Whirlpool Duet® Front-Load WasherWFW88HEA

Key Features

Tap Touch Controls: Allows direct access to washer functions, and its sleek appearance enhances the appeal of any space.

*Based on a 2-lb load of lightweight fabrics.

TumbleFresh™ Option: Keeps clothes fresh and reduces wrinkles by tumbling clothes periodically after cycle's end for up to 6 hours.

Steam-Enhanced Cycles: Add the power of steam to select wash cycles to eliminate tough stains with virtually no pretreating.

Precision Dispense: Holds additives and releases them at the correct time during the cycle for optimal fabric care. Detergent mixes with water to penetrate fabrics and virtually eliminate pretreating.

Duet® Front-Load WasherWFW88HEA

AA208066 WL120251®Registered trademark/™ Trademark of Whirlpool, U.S.A. ©2012. All rights reserved.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Specifications Dimensions

Front-Loading Automatic Washer

PRODUCT MODEL NUMBERS OVERALL DIMENSIONS

WFW94HEX, WFW95HEX, WFW97HEX

Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.

Washer dimensions

Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice.

Ref. W10254447 08/2010

Drain System Options311/2"

(800 mm)

27"(686 mm)

38"(965 mm)

51"(1295 mm)

7"(178 mm)

14"(356 mm)

1"(25 mm)

4"(102 mm)

1"(25 mm)

34" min.(864 mm)

1"(25 mm)

4"(102 mm)

24 in.2

(155 cm2)

48 in.2

(310 cm2)

3"(76 mm)

3"(76 mm)

1"(25 mm)

1"(25 mm)

1"(25 mm)

39" min.(990 mm)

1"(25 mm)

5"(127 mm)

24 in.2

(155 cm2)

48 in.2

(310 cm2)

3"(76 mm)

3"(76 mm)

771/2"(1969 mm)

6"(152 mm)

1"(25 mm)

Custom cabinet installation:

Recessed area or closet installation (washer only):

Recessed area or closet installation (stacked washer and dryer):

Custom under counter installation:

Floor standpipe drain system

41/2"(113 mm)

Wall standpipe drain system

41/2"(113 mm)

Laundry tub drain system

Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at least 30" (762 mm) above floor; install no higher than 96" (2.44 m) from bottom of washer.

30"(762 mm)

min.

41/2"(113 mm)

Floor drain system requires a Siphon Break Kit (Part Number 285834) and additional drain hose (Part Number 8318155) with a connector kit (Part Number 285835) that may be purchased separately. To order, please see toll-free phone numbers in your Washer User Instructions. Minimum siphon break: 28" (711 mm) from bottom of washer. (Additional hoses might be needed.)

Floor drain system

Drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need.

IMPORTANT: To avoid siphoning, 4.5" (113 mm) of drain hose should be inside standpipe or below the top of wash tub. Always secure drain hose with beaded tie strap.

Minimum diameter for a standpipe drain: 2" (51 mm). Minimum carry-away capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm) diameter to 1" (25 mm) diameter Standpipe Adapter Kit is available (Part Number 280130). To order, please see toll-free phone numbers on front page of your Washer User Instructions. Top of standpipe must be at least 30" (762 mm) high; install no higher than 96" (2.44 m) from bottom of washer. If you must install higher than 96" (2.44 m), you will need a sump pump system.

Duet®

Washer moDel WFW88hearecommenDeD Dryer We/GD88hea

Keeps clothes looKinG neWer lonGer*Capacity 4.3 cu ft.

Energy Star Qualified Yes - Tier IIITap Touch Controls Yes

LED display with estimated time remaining YesDrum Material Stainless Steel

Heater YesNumber of Cycles 11

Steam-Enhanced Cycles YesEco-Boost Option Yes

Presoak Option YesAllergen Yes

Sanizitation YesClean Washer Yes

Quick Wash YesCold Wash Yes

Delicates Yescolors c,W

C=Chrome Shadow, W=White

***Intermittent tumbling in the washer helps reduce the growth of odor-causing bacteria.***Thanks to the Adaptive Clean wash system with Precision Dispense Ultra or Precision Dispense. ***Compared to traditional top load washers.

Dimensions

Carton Depth 35

Carton Height 39 1/8

Carton Width 29 7/16

Depth 32 3/4

Height 38 1/2

Width 27

Gross Weight 255

Install Depth Max 52 3/4

Install Depth Min 36 1/2

Note: All dimensions are shown in inches.

