The Next Generation of Folding Tonneau...
2
Folding Tonneau Covers. The Next Generation of Model Specific Install Guide Multiple Applications Chevy, Ford, Mazda, Dodge, Mitsubishi, Toyota, Nissan & Suzuki Form # FL71-M Modified June 2013 For Warranty Issues, Contact UnderCover Directly (866) 900 8800 www.flex-cover.com FORD/MAZDA FX21000 FX21002 FX21004 FX21010 FX21012 CHEVY FX11012 DODGE/MITSUBISHI FX31000 FX31001 FX31006 FX91001 TOYOTA FX41007 FX41009 FX41013 NISSAN/SUZUKI FX51003 FX51004 FX51005 FX51006 A. Clamp kit (6) B. Star knob (2) C. Front Retainer Clamp (2) D. Front Mounting Bolts (2) Lock Washer (2), Flat Washer (2) E. BulkHead Seal A B C D E Hardware Kit Check List 1 KIT - M
Transcript of The Next Generation of Folding Tonneau...
Folding Tonneau Covers.The Next Generation of
Model Speci�c Install Guide Multiple Applications
Chevy, Ford, Mazda, Dodge, Mitsubishi, Toyota, Nissan & Suzuki
Form # FL71-MModi�ed June 2013
For Warranty Issues, Contact UnderCover Directly(866) 900 8800 www.�ex-cover.com
FORD/MAZDAFX21000FX21002FX21004FX21010FX21012
CHEVYFX11012
DODGE/MITSUBISHIFX31000FX31001FX31006FX91001
TOYOTAFX41007FX41009FX41013
NISSAN/SUZUKIFX51003FX51004FX51005FX51006
A. Clamp kit (6)B. Star knob (2)C. Front Retainer Clamp (2)D. Front Mounting Bolts (2) Lock Washer (2), Flat Washer (2)E. BulkHead Seal
A
B
CD E
Hardware Kit Check List1
KIT - M
Multiple ApplicationsMODEL SPECIFIC GUIDE
© 2013 UnderCover, Inc. All rights reserved.
UnderCover, Inc.P.O. Box 620Rogersville, MO 65742(417) 753-8000(866) 900-8800
2 Attach Side Mounting Rails
Truck Speci�c Clamp Assembly
Truck Bed RailRail Spacer
Cover Mounting RailAttach both left and right side rails to the truck bed. The end of the mounting rail with the drain tube �tting will go towards the cab of the truck.
Position the top edge of the mounting rail �ush to 1/8" above the top edge of your truck bed rail, Figure 1 & 2. Using three (3) clamps per side attach the rail to the bed, position the clamps adjacent to each of the black rail spacers. (Tip: Mount the center clamp �rst but do not tighten completely. This will give you the ability to adjust the rail as the outer clamps are attached) Tighten the clamps using a 1/2” wrench or socket, Photo A.
Note: If you discover your truck will not allow you to position a clamp adjacent to the spacer, simply slide the spacer forward or back as needed.
Install the Bulkhead Seal to the front rail of the truck bed and cut to length.
A
1
2Warning! Do not overtighten the clamp assembly. A torque wrench is not necessary. If preferred, torque is apx 120 inch lbs.
Warning! Clamps must be checked periodically for tightness. Failure to do so could result in damage to you or your property.
