8/8/2019 puneet ppt22
1/17
SUMMER TRAINING REPORT- 2010
HINDUSTAN AERONAUTICS LIMITEDACCESSORIES DIVISION, LUCKNOW
INSTITUTE OF ENGINEERING AND TECHNOLOGYLUCKNOW
Submitted to:Mr. D.K SRIVASTAVA
SENIOR MANAGER, A.L.HHINDUSTAN AERONAUTICS LIMITEDACCESSORIES DIVISION, LUCKNOW
Submitted by:PUNEET TRIVEDI
B.TECH FINAL YEARELECTRONICS ENGINEERING
ROLL NO. 2805231003
8/8/2019 puneet ppt22
2/17
( )industan Aeronautics Limited HAL came intoexistence on .st October 1964
The Company was formed by the merger of HindustanAircraft Limited with Aeronautics India Limited and
, .Aircraft Manufacturing Depot Kanpur
,It was late Seth Walchand Hirachand who set up HindustanAircraft Limited at Bangalore in association with the.erstwhile princely State of Mysore in 23 December 1940
The Government of India became a shareholder in March 1941
.and took over the Management in 1942
8/8/2019 puneet ppt22
3/17
8/8/2019 puneet ppt22
4/17
HAL(HINDUSTAN AERONAUTICALS LIMITED)is a navratna public sectorunit and is presently ranked 34 among the global defence company.
HAL employees more than 30000 experinced personnel distributed.There are 19production division and 9 R&D centers developed across the country located at
Banglore ,Kanpur, Korwa, Nasik, Hyderabad,Lucknow.
Banglore is the corporate office of all the division.
HAL also plays a major role in missile projects of the country.
Major production range are SU-30MKI, JAGUAR, HAWK, DORNIER228, DHRUV(ADVANCED LIGHT HELICOPTER), CHEETAL and CHETAK helicopters.The limited series production of LCA, IJT, and LCH has commenced and will beintroduced in the service shortly.
INTRODUCTION
8/8/2019 puneet ppt22
5/17
:HAL has made substantial progress in its current projects
Dhruv , which is Advanced Light Helicopter( )ALHTejas - Light Combat Aircraft (LCA)
( )Intermediate Jet Trainer IJT Various military and civil upgrades.
HAL has played a significant role for India's space
programs by participating in the manufacture ofstructures for Satellite Launch Vehicles like
PSLV ( )Polar Satellite Launch Vehicle SLV ( -Geo synchronous Satellite Launch
)VehicleIRS ( )Indian Remote SatelliteINSAT ( )Indian National Satellite
8/8/2019 puneet ppt22
6/17
http://www.hal-india.com/hptmrodivision.asphttp://www.hal-india.com/transairdivision.asphttp://www.hal-india.com/overhauldivision.asphttp://www.hal-india.com/imgtdivision.asphttp://www.hal-india.com/helicopterdivision.asphttp://www.hal-india.com/enginedivisionbangalore.asphttp://www.hal-india.com/avionicsdivisionkorwa.asphttp://www.hal-india.com/avionicsdivisionhyderabad.asphttp://www.hal-india.com/aircraftdivisionbangalore.asphttp://www.hal-india.com/aerospacedivision.asphttp://www.hal-india.com/accessoriesdivision.asphttp://www.hal-india.com/aircraftdivisionnasik.asp8/8/2019 puneet ppt22
7/17
http://www.hal-india.com/EngineKoraput/products.asphttp://www.hal-india.com/Enginebangalore/products.asphttp://www.hal-india.com/Accessories/products.asphttp://www.hal-india.com/AvionicsKorwa/products.asphttp://www.hal-india.com/Aerospace/products.asphttp://www.hal-india.com/helicopter/products.asphttp://www.hal-india.com/AircraftBangalore/products.asphttp://www.hal-india.com/AvionicsHyd/products.asphttp://www.hal-india.com/AircraftNasik/products.asp8/8/2019 puneet ppt22
8/17
Acccessories Division Lucknow
Mechanical Factory Fuel Factory Instrumentation Factory SU - 30
8/8/2019 puneet ppt22
9/17
Gyroscopic instruments
Radio magnetic indicator(RMI)
Transformer rectifier unit(TRU)
Tachometer
Thermometric probe
INSTRUMENT FACTORY
Various projects running and manufactured ininstrument factory are:-
8/8/2019 puneet ppt22
10/17
Electronic Block PIN 4867-5
The electronic block provides an artificial feel of forces on joystick to the pilot duringpitching(Nose up/down) of the aircraft.
