Updating to X6 Mike DeButts. Updating to X6 How to Install X6 What Not to do when Updating to X6...
-
Upload
willa-roberts -
Category
Documents
-
view
239 -
download
0
description
Transcript of Updating to X6 Mike DeButts. Updating to X6 How to Install X6 What Not to do when Updating to X6...
Updating to X6
Mike DeButts
Updating to X6
• How to Install X6• What Not to do when Updating to
X6• Migration Utility • New File Locations introduced in X6• How to Update Machine & Control
Definitions and Posts
• X6 or New Mastercam releases can always be downloaded from www.Mastercam.com
• Use the installation DVD [These may or may not have been sent to you depending on your Maintenance expiration date]
How to Install X6
• Do Not copy the following files from old versions:
-Config File-Toolbars-Key Mapping File
Take the few minutes to go thru this in the new release
What Not to do when Updating
Migration Utility • Migration Utility
• The Migration Utility is for Updating from X5 to X6
[If you have your files in the default locations] Otherwise you will need to use the manual methods shown later-
Migration Utility
• Files linked to Windows Users– My mcamx6– shared mcamx6
New File Locations
How to Update Machine & Control Definitions and Posts
• Update Folder
How to Update Machine & Control Definitions and Posts
• Update Folder -Pick File Types-Pick Source-Pick DestinationUse this method if your
files are somewhere other than default
How to Update Machine & Control Definitions and Posts
• Have the machine selected• Go thru the Settings Machine Def Manager
How to Update Machine & Control Definitions and Posts
• Have the machine selected• Go thru the Settings Machine Def Manager
Say No Below
Select Green Check Below
How to Update Machine & Control Definitions and Posts
• Machine Definition MUST have the correct version Control Definition Mapped
How to Update Machine & Control Definitions and Posts
• Click the Icon shown below to access the Control Definition Selected
How to Update Machine & Control Definitions and Posts
• Now we are in the Control Definition• Here we will select the Post Processor Button to
link the correct post
How to Update Machine & Control Definitions and Posts
• Add Files will allow you to select the correct version and location of the post
• Select the green check when done
Select and delete any other post
How to Update Machine & Control Definitions and Posts
• Select the post in the drop down• Then you will need to click on the single purple
SAVE icon• You can then Click ALL green checks out and
answer YES to everything that pops up
How to Update Machine & Control Definitions and Posts
• After completing this you will create a simple file and post.
• If you have errors go back thru the process to be sure everything is correct.
NOTE: Older versions may require the use of updatepst.dll found in chooks
Updating to X6
Any Questions?
Thank you..