Ultrasonic Flow Meter Clamp-On type - Eletta · Pipe Strap Section. DC Power Relay OCT Transducer...
Transcript of Ultrasonic Flow Meter Clamp-On type - Eletta · Pipe Strap Section. DC Power Relay OCT Transducer...
-
Ultrasonic Flow Meter-Clamp-On type
ManeeshTypewritten text EUC
-
150mm 68mm
130m
m
155m
m
1rate
4coolcap.
7flowvel.
.cal.
5heatcap.
8soundvel.
0zero
total2 3
start/stop
6temp
<diag.
9signal
Menu
/^ +
Enter
/^
-
ANBIENT TEMPERATURE(MAX):80℃CERTIFICATION:Ex ia II BT6ENCLOSURE:IP68
Ultrasonic Transducer
Part No.CP035
FLOW 31m
m
54mm
25m
m
24m
m
419AAF Series Ultrasonic Flowmeter is a state-of-the-art universal transit-time flowmeter designed using FPGA chip and low-voltage broadband pulse transmission.Comparing with other traditional flowmeter or ultrasonic flowmeter, it has distinctive features such as high precision, high reliability, high capability and low cost, the flowmeter features other advantages:TVT technology designed. Less hardware components, low voltage broadband pulse transmission, low consumption power. Clear, user-friendly menu selections make flowmeter simple and convenient to use.Daily, monthly and yearly totalized flowParallel operation of positive, negative and net flow totalizes with scale factor (span) and 7 digit display, while the output of totalize pulse and frequency output are transmitted via relay and open collector.
Description :
Dimensions :
Transmitter
Transducer
-
Flow
Flow
Flow
Downstream TransducerFlow
Pipe Strap
Section
DC Power Relay OCT Transducer 4-20mA RS485
V method measuring pipe size : 25mm-400mm
Upstream Transducer
Downstream Transducer Pipe Strap
Top View
Transducer space
Z method measuring pipe size: 100mm-800mm
Side View
Upstream Transducer Transducer
Top View
Transducer space
Wiring Diagram:
Transducer Installation Methods:
Side View Section
Transducer
-
Valve
L≥30DL≥10D
Reduce
L≥10D L≥5D
Diffuser
L≥30DL≥5D
90° Bend
L≥10D
L≥5D
Vertical
L10D
≥
L5D
≥
L≥50D
OPNE:ERxA
iTaU IIR BET(M
6AX):80 ℃ENCLOSURE
Ultrasonic T
ransducer
Part No.
L≥10D
Tee
L≥50D
Ultrasonic Transducer
Ultrasonic Transduc
er
When selecting a measurement site, it is important to select an area where the fluid flow profile is fully developed to guarantee a highly accurate measurement. Use the following guidelines to select a proper installation site:1.Choose a section of pipethat is always full of liquid, such as a verticalpipe with flow in theupward direction or a fullhorizontal pipe.
2.Ensure enough straightpipe length at least equalto the figure shown belowfor the upstream anddownstream transducersinstallation.3.Ensure that the pipesurface temperature at themeasuring point is withinthe transducertemperature limits.
4.Consider the insidecondition of the pipecarefully. If possible,select a section of pipewhere the inside is free ofexcessive corrosion orscaling.
Straight length of upstream piping Straight length of downstream piping
Installation Site Selection :
-
Eletta Flow ABP.O. Box 5084SE-141 05 Kungens KurvaSweden
Tel: +46 8 – 603 07 [email protected]
±0.03ft/s ±0.01m/s
3
74
8
OCT output, Relay output, RS232, 4-20mA output, RTD inputOCT output, Relay output, RS485, 4-20mA output
OCT output, Relay output, RS485, 4-20mA output, RTD input
Code Output mode
Code
CP035
W210
Code
030
xxx
Type of transducers
Clamp on transducer,Operating temperature:32℉~ +140℉(0℃~+60℃)
Insertion transducer,Operating temperature:-40℉~+176℉(-40℃~+80℃)
Transducer Cable LengthStandard 30ft (9m)
Maximum lengthen to 305m(1000ft), per 5m is a lengthen unit.
CodePT1000
output, Relay output, RS485, 9m cable.
Type of Temperature sensorPT1000 Temperature sensor
419AAF
Standard Model: 419AAF-4-CP035-030Description: standard flowmeter with Clamp-on transducers, OCT pulse
DescriptionModel
Digital Correlation Transit Time FlowmeterInstallation method:wall mountTransmitter:Flow Range: ~ ±16ft/s ( ~ ±5m/s)Accuracy: ±1.0% of measured valueRepeatability: 0.3%Pipe Size Range:1"~48" (25mm ~ 1200mm)Keyboard:16 (4×4) touch keysDisplay:20×2,alphanumeric,backlit LCDPower supply:10-36V DC@1AmaxTransmitter enclosure:IP65,ABS/PC enclosureTemperature:-20℃~50℃Output: OCT pulse output 0-10KHz, Relay output, 4-20mA optionalCommunication: RS232, Modbus ProtocolTemperature: -40℉~+140℉ (-40℃~60℃)
Ordering Information:
OCT output, Relay output, RS232, 4-20mA output
EUC4
19A1
E20
El-Leaflet-Eletta Vortex Flowmeter_LUGB_V1718.pdf (p.2-5)Untitled