Toyota Aygo Presentatie
-
Upload
snijdersqcs -
Category
Automotive
-
view
1.611 -
download
2
description
Transcript of Toyota Aygo Presentatie
Toyota Aygo
EMMA advanced 5
presentation
Design Goals
• Building a SQ system on a moderate budget
• Optimal use of available space• Show off installation skills
Wiring
Power wires fused properly
• 20 mm2 power cable fused within 20 cm of positive battery pole
• Original battery and location were used
• 60 amp main fuse
Power wires fused properly
• 20 mm2 power cable from positive battery pole supplies power to the amplifier fuse block
• 10 mm2 power cables were use to power te amplifiers
• 40 amp fuses were used
Power wires fused properly
• Original iso plug of the car supplies power to the headunit
• Fused behind the radio and in the original fuse box
Wires properly terminated
Speaker wire terminations
Wire terminations properly protected
• All terminations accessible without removing panels or equipment are protected against touching
• Ground connections of the amps to the car are sealed with clear coat
Wires protected from damage
• Rubber grommet was used to protect the power cable when passing through the firewall
Wires protected from damage
• All wiring was done using PVC slit tubing to protect the wires
• This same tubing was used by the manufacturer throughout the car
Interior wires hidden from view
• All wires in the interior are hidden from view when sitting in a normal driving position (or passenger position) with the doors open
Installation
Components securely mounted
• Headunit was mounted using the supplied mounting shaft
• A custom trim panel was made for a cleaner instalation
Components securely mounted
• The amplifiers were mounted using a welded steel amprack bolted to the seat bolts
Components securely mounted
• The door speakers were bolted to the doors using 6mm bolts and a custom made trim ring
Components securely mounted
• The tweeters were bolted to the a-pilar using an 8mm bolt and custom made trim piece
• An L shaped bracket was made to fix the tweeter to the cars a-pilar
Components securely mounted
• The subbox was bolted to the car using an 8mm bolt to the spare tire location
• The subwoofer itself was bolted down with 6mm bolts
Mounting panels securely mounted
• All mounting panels serving as a structural hold for components are bolted to the car
• Mounting panels serving cosmetic purposes are pressure fitted for easy maintenance.
Protection of speakers
• All speakers are protected using grills
Normal use of the vehicle
• No equipment was installed in the drivers view
• All seats operate as from the factory
First optic impression
• All parts of the installation are finished
• No part is still “ under construction”
Overall craftsmanship
Headunit
Overall craftsmanship
tweeters
Overall craftsmanship
Door speakers
Overall craftsmanship
subwoofer
Overall craftsmanship
amplifiers
Thank you!!
Power schematicsOriginal power supply
Remote 1 mm2
Signal schematics
1.5 mm2 2.5 mm2 4 mm2