User Manual · Web viewUser Manual VM-338A GPS DV Tracking & CAR VIDEO RECORDER Thanks for using...
Transcript of User Manual · Web viewUser Manual VM-338A GPS DV Tracking & CAR VIDEO RECORDER Thanks for using...
User Manual
VM-338A GPS DV
Tracking
1
&
CAR VIDEO RECORDER
2
Thanks for using GPS DV Device!
We reserves the rights of final interpretation of
the manual.
The product is subject to change without notice.
Please accept our apology for your inconvenience.
Please back up your information in the GPS
navigator. Our assumes no responsibility for any loss
caused by material loss.
The manual might contain a few mistakes
though it has been checked. If mistakes are found,
please contact the locus customer service center.
Main function
1. GPS navigation. Very smart, support 3D map
2. One key recording. Get into the recording mode
conveniently.
3. One key enter navigation. Get into the GPS
3
mode conveniently.
4. Support circulating recording. The video before
will be covered automatically.
5. Memo function. Support hand-writing.
6. Can record video while charging.
7. Video(HD film) can be played on this device.
Please read the instructions in this manual
and use only accessories to avoid unpredicted damage.
Failure to follow the instructions will invalidate
warranty and might endanger personnel safety, for
which YF assumes no responsibility.
Data of navigation electronic maps might
be inconsistent with actual traffic signals due to
transportation development. Please follow traffic
regulations and signs and drive according to road
4
situation. Operating the GPS navigator device while
driving might cause serious accidents. We assumes no
responsibility for accidents and loss due to improper
use.
For information of software update and
upgrade, please contact the dealer.
The pictures in the manual are subject to
the material object.
Chapter I Beginning Use
1.1 Appearance 6
paint of paint 7
1.2 Power Supply & Charging 9
1.3 Basic Use 13
1.4 System Main Interface and Major Functions 13
Chapter II
5
2.1 Map 14
2.2 Navigation 15
2.3 DV 15
2.4 Player 17
2.5 Setting 18
2.6Tool case 19
2.7 Time setting 19
2.8Navigation path 20
2.9game 21
Parameters 20
Accessories 21
Troubleshooting 22
Welcome
Thanks for using the GPS navigation and DVR. With
navigation as the major function,
6
it supports DVR, audio play, video play and so on.
You may use the GPS navigator anytime anywhere, for
example while driving, walking or cycling. Its
navigation and amusement functions will enrich your
life and work!
You may see the following supplemental information
in the manual.
Chapter I Beginning Use
This chapter introduces the appearance, components
7
and basic operations.
1.1 Appearance
The effect figure below is subject to the material
object.
8
TF card earphone mic USB2.0 battery
paint of paint
9
Camera Speaker
Note: for your navigation at the same time, can undertake DV the recording, the parameters of the record, in the map to your perfect display.
10
How to use ?First,need to set the screen size
11
Not full screen stateAnd then into DV interface
And then into DV interface
1.2 Power Supply & Charging
Charge the GPS navigator fully with the charger
before first using.
12
1.2.1 Power Supply
The GPS can be powered by the built-in battery or
external power supply.
When the GPS navigator is unconnected to the
charger, it is powered by the Li-polymer battery. When
the GPS navigator is connected to the charger, it is
powered by external power and the battery is charged.
[Attention] The GPS navigator adopts internal
removable Li-polymer battery. To avoid battery
rupture, explosion, release of hazardous substance or
burn, do not unpack, pierce, strike on or discard the
battery in fire or water.
1.2.2 Charging by Charger
The GPS navigator must be charged with the charger
before first use.
Plug the USB terminal of the charger into the USB
13
port on the left side of the GPS navigator and the other
to the power socket to supply power and charge the
GPS navigator.
[Note] Please charge the GPS navigator when the
battery is low or used up in succeeding use.
1.2.3 Charging by Car Charger
Plug one terminal of the car charger into the USB port
on the left side of the GPS navigator and the other to
the charging port to supply power and charge the GPS
navigator.
[Note] Plug in the car charger after the automobile is started to avoid damage due to current surge.
1.Powering on/off & Sleep
14
2.Powering on
Press the power key on the top of the GPS
navigator for at least two seconds to power it on.
3.Powering off & Sleep
Long press the power key to power off the GPS
navigator. The following interface will be prompted. If
short press the key to power, the device will entering
sleep mode at once, re-short press the key to power,
the device will come back the device will
automatically resume the state before entering sleep
mode when powered on again.
