Work Instruction for Dimension Inspection for casting

download Work Instruction for Dimension Inspection for casting

of 3

Transcript of Work Instruction for Dimension Inspection for casting

  • 8/18/2019 Work Instruction for Dimension Inspection for casting

    1/3

    WORK INSTRUCTION FOR DIMENSIONINSPECTION

     

    Doc. No. WI-QC-21

    Date/Rev No. 20.06.2015/00

    Pae No. Page 1 of !

    1. Purpose and Scope:- To inspect the casting geometrically and dimensionally as per approved

    drawing.All casting can check by dimension inspection.

    2. Responsibilities:-Q.C. Inspector is responsible for to do the inspection and records the data.Q.C. In-Charge is nal responsible for inspection.

    3. Safety:-Wear helmet !afety shoes and "and #loves.

    4. Procedure:-

    Inputa$ %rawing m&st have 'Control Copy( stamp. If fo&nd witho&t stamp

    drawing then receive the stamped drawing from Q.A. %epartment.b$ Compare drawing no. ) revision no. in drawing with *+,. If not

    match then inform to Q.A. %epartment and receive the latestdrawing.

    c$ Check vis&ally all shape of casting as per drawing. *.g. osslocation l&g location ,ad location !hape of each view ,artwaviness over grinding on riser or any methoding area etter of casting ) e/tra metal on any location.

    d$ !hifting check vis&ally.e$ Check instr&ment calibration if instr&ment fo&nd d&e in calibration

    than inform to Q.C. department for calibration.f$ Insect the casting dimensionally as per drawing and &se

    instr&ments as per control plan.g$ ength %imension m&st check Top and ottom on both sides for

    checking shifting.h$ Casting tolerance &nderstand as per below listed method.

    asic %imension is 01.21 mm 3pper imit is 01.21 41.151601.25mm and ower limit is 01.21 7 1.181 6 01.9:mm.!o %imension accept between 01.9:mm to 01.25mm.

    i$ If don;t mansion tolerance in dimension then see the drawing titlebo/ which have a mansion standard for tolerance or tolerance chart

    and &se this standard tolerance in partic&lar dimension. 

  • 8/18/2019 Work Instruction for Dimension Inspection for casting

    2/3

    WORK INSTRUCTION FOR DIMENSIONINSPECTION

     

    Doc. No. WI-QC-21

    Date/Rev No. 20.06.2015/00

    Pae No. Page 2 of !

    k$ #eometry tolerance chart.

    l$ I% and =% to be check on parting line and top- bottom point forchecking ovality.

    Output:-a$ >ill the dimensions in report.b$ Check the variation of dimensions w.r.t. drawing if dimension fo&nd

    o&t-of tolerance then inform to Q.C. In-Charge.

    5. Records & ross Reference:-

    Prepared !y : "ppro#ed !y : Issued !y : $.R.

    Sy%bol escription Sy%bol escription

     Tolerance feat&reindication

    $ ?a

  • 8/18/2019 Work Instruction for Dimension Inspection for casting

    3/3

    WORK INSTRUCTION FOR DIMENSIONINSPECTION

     

    Doc. No. WI-QC-21

    Date/Rev No. 20.06.2015/00

    Pae No. Page ! of !

    Si+n : Si+n : Si+n :

    ate :1,..215 ate : ate :

    • Casting %imension Inspection +eport QC->=-15

    • %imension Inspection Control ,lan QC->=-18