Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary...
Transcript of Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary...
![Page 1: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/1.jpg)
S1
Supplementary Information
Thin film transfer for the fabrication of tantalum nitride photoelectrodes
with controllable layered structures for water splitting
Chizhong Wang, Takashi Hisatomi, Tsutomu Minegishi, Mamiko Nakabayashi, Naoya
Shibata, Masao Katayama, and Kazunari Domen*
Electronic Supplementary Material (ESI) for Chemical Science.This journal is © The Royal Society of Chemistry 2016
![Page 2: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/2.jpg)
S2
Experimental Section
Monochromatic irradiation (full width at half wavelength: 10 nm) from a Xe lamp (MAX-302,
Asahi Spectra) was used to measure the incident photon-to-current conversion efficiency (IPCE).
The IPCE values were calculated using the equation:
IPCE = 1240 × Ilight / (λ × P) × 100% (1)
where λ (nm) is the wavelength of the monochromatic irradiation, Ilight (mA cm−2) is the
photocurrent density, and P (mW cm−2) is the incident photon flux for the monochromatic
irradiation. The flat band potential for Ta3N5 photoanode in a 0.5 M KPi electrolyte was
determined by the Mott−Schottky (M−S) method using a potentiostat-frequency response analyser
(METEK, VersaSTAT3-200) at a frequency of 1000 Hz and an AC amplitude of 10 mV. After
fitting the M−S plots, the flat band potential was derived from the intersection with the potential
axis in each plot.
![Page 3: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/3.jpg)
S3
Fig. S1. (A) Cross-sectional SEM images and (B) XRD patterns for Ta3N5/Ta/Ti on Si substrates
with Ta3N5 film thicknesses of (a) 570, (b) 1120, and (c) 1620 nm.
10 20 30 40 50 60
1120 nm
570 nm
1620 nm
Inte
nsity (
a.u
)
2 (degree)
Ta3N
5
Si
Si
Ta3N5Ta
Ti
Si
Ta3N5
Ta
Ti
Si
Ta3N5
Ta
Ti
2 μm2 μm2 μm
(a) (b) (c)
(B)
(A)
![Page 4: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/4.jpg)
S4
Fig. S2. XPS spectra of Ta3N5/Si (black lines), Ta3N5/Ta/Ti after the thin film transfer process (red
lines), and transferred Ta3N5/Ta/Ti after surface etching by a HF/HNO3/H2O (1:2:7, v/v) solution
(blue lines): (a) Ta 4f, (b) Si 2p, (c) N 1s, and (d) O 1s.
36 34 32 30 28 26 24 22 20
Ta loss feature
Ta 4f7/2
Ta 4f5/2
Inte
nsity (
a.u
.)
Binding Energy (eV)104 102 100 98 96 94 92 90
Si 2p1/2
Inte
nsity (
a.u
.)
Binding Energy (eV)
Si 2p3/2
402 400 398 396 394 392 390
Inte
nsity (
a.u
.)
Binding Energy (eV)
N 1s
536 534 532 530 528 526 524
Inte
nsity (
a.u
.)
Binding Energy (eV)
O 1s
(a)
(d)
(b)
(c)
![Page 5: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/5.jpg)
S5
Fig. S3. TEM FFT diffraction patterns of Ta3N5 near the surface of a Ta3N5/Ta/Ti photoelectrode.
Ta3N5
![Page 6: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/6.jpg)
S6
Fig. S4. Mott−Schottky (M−S) plot obtained from Ta3N5(570 nm)/Ta/Ti without Co(OH)x
cocatalyst. The linearly fitted M−S plot indicates that the flat band potential for the Ta3N5/Ta/Ti is
0.02 V vs. RHE, which is consistent with the previously reported value for Ta3N5 photoanodes.1, 2
-0.2 0.0 0.2 0.4 0.6 0.8 1.0 1.20
1
2
3
4
Potential (V vs. RHE)
C-2 (
10
13 c
m4 F
-2)
-0.2 0.0 0.2 0.4 0.6 0.8 1.0 1.20
1
2
3
4
![Page 7: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/7.jpg)
S7
Fig. S5. IPCE spectrum for the Co(OH)x/Ta3N5(570 nm)/Ta/Ti photoanode measured at 1.23 V vs.
