Presenting APower PointProgram
Computer ChecklistPower CordMouseComputer
Setting Up The ComputerOpen computer
Attach power cord
Push on/off button
Plug in mouse
1. Open Computer
2. Attach power cord
3. Push On/Off Button
4. Plug In Mouse
Projector ChecklistProjectorPower CordRemote ControlConnectorCableExtension Cord
Setting Up The ProjectorRemove Lens Cap
Plug in Power Cord
Turn on Power Switch
Setting Up The Projector4-5.Connect Projector to Computer with Cable with Blue Connectors
6.Plug Black USB Cable into any of 3 USB ports for Remote
1. Remove Lens Cap
2. Plug in Power Cord
3. Turn on Power Switch
Turn On Power SwitchFan Will Turn OnGreen Light Next to Menu Button Will Blink Until Bulb Warms UpOnce Bulb Has Warmed, Green Light Will Stop Blinking
Cable with Blue Connectorsand black USB cord
4. Insert Large Blue Connector(Labeled Projector) into Projector Port Labeled Computer In
5. Insert Small Blue Connector (Labeled Computer) into Computer Port Labeled Projector
6. Plug Black USB Cord (On Cable w/ Blue Connectors) into any of three USB Ports for Remote Control
Do Not Unplug Or Turn Off Projector WhenLight Next to MenuButton is Blinking
This Will DamageThe Bulb
Making HeightAdjustments:Press Height Adjustment Button and Foot Will Fall to Raise Height
Level Adjustments:Level Adjustment on Only One of Back Feet
Making Focus/ZoomAdjustmentsLarge Ring Adjusts ZoomSmall Ring Adjusts Focus
Getting the Presentationon the ScreenPress Fn , hold, then press F4 to get presentation on projector screen
Repeat if necessary until presentation shows on both computer and projector screens
Getting the Presentation on the ScreenClick on X to close Norton Antivirus screenDouble click on MG presentation iconPresentations are installed under MG Presentation icon
Using A CDPresentations can be run from CD, but for best results, presentations should be installed on computer
Disc Drive is on Right Hand Side of Computer
Push Button in Middle And Drive Pops Out
Insert CD, Touching OnlyEdges of CD With Fingers, and Snap Down Center of CD, Push Drive in to Close
Starting a Power Point ProgramUsing Mouse, double click on presentation you wish to giveTo begin slide show, go to menu bar and click on SLIDE SHOWThen click on VIEW THE SHOW
Using The Remote ControlUse Next or Previous to Move Through SlidesHit Power Button Twice to Turn Projector Lamp OffGreen Light Blinks as Fan Cools BulbDo Not Turn Lamp Off from On/ Off Switch until green light stops blinking
Ending a Power Point ProgramDouble click POWER button on remote. Green light blinks as fan cools bulb 2. Wait until green light stops blinking, then turn off projector at power switch.
Ending a Power Point Program3.To close computer presentation, click X in upper right handcorner of menu bar4. Click on START in lower left corner of screen, then click onTURN OFF to shut computer down
Ending a Power Point Program5. Remove Cables6. Replace lens cap7.Pack up equipment, using previous checklist to be sure thecorrect materials go into eachcase
Do Not Unplug Or Turn Off Projector WhenLight Next to MenuButton is Blinking
This Will DamageThe Bulb
Credits Photography and Script: Kathleen Habib, Master Gardener
Top Related