Update Bartec WRT 400

25

description

How to update your Bartec WRT400 TPMS Tool!

Transcript of Update Bartec WRT 400

Page 1: Update Bartec WRT 400
Page 2: Update Bartec WRT 400
Page 3: Update Bartec WRT 400

As you are aware of by now Bartec has released software

Revision 39!

This tutorial will show you how to update your tool to the latest and greatest software Bartec has to

offer

Page 4: Update Bartec WRT 400

First make sure yourTool is powered offAnd NOT plugged

Into your PC

Page 5: Update Bartec WRT 400

Go to our website at www.bartecusa.com and click the

log in tab as shown below.

Page 6: Update Bartec WRT 400

Log into your account using your user name and

password

Page 7: Update Bartec WRT 400

Click on the tool management button

Page 8: Update Bartec WRT 400

Locate the tool you are trying to update by serial number and click the

download button for that tool

Page 9: Update Bartec WRT 400

When this window appears click the save button

Page 10: Update Bartec WRT 400

At this screen click save…DO NOT CLICK OPEN here

Page 11: Update Bartec WRT 400

Once you have saved your file you can close or minimize

your web browser and your file will appear on your

desktop

Page 12: Update Bartec WRT 400

Now you want to put your tool in program mode by pressing and holding the enter button and pressing the

green power button at the same time

Page 13: Update Bartec WRT 400

Your tool screen should read NO UPDATE FILES

FOUND

Page 14: Update Bartec WRT 400

Insert the USB cord into your PC then insert the other end into your tool…The USB port for your tool is located on the

right side

Page 15: Update Bartec WRT 400

This removable disk screen should pop up on your computer screen containing a file labeled

PROG.BIN

If the removable disk window doesn’t launch click on the start key at the bottom of the screen and open the

removable disk located under the devices with removable storage tab

Page 16: Update Bartec WRT 400

Click and drag or copy and paste the update file into the removable

disk window

Page 17: Update Bartec WRT 400

Once you move the update file to the window it will automatically begin to download the program to your tool

Page 18: Update Bartec WRT 400

Within seconds your computer will show it is downloading the file to your tool…this process will take around ten seconds to complete

Page 19: Update Bartec WRT 400

During this process your tool screen will read NO UPDATE

FILES FOUND

Once the downloading process is complete remove the USB cord from the tool and press the test button located in the

middle of the tool

Page 20: Update Bartec WRT 400

Your tool will read VERIFYING FILE

Page 21: Update Bartec WRT 400

Your tool will then say VERIFY

COMPLETE ERASING

PROGRAM

Page 22: Update Bartec WRT 400

Your tool will then begin programming and show

you the status

This process will take about thirty

seconds

Page 23: Update Bartec WRT 400

When your tool is done programming it will shut

itself off

Page 24: Update Bartec WRT 400

Power your tool back on by pressing the green power key and under the Bartec logo it should say the new

software level is 39

Page 25: Update Bartec WRT 400