Or
15
1.3.1Restarting the System
When the system does not response, Long press(6
seconds) the power key to restart the system.
1.3.2Fixing the GPS Navigator with Mounting Kit
16
Standby
Restart
Shutdown
The mounting kit is composed of a back splint and a
bracket. To use the GPS navigator in an automobile,
fix it on the dashboard under the front windshield.
[Note] Do not place the GPS navigator in positions
obstructing the driver’s vision. Do not place it without
fixing it, or in the place of air bag or the area after the
air bag is inflated.
1.4 Major Functions
17
Long press the power key on the top of the device to
enter the system main interface.
Chapter II GPS
Various navigation mapping applications can be
installed in the GPS navigator, such as IGO,
TOMTOM intelligent navigation systems, which
position the navigator via the satellite receiver and
display it on the map. Set a destination, and the system
will automatically work out the best path to help the
user reach the destination safely and quickly.
18
2.1 MapDue to transportation development, inconformity
between products and real traffic information will
occur a period after product release. Please drive
according to road condition and abide by traffic
regulations.
2.2 Navigation
19
Navigation paths are for reference only, and the user
may decide whether to follow them.
2.3 DV
20
Video recording: Press the DV key directly
when on standby, boot the video mode. The
red LED on , means it is video standby
now. Press the DV button in the
screen, the green button become blue
, it is means recording. Please press the
button start ,Please press the button
if you want to stop video.
Take picture
If you want to take pictures, Please press the
21
button in the screen,the green button
become the blue ,You can begin
to take pictures. Press this button to take pictures.
2.4 PLAYER(MP3 OR FILM OR PICTURE)
This a media player which built-in this device. You
can view the video with this player.
22
2.5 SETTING
This section is for setting the time and the calibration
of the screen, backlight and so on.
23
:system information Brightness
Settings Touch screen calibration
Language setting Sound Settings
GPS path set
2.6 Tool case
24
View the calendar. Change the
date and time. Change the DV screen size.
calculator
2.7 Setting (Date& Time)
25
Please according to the prompt have set the date and
time. Please in is used for the first time, set up time.
Every time to put the battery, need to set a time again.
2.8Navigation Path
Insert the map data into the device and tap path mark to enter the setting progress. Used for the first
time, please first set up the path.
26
2.9GAME
Very important:
GPS receiving SPEC: COM1, baud rate 4800
27
The device spec:
Video Parameter :
Lens: 300 mega pixel color CMOS
Video: 1280x720
Frame rate: 25 – 30 fps
View angle: 70 degree or120 degree for option
LCD: 4:3 or 5.0 TFT display
Video format: MOV
Picture format: JEPG
Recording time: 2 hours
Recording and GPS navigation time: 2 hours
Micro SD card memory: 1 – 32 GB
USB: USB 2.0
Operation system: WINDOWS CE 6.0
Battery capacity: 900Mah
28
Charging time: about 4 hours
Charger: 5V 500 – 1500 Amm
GPS parameter
SDRAM 4G
Display resolution 480 x 272
Scan parameter COM1 9600
Map supported Support all WIN CE
Accessories
user manual, USB cable, stand , Car Charger
29
Chapter IX Troubleshooting
Please carry out the following operations in case of abnormal operation of the GPS navigator. For further problems, please contact our customer service center.
30
Fault Reason Solution
Startup failure
Low batterySupply external power and
charge the battery.
System downLong press(6
seceonds )power for restar.
Sudden power
cutLow battery
Supply external power and
charge the battery.
No/ vague
display
Low
backlightTurn up the backlight.
Backlight offTap the screen with the
touch pan.
Incorrect
tapping
response
Touch screen
not calibratedRecalibrate the screen.
No sounds Low volume Turn up the volume.
31
Communication
with PC
Poor USB
connectionConnect the USB cable.
GPS signals
reception
failure
Poor GPS
signal or can
not get GPS
info
About 3 minutes are needed
for low intensity of local
GPS satellite signal. Reset
the device. Resetting the
com and baud rate( com1
baud rate9600)
Loss of map
data
Accidental
deletion
Contact your agent or
distributor.
Input a new password after
recovering the GPS data.
NOTE: Please contact with the dealer if you have more question.
32