Download - Sealant - resources.kohler.comresources.kohler.com/interiors/kallista/pdf/1286349_2.pdf · 6 Using a 3/16" drill bit (provided), drill 1-1/2" (38 mm) deep holes at the marked locations.

Transcript
Page 1: Sealant - resources.kohler.comresources.kohler.com/interiors/kallista/pdf/1286349_2.pdf · 6 Using a 3/16" drill bit (provided), drill 1-1/2" (38 mm) deep holes at the marked locations.

SealantTape

7-7/8"(200 mm)Min

FinishedWall

FinishedFloor

2"(51 mm)Min

FloorJoist

Wood Support 6" (152 mm) Min Width

2-3/4"(70 mm) Min3-9/16"(90 mm)Max

33-5/16"(846 mm)

9-1/2"(241 mm)

2 Roughing-In

3-5/16"(84 mm)

23-13/16"(679 mm)

2-7/8"(73 mm) Min3-11/16" (94 mm)Max

6" (152 mm) MinFloor Joist

1 Roughing-InNOTICE: Adequate floor support isrequired. Standard 2x6 lumber isNOT sufficient for this application.NOTE: Concrete can be used as thefloor support.Observe all local plumbing andbuilding codes.

CAUTION: Risk of personalinjury.

Do not use this product as a grab orsupport bar when entering or exitingthe bath.The product is not designedto support weight.

Record your model number belowfor future reference:

7 Install the base to the supportwith the screws and washers.

Ø 3/16"

1-1/2"(38 mm)

6 Using a 3/16" drill bit (provided),drill 1-1/2" (38 mm) deep holesat the marked locations.

5 Use the base to mark themounting holes on the woodsupport.

Cold

Hot

4 Verify correct spout orientationbefore installing the base. Thebase has a notch on the coldsupply side.

3 Construct a wood support underthe floor according to theroughing-in dimensions.

12 Remove the plugs from the base.11Trim the guard flush with thefinished floor.

Ø 3-1/4"(83 mm)

10Finish the floor, leaving a 3-1/4"(83 mm) hole for the guard. Fitthe finished floor between theMIN and MAX lines on the guard.

9 Turn off the water and install theguard to the base.

Notch

Cold

8 Apply sealant tape to the supplypipes. Thread the pipes into thebase, with the cold supply on thenotched side. Turn on the waterand check for leaks.

14 Install the check valve to thediverter. Install the handshoweraccording to the manufacturer’sinstallation instructions.

13 Install the faucet to the base withthe screws and washers.

1286349-2-A

Page 2: Sealant - resources.kohler.comresources.kohler.com/interiors/kallista/pdf/1286349_2.pdf · 6 Using a 3/16" drill bit (provided), drill 1-1/2" (38 mm) deep holes at the marked locations.

Questions? Problems? For additional assistance, please contactKALLISTA's Customer Service Department at 1-888-4-KALLISTA(1-888-452-5547) or kallista.com.

1286349-2-A © 2016 KALLISTA