Thresholds, Weber’s law, Fechner’s three methods Research Methods Fall 2010 Tamás Bőhm.

Thresholds, Weber’s law, Fechner’s three methods

Research Methods

Fall 2010

Tamás Bőhm

Introspection

• Method applied by early psychologists (Wundt)• Self-observation of conscious thoughts and

sensations– Do I perceive this light brighter than that? Why?

• Inherently subjective rejected as a scientific method

• But it provides useful intuitions when designing experiments (helps forming hypotheses)– I realized that it is hard for me to hear very high and

very low tones. Thus the frequency of a tone may be a factor in its perceived loudness/audibility. Let’s test this in an experiment!

Formal methods

• Quantifying the sensations evoked by physical stimuli

• Gustav Fechner (1860): established 3 formal psychophysical methods

• Fechner’s methods have been (and are being) widely used

• More reliable and accurate than introspection

• Results from different experiments are comparable

Thresholds

If a linear relationship is assumed, two values determine the function:

– X-intercept: minimum stimulus value that evoked any sensation;absolute threshold

– Slope: the rate at which sensation grows as we increase intensity;difference threshold(inversely proportional to slope)

Stimulus intensity

Sen

satio

n m

agni

tude

Linear psychophysical

equation

X-intercept

slope

Thresholds

General definitions (not assuming linearity):– Absolute threshold:

intensity that the observer can just barely detect• Intensities below absolute threshold: undetectable• Intensities above absolute threshold: detectable

– Difference threshold (aka. just noticeable difference /JND/ and difference limen):minimum intensity difference that is noticeable to the observer

• A change in intensity that is smaller than the difference threshold: undetectable

• A change in intensity that is larger than the difference threshold: detectable

Difference thresholds• Linear function

difference threshold (slope) is constant

• An observer able to detect the difference between intensities 100 and 110 should also be able to detect the difference between 1000 and 1010. This is not the case: the observer is able to detect the difference only between 1000 and 1100

• 500 & 550 Hz tones• 5000 & 5050 Hz tones• 5000 & 5500 Hz tones• Difference threshold is not

constant!Stimulus intensity

Sen

satio

n m

agni

tude

Linear psychophysical

equation

constant slope

Difference thresholds

• Difference threshold is not constant (changes with intensity) function is nonlinear

• Weber’s law: difference threshold is a constant proportion of the initial stimulus value

ΔI / I = c• Previous

examples:c=10%

• Weber’s lawholds only approximately!

Stimulus intensity

Sen

satio

n m

agni

tude

Nonlinear psychophysical

equation

slope changes with intensity

Absolute thresholds

• Even in the absence of stimulation, there is some random firing on sensory nerves

• This inner noise can even vary from moment to moment• Observers cannot distinguish inner noise from the effect

of a weak stimulus• Even when there is no light (perfect darkness),

observers may experience a dim light (dark light, intrinsic light)

• Observers in an anechoic chamber often report hearing a whistling sound

Measuring truly „absolute” thresholds is problematic: observers may confuse inner noise with the real thing

Psychophysical methods• Threshold measurements: detection of small intensities (absolute thr.) and

discrimination of small intensity differences (difference thr.)Is it intense enough to see? How small a difference can you see?

– Fechner’s 3 methods• Method of constant stimuli• Method of limits• Method of adjustment

– Modifications of Fechner’s methods• Staircase method• Modifications of the method of constant stimuli (adaptive, no standard)

– Forced choice, objective methods– Sensory decision theory (SDT)– Psychophysical functions from psychometric data

• Direct scaling: growth of sensation with intensityHow bright do you see a light?

– Magnitude estimation and the power law• Multidimensional scaling: degree to which stimuli are comparable along

some dimensionsAlong which dimensions do you judge the similarity of two stimuli?

Fechner’s three methods

• Presenting one stimulus at a time

• The stimulus is very weak

• Possible responses:“Yes, I see it.” /“No, I don’t see it.”

Absolute threshold Difference threshold

Method of constant stimuli

Method of limits

Method of adjustment not used

• Presenting two stimuli at a time:

– Standard: fixed, easily detectable

– Comparison: either more or less intense than the standard

• Possible responses:“Comparison is stronger.” /“Comparison is weaker.”

Method of constant stimuli for measuring absolute thresholds

1. Select a range of light intensities from certainly invisible to certainly visible

2. Pick a few (4-7) points uniformly in this intensity range; this will be the constant stimulus set

Weak Strong

Light intensity


3. Test each stimulus many times (20-25) in random order

…


4. Present the stimuli one at a time and ask the observer if it was visible or not

Visible?YES NO

Click to start

Could you see the spot of light?


