YARIS_manual.pdf

YarisBrief Guide

YAR11-0910ENUK-11-00 m YAR11-0910ENUK-11-00 m

1


Table of ContentsAccessing your vehicle 2 – 3

Electric windows and windows lock 4

Steering wheel adjustment 4

Seat and seat belt adjustment 5

Instrument Panel overview 6

Instrument Cluster 7

Multi-information display 8

Stop & Start system (if equipped) 9

Lights 10

Wipers 10

Starting your vehicle 11

Gear change 12

Heating, A/C and de-misting 13

Fuel tank opening 14

Bonnet opening 14

Eco-Driving 15

Introducing YarisThank you for buying a Yaris. We trust this Brief Guide will enable you to become familiar withyour vehicle’s basic operations and assist you in enjoying your vehicle.

This Brief Guide does not replace or substitute the Owner’s Manual, which you will find in thevehicle’s glove compartment. It is important that you review the full Owner’s Manual as well asany further supplementary manuals as this will allow you to familiarise yourself with theoperating and safety instructions and to handle the vehicle within its limitations.

Please do read all documents in your pack as this will ensure you get maximum performancefrom your car and learn about related services offered.

Your Centre and everyone at Toyota wish you many years of enjoyable driving in your new Yaris.

NB: All information contained in this Brief Guide are current at the time of printing. Toyotareserves the right to make changes at any time without notice.

2


Accessing your vehicle

Vehicles without smart entry & startsystem1. Locks the doors.2. Unlocks the doors.3. Indicator light.If you should lose your keys or if you need additionalkeys, duplicates can be made using the key number.

Vehicles with smart entry & start system(on some models)1. Locks the doors.2. Unlocks the doors.3. Indicator light.

Move the lock lever to the "LOCK" position as shownon the label, then the door cannot be opened with theinside door handle. This is to prevent children fromopening the rear doors.

Child rear door protection lock (5-door only)

The Mechanical Key is stored within theElectronic Key.

Type A

Type B

Type C

3


Unlocking and locking the doors for vehicles with Smart entry (on some models)

1. Unlocks all doors.2. Locks all doors.

1. Unlocks all doors.2. Locks all doors.

Door lock switchType A Type B

1

2

12

When you carry the key, you can lock and unlock allside and back doors without using the key.

Push the lock button on the outside door handle. Alldoors lock simultaneously and turn signal lights flashonce.

4


Steering wheel adjustment

To change the steering wheel angle, hold the steeringwheel, push down the lock release lever, tilt thesteering wheel to the desired angle and pull up thelock release lever.

To adjust the steering wheel position, push down thelock release lever. Then tilt the steering wheel to thedesired angle, push or pull it to the desired steeringcolumn length and pull up the lock release lever.

Tilt steering wheel Tilt and telescopic steering wheel

Electric windows and windows lock (on some models) The windows can be operated with the switch on each side door. The ignition key/Start button must be in the“ON” position.

Operating the driver’s window:Use the switch on the driver’s door.Normal operation: The window moves as long as youhold the switch. To open: Lightly press down the switch. To close: Lightly pull up the switch.Automatic operation: Press the switch completelydown or pull it completely up, and then release it. Thewindow will fully open or close. To stop the windowpartway, lightly push or pull the switch up and thenrelease it.

Window lockswitch Operating the passengers’ windows:

Use the switch on each passenger’s door or theswitches on the driver’s door that control eachpassenger’s window. The window moves as long asyou hold the switch.To open: Push down the switch.To close: Pull up the switch.

The steering wheel must not be adjusted while the vehicle is in motion.

5


1. Seat position adjusting lever.2. Seat height adjusting lever (on some models).3. Seat back angle adjusting lever.4. Seat back lock release lever (3 doors models).

To fasten your belt, pull it out of the retractor andinsert the tab into the buckle.You will hear a click when the tab locks into thebuckle.The seat belt length automatically adjusts to your sizeand the seat position.

1. Lower the head seat restraint to the lowestposition.

11234

2. Pull the seat position adjusting lever up. Thenslide the rear seat fully forward.

3. Pull the seat back angle adjusting lever up and foldthe seat back down.

4. Flip over the deck board (on some models).

Seat and seat belt adjustment

Make sure that all occupants are wearing theirseat belts before driving the vehicle.

