1
Microstructural CharacterizationMicrostructural Characterizationof of
MaterialsMaterials
EunEun SooSoo ParkPark
Office: 33-316 Telephone: 880-7221Email: [email protected] hours: by an appointment
2009 spring
04. 13. 2009
2
Scanning TEMcroscopy TEM
3
S E M Operation
4
Scanning Technology
MonitorSample
Secondaryelectrons
ElectronBeam
5
• Electron gun produces beam of monochromatic electrons.
• First condenser lens forms beam and limits current ("coarse knob"). – Condenser aperture eliminates
high-angle electrons.
• Second condenser lens forms thinner, coherent beam ("fine knob" ).– Objective aperture further elimi-
nates high-angle electrons from beam.
SEM: Optics #1
6
• Beam "scanned" by deflection coils to form image.
• Final objective lens focuses beam onto specimen.
• Beam interacts with sample and outgoing electrons are detected.
• Detector counts electrons at given location and displays intensity.
• Process repeated until scan is finished (usu. 30 frames/ sec).
SEM: Optics #2
http://www.unl.edu/CMRAcfem/semoptic.htm
7
Electron Gun (전자빔)
8
Electron Emission-electron gun
• Cathode of the gun is the source of electrons for the beam in the electron microscope
• Thermionic emission – heat• Field emission – strong electrical field• Photoelectric emission – electromagnetic radiation
9
Work Function: WF
W.F 낮을 수록 전자방출이 쉽다
W.F 낮은 금속: 원자반경(atomic radius)이 크다
결정구조에서 원자간 간격이 크다
: 전자가 금속표면을 탈출할 때
넘어야 하는 potential energy(V)
10
11
12
13
14
15
Field emission of electronField emission of electron
Schematic view
W 원자의 가장 높은 궤도의 전자들은 실온에서 energy barrier를 넘기 힘들다.
그러나 금속이 강한 전기장(electric field) 이 놓이면 궤도전자들은 potential barrier energy를 통해 tunneling해서 금속 표면에서 방출된다.
16
Electron Source Physics
• Electrons need to have more energy than the work function (WF) toleave the emitter. Their energy depends on the temperature, so heatingcan be used to cause emission (Thermionic emitter like W or LaB6)
• The WF depends on the material, so choosing a material with a low WFhelps emission (LaB6 or ZrO layer on FEG emitter). It also depends onthe crystal orientation (FEG).
• The Schottky effect is that the WF becomes lower when a strong electricfield is applied on the emitting surface (used in the FEG).
• Field emission occurs at even higher electron fields. In this case the elec-trons tunnel through the now very thin barrier.
17
Thermionic Emission
LaB6 single crystal
Tungsten Hairpin
Self biasing from a resistor
18
1. Tungsten Hairpin Electron Gun
Inexpensive, low mag. high current (x-ray microanalysis), low vacuum(10-5torr), t=30-100h
V-shaped hairpin tip of d = 100μm대부분의 금속 : 열전자 방출 전에 용융, 융점이 높은 W 사용
19
High brightness(5-10times) : lower work function(2.5eV : 4.5eV for W), expensive but longer lifetime(1000hr), high vacuum(10-7torr)
직접 가열 방식
srA/cm 25max 10=β
2. LaB6 Electron Gun
간접 가열 방식
20
Thermionic Electron Emission Gun
가속전압(Accelerating Voltage): cathode와 Anode 사이의 potential 차이
- 보통 30,000V (30kV)
Cathode(Filament): 열전자 방출(W, LaB6)
: 열전자 집속, 1~3 mm 직경의 aperture (hole)
Anode: 열전자 가속
21
22
Self Biased Electron Gun
Richardson’ s law
)kT/Eexp(TAJ W2
C −=
work function
: 방출 전자 전류밀도 (A/cm2)
Filament current(if)
23
♦ Brightness : concept of current density
srA/cm 4current 2222 απ
βdi
anglesolidareab=
×=
Brightness ↑ ⇒ current ↑ in same beam size⇒ beam diameter ↓ in same current
Maximum theoretical Brightness (Langmuir eq’n)
srA/cm 2max kT
eVJ oc
πβ = for thermionic gun ~ 9.2 ×104A/cm2sr
srA/cm 2max E
eVJ oc
Δ=π
β for field emission gun
→ 0.3eV for cold emission~ 2 ×109A/cm2sr
EΔmaxβ
24
3. Field Emission Gun
<301> W single x-tal→ small work function
Disadvantages of thermionic gun : low brightness, evaporation of gun,thermal drift
Small tip radius 100nm
25
Flashing (burn out) 필요:
advantages: small spot size (1-2nm) high resolution
low ΔE improving of low volt. Operation.
tip 수명 단축
26
(larger ΔE)
: flat emitting area on <100> facet
advantages: No flashing, brightness is similar to cold FE
27
V1 : extraction volt.(방출전압)3-5kV
Vo : acceleration volt.(가속전압)
Work Function Barrier decreasing due to electric field (Schottky effect) and electron tunneling → Electron emission
During long-term operation, the tip blunts → more V1 is required.
Electron emission from FE Gun
srA/cm102 27max ×=β
Brightness
28
Control of electron emission
29
30
Electron sources
W
LaB6
FEG
31
Comparison of Electron Source
32
33
Condenser lense :
전자총에서 형성된 crossover를 줄이는 역할과 spot size의 조절
34
집속렌즈 세기변화 Cond. Lens
• 집속렌즈를 세게하면– 프로브 크기(↓)
– 분해능(↑)
– 프로브 전류(↓)
– 화질(↑)
Weak condenser lens Strong condenser lens
36
37
38
Object lense :probe crossover의 위치를 광축을 따라 변화시키면서 image를 focusing 하는 역할
39
40
41
42
Electrostatic Stigmator
Stigmator: 전자빔의 비점수차(astigmatism)를 보정하는 장치
-찌그러진 전자빔을 circular beam으로 만든다.
-정전기적(electrostatic), 자기적(magnetic) stigmator로 나누어짐
43
44
Specimen and Detectors
45
Electron Interactions: All Types
Cathodoluminescence
Secondary e–
Backscattered e–
Incident e–
Auger e–
X-rays
ElasticallyScattered e–
InelasticallyScattered e–
Unscattered e–
Electron/Specimen InteractionsWhen the electron beam strikes the sample, both photon and electron signals are emitted.
46
Auger e–
Through thicknessComposition information
Atomic number and topographical information
Electrical information Topographical information
Surface sensitivecompositional information
Specimen currentElectrical information
47
Top Related