ZoneDAS Data Sheet - RFI
Transcript of ZoneDAS Data Sheet - RFI
ZoneDASQuad-Band/Quad-Channel Active CAT5e DAS
Benefits
Lower Total Cost of Ownership (TCO)Zyxel’s ZoneDAS totally changes the economic equation of DAS deployment—while improving everything else. Eschewing costly yet cumbersome coaxialcabling, ZoneDAS is a unique product that enables the deployment of easy-to-use CAT-5 cables. These inexpensive twisted-pair cables can be installed bynetworking novices, saving the cost of hiring licensed electricians—a necessityin traditional DAS deployment. CAT-5 also allows ZoneDAS to power the entiresystem using just one power supply via PoE. These features significantly shortenZoneDAS deployment time and greatly simplify management. In addition,through bringing the amplifier straight to the antenna, ZoneDAS delivers thebest possible signal-to-noise ratio—with no signal strength degradation. Finally,its low 0~24 dBm base station input requirement helps system integrators loweroverall deployment CAPEX.
Taking advantage of simple maintenance and managementTraditional DAS products do not offer end-to-end monitoring and managementabilities. Signals just pass through RF cables quietly and building owners don’tknow about issues until users complain. Zyxel's active ZoneDAS solves theproblem with its support for end-to-end system monitoring and management,enabling IT staff to manage everything from the RF source to the antenna pointvia EMS and SNMPv3.
Supports multiple vendors/multiple systems/multiplebands/multiple carriers
4 x SISO or 2 x MIMO or2 x SISO + 1 x MIMO or1 x 2CA
High SNR, low noise figure
Pattern-configurable omniand directional antennas
Supports proactive alarms,EMS, and tracking logs
Datasheet ZoneDAS
Operator A Operator B Operator C Operator D
Ensure high flexibility and performanceWith ZoneDAS, output power level for each RF module oneach RU (Remote Unit) can be individually adjusted.Upgrading to MIMO service or additional carrier support isalso easily achieved through RF module additions. ZoneDASremote units feature built-in pattern-configurable antennaein each module, through which users can choosedirectional or omni output and optimize coverage.ZoneDAS also features input auto-levelling algorithms thatadaptively optimize system gain to ensure optimal overallperformance. For GSM900 systems, ZoneDAS's Uplink-Time-Slot-Mutely mechanism serves to avoid adjacent channelrejection and far-close effects for phones close to remoteunits.
Source-independent BTSBusiness models for in-building wireless services typically relyon carrier, neutral-host, or enterprise-pays-for-DAS scenarios.Since Base Transceiver Stations (BTS) are the only wiredsignal sources and must be carrier-provided, compatibilitywith various BTS systems becomes key when adopting DASsystems. Zyxel's ZoneDAS is BTS source independent andaccepts the low 0 to 24 dBm input power range providedby macro, micro, and picocell stations. It carries RF signals
from up to four individual BTS cells while offeringversatile input combinations such as 2 x MIMO, 4 xSISO, or 1 x MIMO + 2 X SISO from 2G, 3G and 4G LTEsystems. In addition, it can pipe RF signals from Zyxel'sSymmRepeater to communicate entirely over-the-air.By simplifying technical maintenance, ZoneDAS helpsoperators refocus on device capacity expansion andsystem upgrades, both essential to achieving higherROI and making investments count.
Multi-Vendor
Multi-System
Multi-Band
Multi-Carrier
GSM UMTS LTE FDD TD LTE
TDD / FDD systems Band 1/2/3/4/5/7/8/12/13/14/17/20/28/38/39/40/41
Datasheet ZoneDAS
BTS Brand A BTS Brand B BTS Brand C BTS Brand D
All modules—RF, SD, and fan—are easily hot swappable.
Specifications
Base Unit Remote Unit
BU (Base Unit) Chassis• 1U, 19” rack mount• 2 x SD module slots• 4 x RF module slots, allowing configurations such as:
■ 4 x SISO■ 2 x MIMO■ 1 x MIMO + 2 x SISO■ 1 x 2CA
• Management interface: one 10/100 RJ-45 port• AC power input, 100~240V AC• Max. power consumption: 450W (full configuration and
max. output power)
BU-RF (Radio Frequency) Module• Band Selectable
■ B1/2/3/4/5/7/8/12/13/14/17■ B20/28/38/39/40/41
• Input power range: 0 ~ 24 dBm• ALC protection range: 24 dBm ~ 33 dBm• Max. output power: -25 dBm• Continuous 20 MHz channel• SMA connector• Input Auto-leveling Algorithm
SD (Signal Distribution) Module• 4 x RJ-45 ports (connect up to 4 x RUs)• Each connects up to 100m of CAT5e STP cabling• PoE feeds power to RUs• Each port can carry 4 separate 20 MHz (FDD or TDD) RF
channels
RU (Remote Unit) Box• 4 x RF module slots• RJ-45 interface (PoE)• Power consumption: 6.5W• Antenna isolation between RF modules: 20 dB• Replaceable silent-fan module (Life Expectance (L10):
80,000 hrs)• Mounting kit for wall and ceiling
SD (Signal Distribution) Port• Single RJ-45 port connects to BU via CAT5e STP• Supports cable lengths of up to 100m• Max. 6 dBm output power• Powers the RU via PoE
RU-RF (Radio Frequency) Module• Band Selectable
■ B1/2/3/4/5/7/8/12/13/14/17■ B20/28/38/39/40/41
• Output power range: 14 ~ 23 dBm excluding antenna gain
• Built-in dual antennas, with software mode switching:Omni antenna for ceiling mount, with 3 dBi gainDirectional antenna for wall mount, with 7 dBi gain
• Max. power consumption: 9W• Uplink-Time-Slot-Mutely mechanism
Datasheet ZoneDAS
Management
Application
Zyxel Communications CorporationTel: +886-3-578-3942 Fax: +886-3-578-2439 Email: [email protected]
For more product information, visit us on the web at www.zyxel.comCopyright © 2018 Zyxel Communications Corp. All rights reserved. Zyxel, Zyxel logo are registeredtrademarks of Zyxel Communications Corp. All other brands, product names, or trademarks mentionedare the property of their respective owners. All specifications are subject to change without notice.
Datasheet ZoneDAS
ManagementFeatures● Web GUI through
http / https● MIB & SNMPv3
agent for EMS● CISCO-like CLI● System log agent