USER GUIDE

THE SUPER-SILENT, ULTRA-POWERFUL SOLUTIONFOR PREMIUM HOME CLEANING

2

Plastic film can be dangerous. To avoid the danger of suffocation, keep away from babies and children.

! WARNING:Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.

! CAUTION:

Thank you for purchasing a BENNETT READ WHISPER vacuum.

Your WHISPER vacuum incorporates the latest technological advances in home cleaning systems. It imitates the most powerful forces of nature in a sleek, elegant cleaning system to ensure that your home is easily and properly cleaned.

Your new vacuum is manufactured to a high standard of quality and is backed up by a 24 month guarantee by Tevo.

Should you need any support from us, please visitwww.tevo.co.za or call 0861 77 88 88.

PLEASE KEEP THIS USER GUIDE IN A SAFE PLACE AND

READ IT CAREFULLY BEFORE USING YOUR BENNETT READ

WHISPER VACUUM FOR THE FIRST TIME.

3

» Use the system only for its intended use.» To protect against a risk of electric shock, do not immerse any part of the system in water or other liquids.» Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.» Do not allow cord to touch hot surfaces.» Do not run appliance over cord.» Do not operate the system with a damaged cord or plug, or if the appliance or any other part of the system has been dropped or damaged. To avoid the risk of electric shock, do not disassemble or attempt to repair the WHISPER. Return the unit for examination and repair. Incorrect re-assembly or repair can cause a risk of electrical shock or injury to persons when the WHISPER is used.» Do not leave the unit unattended while connected. Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts.» Do not use to pick up flammable or combustible liquids such as gasoline and do not use in areas where these may be present.» Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.» Do not vacuum up any liquids with the WHISPER.» Use extra care when cleaning on stairs.» Do not use the vacuum without the dust bag or filters in place.» This appliance is intended only for household use. Follow all user instructions in this manual.» Do not leave the WHISPER plugged in when un-attended. Unplug the electrical cord when not in use and before servicing.» Do not allow to be used by children or to be used as a toy.

» Close attention is necessary when used near children, pets or plants.» Use only as described in this manual. Use only Bennett Read recommended accessories.» Do not pull cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. » Turn off all controls as applicable before unplugging from electrical outlet.» Do not handle plug or vacuum with wet hands or operate without shoes.» Do not put any objects into openings. » Do not use with any opening blocked. » Keep free of dust, lint, hair and anything else that may reduce air flow.» Store your appliance indoors in a cool, dry area.» Keep your work area well lit.» Keep end of hose, wands and other openings away from your face and body.» Use only on dry surfaces.» Using improper voltage may result in damage to the motor and possible injury to the user. Correct voltage is listed on rating label.» Use only identical replacement parts.

WARNING:» To reduce the risk of injury from moving parts – Unplug before servicing.» To reduce the risk of injury of electric shock: – Unplug before cleaning or servicing. – Do not use outdoors or on wet surfaces.

IMPORTANT SAFETY INSTRUCTIONSREAD ALL INSTRUCTIONS BEFORE USING YOUR VACUUM.When using your WHISPER, basic safety precautions should be observed, including the following:

!TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:

WARNING

SAVE THESE INSTRUCTIONS FOR FUTURE USE.

FOR HOUSEHOLD USE ONLY

THE BENNETT READ WHISPER IS INTENDED FOR DRY VACUUMING ONLY. VACUUMING UP ANY LIQUIDS WILL CAUSE PERMANENT DAMAGE TO YOUR MACHINE AND WILL VOID THE GUARANTEE

! WARNING:

10

7

1

2

34

5

6

8

9

18

20

4

PRODUCT VIEW1. Floor nozzle2. Extension tube3. Airflow regulator4. Handle5. Flex-hose6. Hose connector7. Power button/Variable power control8. Automatic cord rewind button9. Dirt container lid10. Dirt container release catch

11. Dust bag12. Pre-motor filter13. Post-motor HEPA filter14. Power cord15. Dusting brush16. Upholstery tool17. Crevice nozzle18. Suction inlet19. Turbo Brush20. LED dust indicator

14

11 15 16 17 19

13

12

5

ASSEMBLY1. Your WHISPER comes fully assembled but we recommend you check the following before vacuuming:

• Pre-motor filter [12] properly installed:Open the dirt container lid (9) by lifting the release catch (10) as shown on pg 8. Slide the pre-motor filter into the slot from the top and clip it into place:

• Post-motor HEPA filter [13]:Slide the HEPA filter in and press down gently to clip it into place:

• Dust Bag [11] properly installed:Insert the front plastic housing of the Dust Bag into the machine (arrows pointing down) by inserting the bottom of the housing into the slot inside the tank cavity until it clips into place:

SETTING UP YOUR WHISPER:1. Connect the flex-hose (5) to the vacuum by inserting the hose connector (6) on the end of the flex-hose into the suction inlet (18). To remove the flex-hose, press the two tabs on either side of the connector and pull the flex-hose outwards.

