W I Issue 3 I 213 noteworthy - agric.wa.gov.au

4
Supporting your success 1 NW I Issue 35 I 2013 Tagasaste used as part of a windbreak for a cropping operation. Strong winds can wreak havoc on crops, pastures, vineyards and orchards causing breakages, fruit fall and sandblasting. Small landholders can avoid potential damage to their farming enterprise with careful planning. Before planting a windbreak you must consider it’s purpose, orientation, spacing, length, height and the most suitable species for your property and the enterprise you are trying to protect. Land owners situated on Western Australia’s Swan Coastal Plain are predominantly faced with strong easterly winds on summer mornings, which swing around to the south-west in the afternoon. During winter, damaging winds can prevail from the north-west. The risk of damage can be greatly reduced by establishing windbreaks to provide protection. Windbreaks work by reducing wind speed and turbulence downwind of the break. They should be permeable and aim to filter the wind, not block it out completely. The most cost-effective windbreaks are trees, which can also offer many additional benefits to the property, including: prevent soil erosion improve plant growth by reducing moisture stress protect plants from wind damage provide shade and shelter for livestock lower the watertable in ‘boggy’ areas increase biodiversity reduce wind evaporation from farm dams. The benefits of correctly designed windbreaks generally outweigh the possible disadvantages. The drawbacks of planting windbreaks are a perceived loss of land as well as the money and time taken to plant the trees and ongoing maintenance (pruning, irrigation, fencing and fertilising). Windbreak design To ensure a windbreak achieves the desired purpose, it needs to be carefully designed. The following key factors should be considered: orientation tree spacing height and length set back distance choosing suitable species. Orientation Windbreaks should be at right angles to the prevailing wind direction. For properties on the NW 51 I 2014 Establishing effective windbreaks on the Swan Coastal Plain noteworthy Small landholder series

Transcript of W I Issue 3 I 213 noteworthy - agric.wa.gov.au

Page 1: W I Issue 3 I 213 noteworthy - agric.wa.gov.au

Supporting your success 1

NW I Issue 35 I 2013

Tagasaste used as part of a windbreak for a cropping operation.

Strong winds can wreak havoc on crops, pastures, vineyards and orchards causing breakages, fruit fall and sandblasting.

Small landholders can avoid potential damage to their farming enterprise with careful planning.

Before planting a windbreak you must consider it’s purpose, orientation, spacing, length, height and the most suitable species for your property and the enterprise you are trying to protect.

Land owners situated on Western Australia’s Swan Coastal Plain are predominantly faced with strong easterly winds on summer mornings, which swing around to the south-west in the afternoon.

During winter, damaging winds can prevail from the north-west.The risk of damage can be greatly reduced by establishing windbreaks to provide protection.

Windbreaks work by reducing wind speed and turbulence downwind of the break.

They should be permeable and aim to filter the wind, not block it out completely.

The most cost-effective windbreaks are trees, which can also offer many additional benefits to the property, including:

• prevent soil erosion

• improve plant growth by reducing moisture stress

• protect plants from wind damage

• provide shade and shelter for livestock

• lower the watertable in ‘boggy’ areas

• increase biodiversity

• reduce wind evaporation from farm dams.

The benefits of correctly designed windbreaks generally outweigh the possible disadvantages.

The drawbacks of planting windbreaks are a perceived loss of land as well as the money and time taken to plant the trees and ongoing maintenance (pruning, irrigation, fencing and fertilising).

Windbreak designTo ensure a windbreak achieves the desired purpose, it needs to be carefully designed.

The following key factors should be considered:

• orientation

• tree spacing

• height and length

• set back distance

• choosing suitable species.

OrientationWindbreaks should be at right angles to the prevailing wind direction. For properties on the

NW 51 I2014

Establishing effective windbreaks on the Swan Coastal Plain

noteworthySmall landholder series

Page 2: W I Issue 3 I 213 noteworthy - agric.wa.gov.au

Supporting your success 2

NW I Issue 35 I 2013

Mechanical planting can be more time effective.

The rows should be planted about three to four metres apart. Most trees/shrubs should be planted in a line about three to five metres apart (wider gap between trees, lesser gap between shrubs).

If planting only one or two-row windbreaks is unavoidable, reduce the spacing between trees to achieve faster closure of the canopy and to insure against gaps.

Where an access track or gate is needed, plant some shrubs right up to the gate/track to help prevent the wind from accelerating through the space.

An additional short windbreak at least twice the length of the gap to the windward side of the access gap can also help.

Height and lengthThe higher a windbreak the larger the area it will protect.

However, height is best limited to 10m to prevent excessive shading of the adjacent area.

Windbreaks offer wind protection to a distance of about 10 times their height.

NW 51 I 2014

Swan Coastal Plain, a windbreak running north-north-west to south-south-east will give the best protection without causing excessive winter shade.

It’s important when planning to be aware of access roads or other structures that may be impacted.

Tree spacingAn effective windbreak will filter the wind, not stop it from passing through.

Permeability should be about 50% with gaps minimised in the windbreak to prevent wind tunnels, which may cause direct damage to plants on the other side.

Windbreaks work best when they consist of several rows of staggered trees and shrubs. This allows the trunks of one row to be aligned with gaps in the next row.

Planting at least three rows offers some insurance against gaps from seedling or mature plant deaths. If a tree dies another should be planted in its place.

Shrubs are best planted on the outside (windward), with taller trees on the inside of the windbreak.