Adjusting front seats Fold-down rear seat

Seat belts

6


Instrument Panel Overview

1. "AIRBAG OFF" indicator light2. Front passenger's seat belt reminder light3. Audio system4. Hazard lights switch5. Headlight, turn signal, and rear/front fog light

switch6. Wiper and washer switches7. Start Button (with smart entry and start system)

8. Ignition switch (with key cylinder-type ignitionswitch)

9. Tilt and telescopic steering lock release lever10. Air conditioning controls11. Cigarette light/Power outlet12. Rear window demister switch

7


Instrument Cluster

1. Service reminder indicators and indicator lights.2. Speedometer.3. Display knob/Clock reset knob.4. Clock.5. Outside temperature/Cruise information.

6. Fuel Gauge.7. Gear position indicators.8. Tachometer.9. Odometer and two trip meters.10. Trip meter reset knob.

Indicator symbols on the instrument panel

* on some models

Brake system warninglight

Anti-lock brake systemwarning light

Discharge warning light

Low engine oil pressurewarning light

Malfunction indicatorlamp

Power steering systemwarning light

Low fuel level indicatorlight

Low engine coolanttemperature indicatorlight

High engine coolanttemperature warninglight

Fuel filter warning light(Diesel models only)

Engine preheatingindicator light (Dieselmodels only)

SRS warning light Open door warninglight

Turn signal indicatorlights

Tail light indicatorlight*

Headlight high beamindicator light

Front fog lightindicator light*

Rear fog light indicatorlight

Multi-mode manualtransmission warninglight*

Vehicle stability controlsystem*

Slip indicator light* Front passenger’s seatbelt reminder light

Smart entry and startsystem warning light*

Driving pattern (“Es”mode) indicator light*

Driver seat beltreminder light

Front passenger airbag“OFF”

Engine oil changereminder light*

8


Multi-information display

1. Clock.2. DISP knob.3. Outside temperature/Cruiser information.

When the ignition switch is set in the "ON" position,the previous mode display will appear.

Digital meter

Analogue meter Digital clock

The engine must be “ON”.Pushing the reset knob flashes the indicator for the hour, and you can adjust the hour.Press the reset knob until the desired hour will appear.After approximately 5 seconds pass without operating, the indicator for the minutes flashes. Then you can adjustthe minute.Press the reset knob until the desired minute will appear.After approximately 5 seconds pass without operating, the indicator will return to the normal display.

9


For details of restrictions and operating conditions, please read carefully Section 1-6 in your Owner’s Manual.

Stop & Start system (if equipped)This vehicle is fitted with a “Stop & Start” function that allows the automatic stopping and starting of the engine.This function helps you to decrease the fuel consumption.

Stopping the engineFirst put the shift lever in the neutral position whenstationary, and release the clutch pedal. The enginewill then stop. Next with the engine stopped, if theclutch pedal is pressed, the engine will start again.The “ECO” indicator will light up in the instrumentcluster when the engine has stopped.A buzzer will sound as a warning when the followingoperations are done:1. The shift is put into a gear position without the

clutch pedal being pressed when the engine isstopped.

2. The driver’s door is opened when the engine hasstopped temporarily.

Restarting the engineCheck that the shift lever is in “N” and depress theclutch pedal, the engine will re-start and the “ECOOFF” indicator will come on but when the vehiclestarts moving, it will go off.If you should want to disable the system, press “ECOOFF” switch.

To disable the system, press the "ECO OFF" switch. Atthis time, the indicator of the switch will come on.

To disable the Stop and Start system

10


Lights

HeadlightsTo turn on the lights: Twist the headlight/t urnindicator lever knob.Position 1: Side, tail, license plate and instrumentpanel lights on.Position 2: Headlights and all of the above on.

High-low beamsFor high beams, turn the headlights on and push thelever away from you (position 1). Pull the lever toward you (position 2) for low beams.To flash the high beam headlights, pull the lever allthe way back (position 3). The high beam headlightsturn off when you release the lever.

Windscreen wipers and washerTo turn on the windscreen wipers, move the lever tothe desired setting. The key/Start button must be inthe « ON » position.Position 1: intermittent.Position 2: slow.Position 3: fast.For a single sweep of the windscreen, push the leverup and release it.To spray washer fluid, pull the lever toward you.

