Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic...
Transcript of Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic...
![Page 1: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/1.jpg)
Tuning a Dual-Band Bow-tie Slot
Antenna with Parabolic Radiating
Slots for the 900 MHz and 2400
MHz Bands
Layne A. Berge
Michael T. Reich
Masud A. Aziz
Benjamin D. Braaten Department of Electrical and
Computer Engineering
North Dakota State University
Fargo, ND, USA
![Page 2: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/2.jpg)
• Introduction and background information
• Purpose of research
• Simulated and measured results
• Discussion
• Conclusion
Overview
![Page 3: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/3.jpg)
Introduction
M. Miao, B. Ooi, and P. Kooi, “Broadband CPW-fed wide slot antenna,”Microwave and Optical Technology Letters, vol. 25, no. 3, pp. 206–211,2000.
•Planar, bow-tie, CPW
fed, slot antenna
•Original design
maintained broadband
operation between 3
and 5 GHz
![Page 4: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/4.jpg)
Background
•Planar antennas are simple to fabricate in-house
•CPW (coplanar waveguide) feed allows balanced
excitation
•Bow-tie antenna design has a dipole like gain
pattern
![Page 5: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/5.jpg)
Purpose of Research
•Create an antenna design using a lower
permittivity substrate (original ɛr = 10.1)
•Dual-band operation at lower, consumer-band
frequencies
•900 MHz
•2400 MHz
![Page 6: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/6.jpg)
Design
H = 140 mm
W = 240 mm,
Bw = 100.2 mm
Bi = 8 mm
Bo = 70.3 mm
g= 0.4 mm
d = 4.6 mm
S = 7.5 mm
![Page 7: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/7.jpg)
Design
•Rogers 4003C
•Ɛr = 3.55
•Thickness =
1.6 mm
![Page 8: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/8.jpg)
Design
•Parabolic curves emulate a
Vivaldi antenna design
•Broadband
•Greater slot perimeter =
longer path taken by currents
J. Mandeep and M. Nicholas, “Design An
X-Band Vivaldi Antenna,” Microwaves &
RF, vol. 47, no. 8, 2008.
![Page 9: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/9.jpg)
Measurement and Simulation Results
•Compared both Method of
Moments and Finite-
Element Method
•Good correlation between
simulated and measured
results
•Dual-band operation at 900
MHz and 2400 MHz
![Page 10: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/10.jpg)
Measurement and Simulation Results
•Gain at 900 MHz in the y-z plane (left) and x-z plane (right)
•Gain pattern similar to a dipole antenna
•Simulated gain excursion caused by ideal assumptions (infinite
substrate layer)
![Page 11: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/11.jpg)
Measurement and Simulation Results
•Gain at 2400 MHz in the y-z plane (left) and x-z plane (right)
•Gain pattern deviates from that of a dipole at high frequencies
•Caused by too large of a slot (electrically large dipole antenna →
favors side-lobes)
![Page 12: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/12.jpg)
Measurement and Simulation Results
•Surface currents at 900 MHz (left) and 2400 MHz (right)
•Too large of slot evident in “odd” surface currents in 2400 MHz plot
(right)
![Page 13: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/13.jpg)
Measurement and Simulation Results
•Field strength at 900 MHz in the y-z plane (left) and x-z plane
(right)
•Low cross-polarization in both plots
•Correlates well with gain plots
![Page 14: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/14.jpg)
Measurement and Simulation Results
•Field strength at 2400 MHz in the y-z plane (left) and x-z plane
(right)
•Non-negligible cross-polarization evident in each plot
•Reinforces distorted gain patterns
![Page 15: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/15.jpg)
Discussion • Deviation from simulated and measured gain
results at 900 MHz occurred because of ideal
assumption by software (infinite substrate)
• Poor gain plots at 2400 MHz
– Asymmetries partly caused by radiation losses through
the substrate
– Main cause was found to be the slot width being near
1.5λ
– Large slot results in prominent side lobes
– Similar to results for electrically long dipole antennas
![Page 16: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/16.jpg)
Discussion • Maintained large bandwidth at both operating
frequencies (Return Loss > 10 dB)
– 602 MHz bandwidth at 900 MHz
– 229 MHz bandwidth at 2400 MHz
• Used a lower permittivity substrate
– Less loss
• Curved slot sides presented a longer path to
currents than a comparable straight side
![Page 17: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/17.jpg)
Conclusion • Created a dual-band bow-tie slot antenna
operating at 900 MHz and 2400 MHz
• Used a lower permittivity substrate than
previous designs
• Used curved slot sides in order to reduce size
of antenna
• Gain pattern at 2400 MHz was distorted
– Slot width too wide
![Page 18: Tuning a Dual-Band Bow-tie Slot Antenna with Parabolic ...braaten/EUCAP_2012_Bowtie_presentation.pdfTuning a Dual-Band Bow-tie Slot Antenna with Parabolic Radiating Slots for the 900](https://reader034.fdocuments.us/reader034/viewer/2022042106/5e84971ea649de49814489e8/html5/thumbnails/18.jpg)
Questions?
Thank you for listening!