Dry sand areas

Trees/tall shrubs (>3m) ShrubsPeppermint (Agonis flexuosa)

Coojong (Acacia saligna)

Moonah/Rottnest tea tree (Melaleuca lanceolata)

Olive Grevillea (Grevillia olivacea)

Woody pear (Xylomelum occidentale)

Red eyed wattle (Acacia cyclops)

Spearwood (Kunzea glabrescens)

One sided bottlebrush (Calothamnus quadrifidus)

Winter wet flats

Trees/tall shrubs (>3m) Shrubs

Swamp peppermint (Agonis littoralis)

Swamp blood flower (Calothamnus lateralis)

Swamp sheoak (Casuarina obesa)

Mountain kunzea (Kunzea recurva)

Spearwood (Kunzea ericifolia)

Grey honey myrtle (Melaleuca incana)

Wonnich (Callistachys lanceolata)

Robin redbreast bush (Melaleuca laterita)

Table 1 Local species suitable for windbreaks.

Page 3: W I Issue 3 I 213 noteworthy - agric.wa.gov.au

Figure 1 A windbreak consisting of trees and shrubs breaks the force of the wind. Streams of air will pass through and over the top (Source: Primary Industries and Resources SA).

Supporting your success 3

NW 51 I 2014

For example, a 5m windbreak will give protection for about 50m downwind.

Protection is greatest at ground level so orchards, grapevines and other taller crops will be less protected because of their height.

The length of the windbreak needs to be a minimum of 15-20 times the height of the trees; otherwise wind will be deflected around the ends, reducing its effectiveness.

Therefore a 5m high windbreak should be 75-100m long.

Set back distanceTo reduce shading and competition from tree roots, windbreaks should be planted at least 10m from any crop.

Allow a greater buffer area if tall windbreak species are being used.

Sufficient room should be left to allow ripping of the tree roots, vehicle access and turning space. A greater distance between crop and windbreak is required when

trees are planted to the north of the cropping area to minimise shading in winter.

Choosing suitable speciesA wide range of species are available for windbreaks (see Table 1).

Choose species that are well adapted to the site conditions.

Plants which are native to the area are highly specialised and generally have very few pests or diseases.

Choosing the wrong species for a soil type and rainfall area can end in poor growth and premature deaths.

When choosing species consider the following:

• the tree species matches the soil type

• mature height and lateral root growth

• water requirements and growth rate

• selection of species with foliage close to ground level

• a combination of species to reduce gaps and provide biodiversity.

If suitable, deciduous trees can be considered for frost-susceptible locations to prevent cold air being trapped by the windbreak.

It is important to check with a tree supplier if any of the potential species for use as a windbreak are a risk of becoming a weed.

Establishing a windbreakNearly all soils benefit from ripping as it breaks up compacted soils such as those found on properties with a long history of grazing.

It’s best to deep rip in late summer to early autumn when the soil is dry, and to a depth of 50-80cm.

Mounding may be necessary in waterlogged areas.

Mounds should be 20-30cm high by 1m wide and done on the contour.

Weed controlBefore the trees are planted, control weeds to a distance of 1m outside the proposed tree row/s by cultivation and/or with herbicides.

A non-residual herbicide such as glyphosate can be used.

For more effective weed control use a residual, pre-emergent herbicide such as simazine (only if no run-off can occur) and wait at least two weeks before planting the trees.

Page 4: W I Issue 3 I 213 noteworthy - agric.wa.gov.au

For more informationNoteworthy 1 - Safe chemical spraying for small landholders

Noteworthy 2 - Fencing for beginners

Noteworthy 41 - Waterwise irrigation - big benefits for small properties

Nurseries

Rural suppliers

Landcare groups

Contact detailsSmall Landholder Information Service (SLIS) agric.wa.gov.au/small_landholder +61 (0) 8 9733 7777 or +61 (0) 8 9780 6100

Important disclaimer The Chief Executive Officer of the Department of Agriculture and Food and the State of Western Australia accept no liability whatsoever by reason of negligence or otherwise arising from the use or release of this information or any part of it.

© Western Australian Agriculture Authority 2014

4

NW 51 I 2014

Supporting your success

Consider irrigation and fertiliserIf you use local species and plant early after the break of season, the trees should be able to get established before the dry, hot summer.

However, nearly all species will benefit from being watered once a week during the first two to three summers if possible.

Irrigation is also likely to promote a sustained growth rate and reduce root invasion into any irrigated production areas.

Fertiliser requirements will depend on the species you choose, but most trees (including natives) will benefit and grow more quickly with some additional nutrients.

Check with your tree supplier for recommendations.

Control pests, disease and stockUsing local or native species will minimise pest and disease attack.

Rabbits, kangaroos and ducks can find seedlings tasty, so try to control pests before planting or

consider using tree guards specific to the pest/s if possible.

During establishment of a windbreak it is recommended to exclude stock, so trees can reach their maximum height without any setbacks.

Temporary or permanent fencing could be erected.

Consider allowing stock to access the shade offered by the windbreak once the understorey is well developed, but remove them if damage and gaps in the trees/shrubs become apparent.

Windbreaks can be a great addition to any property.

They can help prevent soil erosion, protect plants from wind damage, provide shelter for livestock, increase biodiversity and reduce evaporation from dams.

However, it is vital you take the time to plan.

Consider purpose, location, design and species, so you get it right the first time and enjoy the many benefits windbreaks can provide your property.