wk MODULE 12 STRUCTURAL DESIGN AND DETAILING (60 Hours, 4 Credits)
22.07.1324.07.13
C1 Overview of structural design
Explain and locate Neutral axis Explain dead loads, imposed loads and
wind loads. Calculate design load for ultimate and
serviceability limit state. Explain serviceability limit state in terms
of deflection, cracking, durability, fire resistance
29.07.1331.07.1305.08.1307.08.13
C2 Demonstrate knowledge of the design methods of reinforced concrete rectangular beams.
Calculate the moment of resistance for a singly reinforced section.
Calculate minimum amount of longitudinal bars and stirrups.
Explain Bar Spacing rules. Design a continuous rectangular beam
for compression and tension steel. Illustrate standard detailing practice. Draw beam section and elevation. Carry out reinforcement detailing and
describe curtailment of bars.12.08.13
14.08.13
C3 Design solid slabs
Carry out preliminary sizing of slabs using span-effective depth ratio.
Design slabs for bending spanning in one direction and check for deflection.
Carry out reinforcement detailing and describe curtailment of bars.
19.08.1321.08.13
C4 Demonstrate knowledge of the Design Of Short And Slender Columns
Differentiate between short columns. Design short braced column(axially
loaded / supporting an approximate symmetrical arrangement of beams)
Design short columns resisting moments and axial forces using design chart.
Describe reinforcement details.26.08.1328.08.1302.09.13
C5 Demonstrate knowledge of the method of design of isolated footings subjected to axial load and moment.
Calculate the pressure distribution under a pad footing using the permissible bearing pressure with axial load and moment acting on the base
Calculate the reinforcement required to resist bending for an axially loaded base
04.09.13 Class test
09.09.1311.09.13
C6 Demonstrate understanding of the use of structural steel in buildings
Design beams for bending and shear. Design columns to carry a known axial
load and a nominal moment in simple construction.
Submission of assignment16.09.1318.09.1323.09.13
C7 Demonstrate understanding of the use of structural timber in buildings
Explain the factors that affect the design of structural timber- Influence factors: load duration, load
sharing, buckling, maximum depth to breadth ratios
Describe the method for designing structural timber for beams and columns, taking into account the factors mentioned above.
25.09.1330.09.13
Correction of class test
02.10.1307.10.1309.10.1315.10.13
Revision
Top Related