STAINLESS INSERT METHOD

MATERIAL COST $18 approx.

(22 Ga. Stainless Steel rolled and PVC)

TIME TO INSTALL 30-40 minutes

www.Tubos.bizP.O. Box 4663, Clearwater, FL 33758 • Fax 727.213.6391

Patent Pending

• Insert your stainless steel sleeve into existing vent pipe.

• Apply caulking on top of existing pipe.

• Cut & slide your new PVC over stainless steel.

• Cut notches into exposed stainless steel.

• Fold down stainless steel over new PVC to hold. Only good for lead boot application.

• Attach No-Hub to existing vent pipe, tighten to 60 inch lbs torque or it will leak.

• Measure and cut your PVC to specifi ed height.

• Attach PVC to No-Hub, again at 60 inch lbs torque.

• Now fi t your larger lead boot over pipe and no-hub then stuff all excess lead into smaller PVC. Not applicable for TPO or PVC roofs unless going below the roof deck.

NO-HUB METHOD

#1 - Insert your Tubos.

#2 - Cut your Tubos at code height.

#3 - Apply caulking to keep methane gas in.

Done... and you still haveone Tubos application left. Now apply lead boot, oradhere TPO or PVC, goodfor all roofi ng applications.

MATERIAL COST $22 approx.

(No-Hub and Larger Lead Boot to Fit Over No Hub)

TIME TO INSTALL 15-20 minutes

MATERIAL COST $16.70 avg. per extension

TIME TO INSTALL 3 MINUTES OR LESS !

TUBOS METHOD