Bunk Bed
Assembly Instructions
Thank you for buying our Canadian-made products.
Congratulations! Your Bunk Bed is now assembled.
The Bunk Bed Ladder can be used over the end or over the side of
the bunk bed. Screws and bolts should be tightened periodically to ensure a long-lasting product.
* Using the bunk beds as separate beds: If you have the split bunks option and want to use the beds separately, you may want to put the post brackets all at the
same height in either the upper or lower positions.
Tools: Rubber Mallet, 1/2” and 5/8” Wrenches (or drill and sockets), #2 Robertson Screwdriver (or drill and #2 Robertson bit) 1) Inventory Parts: 2 Bunk Bed End Assemblies, 4
½-log Bed Rails, 2 Top-bunk Safety Rails, 2 Bed Slat
Rolls, 1 bag of Fastening Hardware, Instructions.
4) Install Bottom Bed Rails and Safety Rails:
Insert both Bottom Bed Rails with bolt heads
hooked into the brackets. Snug by hand only.
Insert both safety rails in place in the top bunk.
Use a mallet to drive tenons of the safety rails into
the mortise holes all the way by hitting the posts
inward. (No glue or fastening hardware required).
3) Insert Bed Rails Bolts (16): Screw 1” bolts
(5/8” heads) into brackets on side rails by
hand.
6) Slat Rolls: Un-roll the two slat rolls with
the straps sides up. Secure them in three
places on each side of each slat roll as shown
below with 1½” wood screws, on the end
boards and on the middle board
(Twelve places in total).
2) Attach Bed Rail Brackets Upper and lower screw
positions are pre-marked on all bed posts. Fasten 8
brackets in total (4 top, 4 bottom). Hooks go toward
the outside of the bed pointing up. Screws are
towards the inside of the bed (see photo below).
Normally the brackets go in the lower location on
the bottom and upper locations on the top bunk to
allow better access to the lower bunk. (* see note
below for split bunks option)
5) Top Bed Rail: Remove the two bolts from
one end of each remaining bed rail. Hook the
other end of one of the rails into the post
bracket under one of the installed safety rails.
Align the other end of Bed Rail with its bracket
and screw the two removed bolts in by hand.
Repeat for the other side.
Tighten all 16 bolts using the 5/8” wrench.
Manufactured by:
Dundalk LeisureCraft Inc. (888) 923-9813 318448 8th Line NE www.dundalkleisurecraft.com Melancthon, ON [email protected] L9V 2K3
Top Related