Pressure Measurement
www.alliancecalibration.com
Pneumatics & Hydraulics
Pneumatics is the study of the mechanical properties of gases. Gases can be compressed and stored to form potential energy.
Hydraulics is the study of fluid mechanics. Liquids can not be compressed so they are well suited to perform heavily loaded tasks at a distance when gases would just further compress.
www.alliancecalibration.com
Why Measure Pressure?
Process Controls Room Differential (Isolation) Movement in Explosive Environments Hydraulics (Presses & Stamping) Package Integrity (leak testing)
www.alliancecalibration.com
SI Units
The pascal (Pa) is the SI derived unit for pressure = 1 N/m2
That's about ¼ Lb spread out across a square meter
The most common unit used in the US is the PSI
That's 1 Lb on 1 square inch It takes 6,895 Pascals to make 1 PSI
www.alliancecalibration.com
Pressure Units
Pascal (Pa) Bar PSI InH
20
cmH20
ftH20
Torr
InHg
Atm (Atmosphere)
Kg/cm2
kPa
MPa
mmHg
www.alliancecalibration.com
Manometer
The simplest device used to measure pressure is the manometer. A “U” shaped tube filled with water. This is the origin of the unit “Inches of Water Column”
www.alliancecalibration.com
Pressure Gage
When pressure increases in a curved flattened tube the tube straightens
This is referred to as a “Bourdon Tube Gage”
www.alliancecalibration.com
Pressure Transducer
An electronic strain gage is attached to a diaphragm. When pressure is applied to the diaphragm the strain gage registers the force applied and then “Calibration Factors” are used to interpret the force as pressure
www.alliancecalibration.com
Accuracy
Typically electronic devices have a specification based on % reading however...
“Most” pressure measuring instruments have an accuracy based on % of full scale of the device.
This is important to keep in mind because a 10,000 PSI digital gage will read out to 1 PSI, but at 1%FS it has an accuracy of ±100 PSI
www.alliancecalibration.com
Calibration
Direct Comparison The UUT and Standard a both connected to a
single pressure source and the readings are compared
Primary Standards Deadweight Testers are also common and
apply pressure to a UUT based on the quantities of: length, mass and time.
www.alliancecalibration.com
www.alliancecalibration.com
Top Related