5. Calculate the proportion of “yes” and “no” responses at each light level

+ - + + + - - - + + + - - - - +

0% 5% 20% 50% 80% 95% 100%


6. Plot the percentages against stimulus intensity psychometric function

Stimulus intensity

Per

cent

age

“see

n”

0%

100%

50%

75%

25%

Psychometric function for absolute thresholds

Ideal

FIG (Sekuler)

• Fixed absolute threshold• Step function

Actual

FIG (Sekuler)

• Absolute threshold varies somewhat from trial to trial (due to constant fluctuations in sensitivity)

• Conventionally, the intensity corresponding to 50% is considered to be the threshold

sigmoid function

Method of constant stimuli for measuring difference thresholds

1. Standard stimulus has a fixed intensity

2. The intensities of comparison stimuli bracket the standard

Light intensity

Standard stimulus:

Comparison stimuli:


3. All pairs of standard and comparison stimuli are tested many times


4. For each pair, the observer judges if the comparison stimulus was stronger or weaker than the standard

http://www.yorku.ca/psycho

STRONGER WEAKER





5. For each comparison level, the percentage of “stronger” responses is calculated and results are plotted as a psychometric function

Light intensity of comparison stimuli

Per

cent

age

“str

onge

r”

0%

100%

50%

75%

25%

Psychometric function for difference thresholds

• When the observer cannot see a difference, he/she chooses randomly between “stronger” and “weaker”; this corresponds to 50% on the psychometric function point of subjective equivalence (PSE)


Per

cent

age

“str

onge

r”

0%

100%

50%

75%

25%

PSE

Psychometric function for difference thresholds

• By convention, the intensity at 75% is considered to be just noticeably stronger than the standard DS

• A comparison intensity at 25% is just noticeably weaker than the standard DW

• Difference threshold = the average of DS and DW


Per

cent

age

“str

onge

r”

0%

100%

50%

75%

25%

DW DS

Method of limits for measuring absolute thresholds

1. On each trial, the observer reports if she/he could see the light or not.

2. Start with presenting a light intensity well above the expected threshold (the observer can certainly see it)

3. Decrease the intensity until the observer cannot see it

4. Threshold estimate: the intensity at which the response changes

+

-

+

+

+

+

+

-

-

-

-

Ligh

t in

tens

ity

Trials

• Descending series: start from above the expected threshold and decrease intensity

• Ascending series: start from below the expected threshold and increase intensity

threshold estimate

Click to start

Method of limits for measuring absolute thresholds

• Ascending and descending series may yield different results use both

• Even in the same direction, there is variability in the threshold (inner noise, etc) average many measurements

• Measured threshold corresponds to 50% point in a psychometric function (method of constant stimuli)

+

-

+

+

+

+

+

-

-

-

- -

+

+

+

+

+

-

-

-

-

Ligh

t in

tens

ity

Trials

pure-tone audiometry

http://www.phys.unsw.edu.au/jw/hearing.html

http://www.phys.unsw.edu.au/jw/hearing.html

threshold estimate

Method of limits for measuring difference thresholds

• Intensity of the comparison stimulus is decreased (descending) or increased (ascending) until the response changes

• Threshold estimate: intensity difference between the standard and comparison stimuli where the response changes

• Average results from multiple series in both directions

+

-

+

+

+

+

Ligh

t in

tens

ity o

f co

mpa

rison

stim

ulus

Trials

+ comparison brighter

- comparison weaker

+

-

-

-

-

+

-

+

+

+

+

-

-

-

-

-

+

Method of adjustment for measuring absolute thresholds

• Observer can vary the stimulus intensity

• Instructed to adjust it so that it is just visible or just invisible

• Initial intensity is set to be far from the expected threshold value

adjustment device

stimulus with adjusted intensity

observer

Method of adjustment for measuring absolute thresholds

• Threshold estimate: final intensity value

• Descending: initial intensity is well above expected threshold; adjusted to just visible

• Ascending: initially well below threshold; adjusted to just invisible

• Ascending and descending task repeated several times and results averaged

• Similar to method of limits but observers find it easier

threshold estimate

descending ascending

• Adjustment: by a real or a software device (e.g. knob, slider)

Thresholds, Weber’s law, Fechner’s three methods Research Methods Fall 2010 Tamás Bőhm.

Documents

Transcript of Thresholds, Weber’s law, Fechner’s three methods Research Methods Fall 2010 Tamás Bőhm.