How to use Access Point with Cable Modem Motorola and WPS
1. Power lights
2. LAN connection light (if a LAN line is connected, the light will
be on)
3. WAN connection light will be on every time there is a line
connected at WAN slot.
4. Wireless status light
5. WPS status light
Motorola SB6120E Motorola SB5101N
1. After connecting LAN line between Access Point at the WAN slot
and Docsis
2. Proceed with Zyxel NBG-416N connection (Default: no Security)
3. Open a Browser and type 192.168.1. Enter “admin” for Username
and "1234” for Password
4. Check the IP Address from Docsis
5. Select Network > Wireless LAN > General > Security
Select WPA2/PSK at Security Mode
Place a check mark at WPA Compatible
Select TKIP+AES for Cipher Type
Enter the desired parameters for Security
Click Apply
6. Reconnect after the parameters for security is entered.
7. You can enter the set Passkey or press WPS at Access Point if
your Notebook supports WPS
8. You can connect and access the Internet
9. Passkey can be checked by right clicking and selecting View
Connection Properties
10. Place a check mark at Show characters
Note: WPA-PSK or WPA2-PSK must be selected for security mode
before setting the parameters for WPS
Top Related