Networking 101. OSI Reference Model Data Header Header Header.
Topic1.2berrorgraphing.notebook September 06, 2019 · The "good" Topic 1: Measurement and...
5
Topic1.2berrorgraphing.notebook 1 September 06, 2019
Transcript of Topic1.2berrorgraphing.notebook September 06, 2019 · The "good" Topic 1: Measurement and...
-
Topic1.2berrorgraphing.notebook
1
September 06, 2019
-
Topic1.2berrorgraphing.notebook
2
September 06, 2019
-
Topic1.2berrorgraphing.notebook
3
September 06, 2019
-
Topic1.2berrorgraphing.notebook
4
September 06, 2019
-
Topic1.2berrorgraphing.notebook
5
September 06, 2019
Summary1. establish the independent and dependent variables, record their respective uncertainty
2. setup and plot the data; include labels, scales, units, etc.
3. using the uncertainty of the data, add error bars to each data point (one dimension might be enough)
4. draw a line of best for the data, try to be as close to the data points as possible; the line should pass through the error bars at the very least
5. determine the slope and y intercept of the line of best fit, be sure to include the units
Finding the Uncertainty for the Graph
6. draw a line that creates the maximum slope possible within the error bars, record the slope and the y intercept.
7. repeat #6 with the line that has the minimum slope, record the slope and y intercept
8. Use the difference between the max and min slopes and y intercepts to generate your uncertainty see calculations above
Page 1Page 2Page 3Page 4Page 5