Units input - air speed and altitude from capsule unit
Units output - electrical signals 0-100 micro A. to drive actuator for increase feel offorce of decrease feel of force.
The active computer circuit is receiving speed and altitude data (E and ES) from capsuleunit.
These data are analyzed by computer circuit, which supplies a voltage whichvaries with pneumatic input data i.e. E = f(E- ES1) volt.
This voltage is compared with the voltage RF from follow up unit(feedback from actuator)the error voltage EF-RF resulting from the comparison is amplified and transmitted to thepower amplifier which supplies either data E1(high aircraft speed)or E2(low aircraft speed)of the actuator .
Thus electronic block is controlling the actuator position (increase feel of forces or
decrease feel of forces) according to the received pneumatic data.
8/8/2019 puneet ppt22
11/17
8/8/2019 puneet ppt22
12/17
Amplifier PIN 7298792
The amplifier is used to regulate HOT & COLD air of cabin by opening orclosing of the temperature control volve and bypass volve.
The HOT & COLD air comes from the cooling unit which consists of a
compressor,a heat exchanger
The principle is based on amplification and servomechanism.
Units input i) Cabin temperature sensor (2000 at 25c)
ii)Duct temperature sensor (2000 at 25c)
Units output operating voltage 115Vac 2.5% for temperature control volve
and bypass volve.
8/8/2019 puneet ppt22
13/17
Cabin sensors SpeedContr
olAmplifier
Thyristr
Lower LimitSensor Bridge
Low
Limita
mplifi
er
Tachometergeneator
Volves
Volves
Preset R
Slaving Bridge
Duct SensorBridge
Pre
amplifier
Mainampli fie
r
Negative feedback
ofSpeedLinearization
Servo Motor and Control
Ampliefier
BlockDiagram
8/8/2019 puneet ppt22
14/17
GENERAL BLOCK DIAGRAM OF SYSTEM
Fuel Quantity and FlowMetering System
STR7-51
FUEL Flow
MeteringPortion
Fuel Quantity
GaugePortion
Automatic
ControlPortion
8/8/2019 puneet ppt22
15/17
FCG PROBE(LCA)
8/8/2019 puneet ppt22
16/17
Function:LCA FCG probe are used fuel content gauging of internal fuel tanks.Some of the probes arewith built in independent level switches (high/low level) along with fuel content gauging.
Principal:
a)Fuel Content Gauging Probe : principle of capacitance gauging.
b) Fuel Level Switches : principle of Weins-Bridge oscillator.
Construction:
a) FCG Probe:It consists of two concentric alluminium alloy tubes insulated from each other to formcapacitance plates.b) Fuel level switches:The level sensing is achieved by using 2 concentric tubes of shorter lengths and of largerdiameter than those of main gauging probes.
FCG PROBE(LCA)
TEMPERATURE SENSOR
8/8/2019 puneet ppt22
17/17
TEMPERATURE SENSORPIN 1722.00.000
Function :Temperature sensor used in helicopter to sense the temperature of the medium in which
sensitive ports (bulb) of the unit is immersed
Principle of operation :Increase in resistance of metal with increase in temperature
Construction :
Consists of mixed resistance temperature detector, wound on an insulated former, theseare mounted in a tabular body closed at one end.
Working :Due to change in temperature resistance of temperature detector changes and appropriate
signal is sent to temperature detector
Specification :Insulation resistance > 20m ohmlength = 82.5-83.5mmweight = 25gms max.
used in ALH
Top Related