3. To extend the extension wand, hold the grip and push it away from you. To retract, hold the grip and pull it towards you:

2. Connect hose handle (4) to the end of the extension wand (2) and twist slightly to tighten:

4. Connect floor nozzle (1) to the end of the extension wand (2) and twist slightly to tighten:

5. Once assembled, you can store your vacuum by inserting the storage clip (located on the back of the floor nozzle) into the storage slot on the rear of the vacuum:

6

AUTOMATIC CORD REWINDYour vacuum is equipped with an automatic cord rewind. When cleaning is finished, switch the electricity off at the wall socket and disconnect the plug from the electrical outlet. Hold the plug and press the automatic cord rewind button to rewind the power cord:

POWER BUTTONTurn the power ON or OFF by pressing lightly downward on the power button:

VARIABLE SUCTION CONTROLThe power button also controls the suction power of your Bennett Read WHISPER:A. Settings 1 and 2 are suitable for delicate areas and fabrics such as curtains, blinds, upholstery & area rugs:

OPERATIONSPOWER CORDThe power cord is located at the rear of the vacuum. Gently pull out the power cord:

Stop pulling the power cord once the yellow line is visible. There is also a red line, which indicates the end of the useable cord. Do not pull the power cord out beyond the red line. Failure to adhere to this will render your guarantee void.

Setting 1:

Setting 2:

SPECIAL TOOLSYour Bennett Read WHISPER is not only a powerful carpet and rug vacuum cleaner, it is also a versatile bare floor and above floor vacuum cleaner when you select one of the special tools:

FLOOR NOZZLE (1)Use to vacuum carpets, rugs and bare floors. Swivel head turns to get into tight spaces and fits under furniture and cabinets.

DUSTING BRUSH (15)Use the dusting brush to clean cornices, skirtings and tight spaces.

UPHOLSTERY TOOL (16)Use the upholstery tool to clean curtains, draperies, cushions and fabrics.

CREVICE TOOL (17)Use the crevice tool in tight, narrow spaces.

PET TURBOBRUSH (19)Ideal for removing pet hair from furniture.

B. Setting 3 is for fitted carpets:

7

EMPTYING THE DUST BAG

• First, unplug the vacuum from the electrical outlet. Remove the hose by pressing the securing clips inwards and pulling the hose connector out from the suction inlet. Set the hose aside

MAINTENANCEAND CARE

AIR FLOW REGULATOROpen the airflow regulator (3) by sliding the regulator up towards the handle to create an open position. This will reduce the suction power for vacuuming delicate fabrics. For full suction power, close the airflow regulator by sliding the regulator to the closed position.C. Setting 4 and 5 are for hard floors:

Setting 3:

Setting 4:

Setting 5:

Use only Bennett Read WHISPER replacement filters in your vacuum. Replacement parts can be purchased from selected retail stores or directly from Tevo. See page 11 for details

! CAUTION:

OPEN

CLOSED

8

• Open the Dirt Container lid:

Note: The Dirt Container lid will not close if the Dust Bag is not fitted in place

• Remove the Dust Bag as shown:

• While holding the dust bag over an outside dust bin, slide open the bottom and shake the bag to rid of all the dust and dirt inside

REPLACING/CLEANING

THE PRE-MOTOR FILTER

The pre-motor filter assists in the filtration process that returns cleaner air back into your home.

To avoid injury, turn vacuum OFF and unplug cord from the wall when performing maintenance.

! WARNING:

This bag can be rinsed under running water and must be allowed to dry completely before returning to the machine. It is recommended to slide open the bag at the bottom before washing

• Unplug the vacuum from the electrical outlet

• Open the dirt container lid

• Remove the dust bag

• Press down on the button on top of the pre-motor filter and pull upwards to remove

• The pre-motor filter can be hand-washed in cold water. Rinse well and air-dry thoroughly before returning to the vacuum

• Clip the pre-motor filter securely back into place before use

Empty the dust bag (11) regularly to ensure maximum suction power at all times. The machine is equipped with an LED “Dust Indicator” [20] above the power button. Once this indicator turns red, the bag needs to be emptied immediately as per the instructions

! CAUTION:• Ensure that the slider at the bottom

of the bag is completely closed before returning to the machine

9

REPLACING/CLEANING THE

POST-MOTOR HEPA FILTER

The post-motor HEPA filter assists in the filtration process that returns cleaner air back into your home.

