S. Williams.
RI. In 1928, the first full year of aviation's "Lindbergh boom," dozens ofnew designs appeared on the marketto replace the staid old three-seat biplanes that had been the mainstay ofthe industry from the early 1920s. Although monoplanes were coming onstrong in general aviation, having madetheir mark as transports, the biplanewas still the predominant design.
One of the new models that heldpromise was a little two-place flyingboat designed by James H. Eastmanand Tom Towle at the Beasley-EastmanLaboratory in Detroit, Mich. (The"Beasley" part of the name came fromthe financier P. R. Beasley, who backedthe firm.) But with only a 70-hp French
58 THE AOPA PilOT I MAY 1975
An Eastman £·2 Sea Rover flying boat of Gorst Air transport, photographed on lake Union in the heartof Seattle, Wash. Note the open cockpits and rudimentary lower wing. Photo by Gordon S. Williams.
EASTMAN E-2 SEA ROVER
Empty weightGrossweightHigh speedCruise speedInitial climbCeilingRangePrice
els were putting the passengers andcrew into comfortable cabins. In theE-2, however, the front-cockpit passengers and the rear-cockpit pilot and extrapassenger were seated both behind andbelow the rough-running and leakyChallenger engine, and received the fullbenefit of this unfortunate combination.
Plans were made to introduce a cabinversion of the E-2, but nothing evercame of them. There was an amphibianversion, however, which was designatedE-2A (for amphibian), and given thename "Sea Pirate" to distinguish itfrom the straight flying boat.
The wings and tail were of conventional construction, with wooden boxspars and built-up wood truss ribs forthe wings and welded-steel tube andchannel tail surfaces, all fabric covered.The hull was advanced for a small flying boat of the time, being all metaland divided into five watertight compartments. Crew and passengers, however, were out in the breeze as in theold days. The E-2 Sea Rover carriedfour people, while the E-2 Sea Piratecould carry only three because of theadded weight of the retractable landinggear,
The E-2 received Approved Type Certificate A-2BB on Jan. 22, 1930, and the
Specifications and Performance
Span (upper) 36 It 0 in(lower) 20 It 8 in
Length 26 It 3 inWing area 243 sq ItPowerplant Curtiss Challenger,
185 hp @ 2,000 rpm1,745 Ib2,725 Ibno mph90 mph740 fpm9,500 It360 mi$8,750 initially, raised to$9,985 and then reduced to$6,750 in March 1931
E-2A received ATC A-33B on July 17,1930. Both of these certificates wereissued after the start of the Great Depression, when the bottom had droppedout of traditional airplane sales. As aconsequence, only 15 E-2s and fourE-2As were sold before the Eastmanfirm shut down, following the demiseof Detroit Aircraft. 0
Top Related