Project: Flamin’Red Rocket

The following are images taken from the 3 main pictures I sent to you showing the detailing needed for the paint job on my Rocket 3 tins you have.

FLYSCREEN

OIL TANK

** NB: PLEASE NOTE THE WHITE LINES AROUND ALL OF THE BLACK AND ALSO THE

SHADOWING AROUND THE FLAMES

1

Project: Flamin’Red Rocket

Rear Fender

Front Fender

2

Project: Flamin’Red Rocket

PETROL TANK

NB: PLEASE NOTE THAT THE PATTERN IS SYMETRICAL FROM THE CENTRE OF THE FUEL FILLER PORT AND ALSO, NOTE THE

BLACK “BACKGROUND” RUNNING AROUND THE LIP OF THE TANK

3

Project: Flamin’Red Rocket

Modification to Bodywork

Rear mud guard

1.Rear mud guard cut off above the rear tail light;

2.The new shortened tail light should follow a slight round profile as below;

4

Project: Flamin’Red Rocket

Front mud guard

3.Front mud guard reduced by 3 inches on the rear and 3 inches on the front – send me some pictures once cut down so I can check its the right size;

4.Both front and rear parts of the front mud guard to follow the same profile as the original (similar to the one below but not identical);

5

Project: Flamin’Red Rocket

Side panels

5.Badges removed from both the side panels and filled as picture below;

Oil Tank

6.Oil tank indentation filled if possible so a smooth image such as below can be put on;

6

Project: Flamin’Red Rocket

Chromes to be supplied via the post shortly and painted

7.Fork wind deflectors (x2) such as the black ones shown below – Painted BLACK OR AS MAIN SCHEME IF POSSIBLE

8.Radiator surround (x1) as shown below – PAINTED AS MAIN SCHEME IF POSSIBLE

7

Project: Flamin’Red Rocket

9.Rear peg triangle (x2) such as the black one shown below – PAINTED AS MAIN SCHEME IF POSSIBLE

10. Sissy bar edges (x2) shown as below. Paint scheme on the rear mud guard should continue on to the chromes (also as shown below):

8

Project: Flamin’Red Rocket

11. Bear claw (x1) such as the one shown below. Paint scheme on the petrol tank should continue on to the bear claw (also as shown below):

9