• Unplug the vacuum from the electrical outlet

• Open the Dirt Container lid

• Remove the Dust Bag

• Remove the HEPA filter by lifting the tab (indicated with an arrow on the filter cover) and pulling the filter outward

• Replace the post-motor HEPA filter by sliding it back into the slot and pressing down firmly on the arrow until it clips into place

The post-motor HEPA filter is NOT washable with water. Only use a brush or compressed air to cleanthe HEPA filter.

! CAUTION:

DO NOT OPERATE YOUR BENNETT READ WHISPER WITHOUT IT’S FILTERS IN PLACE OR WITH WET/DAMP FILTERS. SERIOUS DAMAGE WILL BE CAUSED TO THE MACHINE IF NOT OPERATED ACCORDING TO THIS USER GUIDE AND WILL VOID YOUR WARRANTY.

! WARNING:

Your Bennett Read Whisper is equipped with a Thermal Cut-off function that is designed to protect the motor from overheating. Should the machine switch off while working, unplug the vacuum’s power cord from the wall socket, then check and clean all filters as explained in this User Guide. Allow your vacuum to cool down before switching it back on. See the Troubleshooting Guide for more information.

! NOTE:

Use only Bennett Read WHISPER replacement filters in your vacuum. Replacement parts can be purchased from selected retail stores or directly from Tevo. See page 11 for details

! CAUTION:

10

TROUBLESHOOTING

Vacuum cleanerwon't switch on

PROBLEM POSSIBLE CAUSES REMEDIES

1. Power cord not firmly plugged in, or is not switched on at the wall socket

1. Check electrical plug

Weak suctionpower

Visible dustescaping from themachine whilevacuuming

1. Dust bag full 1. Remove and clean dust bag and filters

2. Check and clean filter regularly

2. Pre-Motor filter clogged/dirty

3. Check and clean filter regularly

1. Check and install all filters as explained in this User Guide

3. Post-Motor HEPA filter clogged/dirty

ACCESSORIES

4

51

3

1. Filter bag/pre or post motor filters are not installed properly

2. Clean all filters as explained in this User Guide

2. Filter bag and filters are dirty

17 1915 16

2

1. Floor nozzle 2. Extension wand3. Airflow regulator 4. Handle5. Hose

15. Dusting brush16. Upholstery tool17. Crevice nozzle19. Turbobrush

11

CONSUMER GUARANTEE

Your Bennett Read WHISPER has a 24 month product guarantee from Tevo (Pty) Ltd. In the event of the unit malfunctioning, Tevo will replace or repair, at Tevo’s option, any faulty component, free of charge from the date of purchase by the original purchaser for 24 months. This guarantee does not apply to routine maintenance components such as filters and brushes. Damage or malfunction caused by negligence, abuse, unauthorized repair, or use not in accordance with the User Guide is not covered. Tevo is not liable for incidental or consequential damages of any nature associated with the use of this product. Tevo’s liability will not exceed the purchase price of this product.

Guarantee and Service enquiries can be made by contacting:Tevo (Pty) LtdMonday to Friday from 8am - 5pm

Customer Service Help Line 0861 77 88 88

Gauteng 086 111 8386Durban (031) 570 5900Cape Town (021) 380 0038/9

www.tevo.co.za

Other maintenance or service not included in the manual should be performed by an authorized service representative.

Thank you for selecting a Bennett Read product.

PROBLEM POSSIBLE CAUSES REMEDIES

Machine switchesoff duringoperation(Thermal Cut-offSwitch)

1. Filters dirty or clogged, or the Dust Bag is full

1. Clean or replace all filters as explained in this User Guide

2. Check and clean the flex-hose and the extension tube

2. Obstruction in the flex-hose or in the extension tube

The machine will only switch on after it has cooled down sufficiently.Permanent damage will be caused to your machine if you continue to use it without addressing the root cause of the overheating as explained above

THE SUPER-SILENT, ULTRA-POWERFUL SOLUTIONFOR PREMIUM HOME CLEANING