Available NATIONWIDE Hire Desk: 0870 240 2381 TPA Product Profile

This lightweight foam RRAP system has been designed to enable road rail vehicles and equipment to mount or cross the rail quickly and safely.

An example installationvideo overview can beviewed at;

www.tpa-rrap.com

Network Rail Approved, Lightweight Foam Track Access System, for on/off tracking of RRV’s.TPA is firmly established in the rail sector as “the” principle provider of safe, effective, value for money temporary roadways, walkways & access systems.

The lightweight foam rail track access system is a further new addition to TPA’s range of portable access equipment. With its customary rapid installation time, this new RRV rail track access system shall provide a superb all round solution to the on and off tracking of road rail vehicles.

The BenefitsThe crossing or access point is made from two metre long foam sections, each of which weighs under 25kg so they can be easily hand-carried into position. Only simple site preperation is required and the system provides the following benefits;

1. Lightweight each section weighs under 25kg.2. Available in two metre kits.3. Approved for use up to 15 tons per axle.4. Network Rail Approval Number PA05/03446.5. Simple site preparation.6. Easily transported to and from the access point.

The ProcessThe lightweight foam system allows operators on site to construct a road rail access point (RRAP), simply and easily.R

ap

id R

ail

Acc

ess

© 2014 TPA Portable Roadways LimitedAll Rights reserved

Specifications are subject to change without noticeTrademarks are the property of TPA Portable Roadways Limited or their respective owners.

W: www.tpa-rrap.com T: 0870 240 2381 E: rrap@tpa-ltd.co.uk

Lightweight Foam RRAP TPA Rapid Rail Access System

Innovative SolutionThe purpose of the Foam Rail Ramps is to provide an easy to install temporary RRAP for the on/off/cross tracking of RRV’s fitted with road wheels and having axle loads up to 15tonnes.

ProtectiveThe ramps are suited for use on flat bottom plain line with a sleeper spacing of 650mm (28 per 60ft rail). The recesses for the clips will allow for some variation in the sleeper spacing.

Quick HandlingEach section has a hand hold for ease of handling.While each section is under 25kgs, it is easier and safer for two men to lift each section, due to the size.

LW Foam Specifications HighlightsDimensions• Available in two-metre kits• Multiple kits can be used to extend the length of the RRAP

Weight• Lightweight - each section weighs under 25kg

System Parts• Each two-metre ramp kit consists of 2 outer ramp sections and 1 inner deck section with 2 centre end ramps

Load Bearing Capacity• Approved for use up to 15 tonnes per axle• Maximum 30 tonnes gross weight

Installation Time• Full ramp kit, inclusive of five full track access point (bridge) sections can be fully installed and ready for use in less than 20 minutes• Easily transported to and from the access point

Note• The Lightweight Foam RRAP is not approved to be used on the Bull Head Track style of rail line, due to the clearance and “chairs” in which the rail sits.

RISQS & Link-up Achilles RegisteredSupplier Number 058540

Document Issue date 16/07/15Document Version 1.6