Rear window wiper and washerTo turn on the rear window wiper, twist the lever knobupward.The key/Start button must be in the « ON » position Position 1: intermittent.Position 2: normal.To spray washer fluid on the rear window twist theknob upward or downward as far as it will go (position3). The knob automatically returns from thesepositions after you release it.

Wipers

Starting your vehicle

Light: Red: No startGreen: Engine start

Key positions are as follows:1. Lock: The steering wheel is locked and the key can

be removed.2. ACC: Some electrical equipment such as audio can

be used.3. On: All electrical equipment can be used.4. Start: Starts the engine.

NB For diesel vehicles:The engine should not be started until the indicator light goes out.

11


For vehicles with smart entry : (on some models)1. The driver should carry the key on his person.2. The Engine Start Stop button is used to start the

vehicle.

Starting procedure:Manual transmission:Ensure parking brake is applied.Put gear lever to the neutral position.Press and hold the clutch pedal firmly.Start the engine.

Multi-mode manual transmission:Ensure parking brake is applied.Gear lever set in P.Press and hold the brake pedal firmly.Start the engine.


Gear change

Shift position usesShift position Function

R ReversingN Neutral and engine startingE Easy mode (automatic

operation)M Manual mode

“+” = Upshifting“–” = Downshifting

5-speed manual transmission

Multi-mode manual transmission

6-speed manual transmission

12

The shift pattern is as shown.

The shift pattern is as shown.


Heating, A/C and de-misting

Manual controls

Automatic controls (on some models)

13

1. Air intake selector.2. Air flow selector.3. Temperature selector.4. Fan speed selector.5. “A/C” button (on some models).

1. Temperature selector.2. “OFF” button.3. Air intake button (recirculate).4. Fan speed selector knob.5. “MODE” button (air flow selector).6. “A/C” button.7. Automatic operation button.8. Air intake button (fresh).9. Windshield air flow button.

14


Bonnet openingTo open the bonnet:1. Pull the bonnet lock re lease lever.

The bonnet will spring up slightly.

2. In front of the vehicle, pull up on the auxiliarycatch lever and lift the bonnet.

3. Hold the bonnet open by inserting the support rodinto the slot.

Fuel tank opening

1. To open the fuel filler door, pull the lever up. 2. To remove the fuel tank cap, turn the cap slowlycounter clockwise, then pause slightly beforeremoving it. Hang the tether as shown in theillustration.

Take care to select the correct fuel

15


Eco-Driving

What is ‘‘Eco-Driving’’?’• Eco-Driving = Driving in a more careful and environmentally responsible way• Eco-Driving = Reduced fuel costs ❯ Potential saving in the EU of 20 billion euros by 2010• Eco-Driving = Reduced Environmental impact ❯ Potential saving in the EU of 50 million tons of

CO2 emissions by 2010

Total potential saving of 20 - 30%.

Eco-Driving Savings

Roof load increases wind drag and therefore consumption.

Open windows increase fuel consumption by an average of 5%.

Shifting up gear earlier can result

in 8% saving.

Starting• Remove any extra weight and roof load• Plan your route to avoid detours• Avoid using your car for short journeys

Checking/maintenance• Check your tyre pressures regularly• Service your car according to owner’s manual

Driving• Shift up gear earlier• Only use electrical accessories when necessary (e.g. A/C)• Follow and anticipate the traffic flow• Keep your windows closed (use ventilation system when possible)• Switch off your engine if you have to wait longer than 30 - 60 seconds

How to Eco-Drive?

Roof Load(Speed at 120 km/hr)

Increasedconsumption

Luggage rack 5 – 10%Ski box 10 – 20%Bicycle rack 30%Loaded luggage rack 35 – 40%

Air Conditioningcan result in 10 - 25%

extra fuel consumption.

Low Tyre Pressure result in higher fuel consumption (up to 3% extra from 0.5 bar too low)Tyre pressures can fall by 2.5 - 5.0% after one month, and by 20% after 5 months.

16


YAR1

1-09

10EN

UK-

11-0

0


YAR1

1-09

10EN

UK-

11-0

0

YARIS_manual.pdf

Documents

Transcript of YARIS_manual.pdf