JVOP-181 USB Copy Unit (Y-Stick) Driver Installation Guide

IG.V1000.01 12/11/2007

Installing the JVOP-181 USB Copy Unit (Y-Stick) Driver To install the driver, please follow the steps below;

1. Copy the driver to a folder located on the PC such as My Documents. 2. Insert the USB connector from the JVOP-181 Copy Unit into an available

USB port on the PC. 3. The PC will recognize the new hardware and will display the Hardware Wizard

shown below.

4. Follow the Hardware Wizard and select Install from a list or specific location (Advanced)

then select Next.

JVOP-181 USB Copy Unit (Y-Stick) Driver Installation Guide

IG.V1000.01 12/11/2007

5. Select Search for the best driver in these locations. 6. Select Include this location in the search. 7. Select Browse and choose the location where the file was saved. 8. Select Next.

9. The installation is now complete. Select Finish to begin using the USB Copy Unit.