RHE.
400 450 500 550 600 6500
10
20
30
40
@ 1.23 V vs. RHE
IPC
E (
%)
Wavelength (nm)
![Page 8: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/8.jpg)
S8
Fig. S6. Top-view SEM images of a Co(OH)x/Ta3N5(570 nm)/Ta/Ti photoanodes (a) before and (b)
after a static potential measurement at 1.23 V vs. RHE for 20 min.
1 μm1 μm
(a) (b)
![Page 9: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/9.jpg)
S9
Fig. S7. Schematic of the procedure used to prepare Ta3N5 films modified with various interfacial
layers between the Ta3N5 and Ta layers. (a) Ta3N5/MNx/Ta/Ti (M = Nb, Ti). A metallic Nb (or Ti)
film is initially deposited on the Ta/Si by sputtering. After oxidation (700 °C for 2 h) and
nitridation (900 °C for 2 h in a 100 sccm NH3 gas flow) of the M/Ta/Si (M = Nb, Ti) sample, a
layer of NbNx (or TiNx) is formed on top of the Ta3N5 thin film on the Si substrate. (b)
Ta3N5/CdS/Ta/Ti. A thin layer of CdS (approximately 60 nm) is deposited on top of the
as-prepared Ta3N5/Si sample using chemical bath deposition (CBD), employing a previously
reported method.3 After depositing the modified contact layers on the Ta3N5/Si samples, the Ta3N5
photoelectrodes are prepared by following the identical transfer procedure shown in Fig. 1 in the
main text.
M/Ta/Si MNx/Ta3N5/Si Ti/Ta/MNx/Ta3N5/Si
Ta3N5/Si CdS/Ta3N5/Si Ti/Ta/CdS/Ta3N5/Si
Sputtering
CBD
(a)
(b)
Ti/Ta/MNx/Ta3N5
Ti/Ta/CdS/Ta3N5
M = Nb, Ti
![Page 10: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/10.jpg)
S10
Fig. S8. Average photocurrent densities (n = 4, ±σ) of Ta3N5/Ta/Ti and Ta3N5/NbNx/Ta/Ti
photoelectrodes at different electrode potentials.
0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.30
1
2
3
4
Cu
rre
nt
De
nsity (
mA
cm
-2)
Potential (V vs. RHE)
Ta3N
5/NbN
x/Ta/Ti
Ta3N
5/Ta/Ti
![Page 11: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/11.jpg)
S11
Table S1 Work functions of various polycrystalline metals.4
Metal (Polycrystalline) Work function (eV)
Ta 4.25
Nb 4.30
Ti 4.33
Zr 4.05
Mg 3.66
![Page 12: Thin film transfer for the fabrication of tantalum nitride … · 2016-05-25 · S1 Supplementary Information Thin film transfer for the fabrication of tantalum nitride photoelectrodes](https://reader030.fdocuments.us/reader030/viewer/2022040816/5e5e3e4a833e777f7f4fad1c/html5/thumbnails/12.jpg)
S12
References
1. S. Khan, M. J. M. Zapata, M. B. Pereira, R. V. Goncalves, L. Strizik, J. Dupont, M. J. L. Santos
and S. R. Teixeira, Phys. Chem. Chem. Phys. 2015, 17, 23952-23962.
2. Y. Li, L. Zhang, A. Torres-Pardo, J. M. González-Calbet, Y. Ma, P. Oleynikov, O. Terasaki, S.
Asahina, M. Shima, D. Cha, L. Zhao, K. Takanabe, J. Kubota and K. Domen, Nat. Commun.
2013, 4, 2566.
3. M. A. Contreras, M. J. Romero, B. To, F. Hasoon, R. Noufi, S. Ward, and K. Ramanathan, Thin
Solid Films, 2002, 403, 204-211.
4. H. L. Skriver and N. M. Rosengaard, Phys. Rev. B, 1992, 46, 7157-7168.