52 1/4"(1327) mm

38 1/2"(978) mm

27"(686 mm)

32 3/4"(821) mm

Whirlpool Duet® Front-Load DryerWED88HEA—Electric | WGD88HEA—Gas

Key Features

Advanced Moisture Sensing: Three built-in sensors read incoming air temperature and outgoing air tem- perature while monitoring moisture levels inside the dryer. This helps the drying cycle end when everything is perfectly dry, saving time and energy and helping to prevent overdrying.

Wrinkle Shield™ Plus Option with Steam: Help keep wrinkles from setting in to your clean clothes for up to 140 minutes. These models use the added benefit of steam for even better wrinkle-fighting performance.

*Compared to a conventional top-load laundry pair, electric models only.

Quad Baffles: Four shorter, staggered baffles increase the effectiveness of the dryer and promote better, more even tumbling.

Tap Touch Controls: Inter-face allows direct access to dryer functions, and its sleek appearance enhances the appeal of any space.

Duet® Front-Load DryerWED88HEA—Electric | WGD88HEA—Gas

AA208066 WL120251®Registered trademark/™ Trademark of Whirlpool, U.S.A. ©2012. All rights reserved.

Specifications Dimensions

Duet®

Dryer moDel We/GD88hearecommenDeD Washer WFW88hea

preserves the perFect Fit*Capacity 7.4 cu ft.

ENERGY STAR QUALIFIED Yes - Tier IIITap Touch Controls Yes

LED display with estimated time remaining YesDrum Material Stainless Steel

Duel Heating Element YesNumber of Cycles 10

Temperature Controls 5Steam-Enhanced Cycles Yes

Wrinkle Shield YesSanizitation Yes

Eco-Boost Option YesQuick Dry YesTimed Dry Yes

Delicates YesVenting 4-way internal

colors c,WC=Chrome Shadow, W=White

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Dimensions

Carton Depth 35

Carton Height 39 1/8

Carton Width 29 7/16

Depth 31 1/8

Height 38 1/8

Width 27

Gross Weight 255

Install Depth Max 56 5/8

Install Depth Min 36 1/2

Note: All dimensions are shown in inches.

Electric Dryer

PRODUCT MODEL NUMBERS

Recommended Installation Spacing (Dryer Only):

WED94HEX, WED95HEX, WED97HEX

NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See “Venting Requirements.”

27"(686 mm)

3/4"*(18 mm)

381/8"(968 mm)

Front view: Side view: Back view:

61/2"(165 mm)

297/8"*(759 mm)

31/2"*(89 mm)

61/8"*(156 mm)

143/8"(365 mm)

3/4"*(18 mm)

18" min.(457 mm)

1"(25 mm)

5"(127 mm)

24 in.2 min.(155 cm2)

48 in.2 min.(310 cm2)

3"(76 mm)

3"(76 mm)

1"(25 mm)

Installation spacing for recessed area or closet installationAll dimensions show recommended and minimum spacing allowed.

■ Additional spacing should be considered for ease of installation and servicing.

■ Additional clearances might be required for wall, door, floor moldings, and dryer venting.

■ Additional spacing should be considered on all sides of the dryer to reduce noise transfer.

■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

■ Companion appliance spacing should also be considered.

Electric Dryer

PRODUCT MODEL NUMBERS

Recommended Installation Spacing (Dryer Only):

WED94HEX, WED95HEX, WED97HEX

NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See “Venting Requirements.”

27"(686 mm)

3/4"*(18 mm)

381/8"(968 mm)

Front view: Side view: Back view:

61/2"(165 mm)

297/8"*(759 mm)

31/2"*(89 mm)

61/8"*(156 mm)

143/8"(365 mm)

3/4"*(18 mm)

18" min.(457 mm)

1"(25 mm)

5"(127 mm)

24 in.2 min.(155 cm2)

48 in.2 min.(310 cm2)

3"(76 mm)

3"(76 mm)

1"(25 mm)

Installation spacing for recessed area or closet installationAll dimensions show recommended and minimum spacing allowed.

■ Additional spacing should be considered for ease of installation and servicing.

■ Additional clearances might be required for wall, door, floor moldings, and dryer venting.

■ Additional spacing should be considered on all sides of the dryer to reduce noise transfer.

■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

■ Companion appliance spacing should also be considered.

** Preserves the perfect fit thanks to Advanced Moisture Sensing select models.**Compared to conventional (traditional) top load washers.