Testchief 642-902 Exam - implementing cisco ip routing

Cisco 642-902implementing cisco ip routing

10 Q&A

Version 3.0

http://www.testchief.com/642-902.htm



Leading the way in IT testing and certification tools, www.TestChief.com

- 2 -

Important Note, Please Read Carefully

Other testchief productsA) Offline Testing engineUse the offline Testing engine product topractice the questions in an exam environment.

Build a foundation of knowledge which will be useful also after passing the exam.

Latest VersionWe are constantly reviewing our products. New material is added and old material isrevised. Free updates are available for 90 days after the purchase. You should check yourmember zone at testchief and update 3-4 days before the scheduled exam date.

Here is the procedure to get the latest version:

1.Go towww.testchief.com2.Click on Log in3.The latest versions of all purchased products are downloadable from here. Just click thelinks.For most updates,it is enough just to print the new questions at the end of the newversion, not the whole document.

FeedbackIf you spot a possible improvement then please let us know. We always interested inimproving product quality.Feedback should be send to [email protected]. You should include the following:Exam number, version, page number, question number, and your login Email.

Our experts will answer your mail promptly.

CopyrightEach iPAD file is a green exe file. if we find out that a particular iPAD Viewer file isbeing distributed by you, testchief reserves the right to take legal action against youaccording to the International Copyright Laws.

ExplanationsThis product does not include explanations at the moment. If you are interested inproviding explanations for this exam, please contact [email protected].


- 3 -

www.testchief.com Q: 1 Refer to the exhibit. EIGRP has been configured on allrouters in the network. What additional configuration statement should be includedon router R4 to advertise a default route to its neighbors?

A. R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1B. R4(config)# ip default-network 10.0.0.0C. R4(config-router)# default-information originateD. R4(config)# ip route 10.0.0.0 255.0.0.0 10.1.1.1

Answer: B

www.testchief.com Q: 2 Refer to the exhibit. EIGRP is configured with the defaultconfiguration on all routers. Auto summarization is enabled on routers R2 and R3,but it is disabled on router R1. Which two EIGRP routes will be seen in the routingtable of router R3? (Choose two.)


- 4 -

A. 10.0.0.0/8B. 172.16.10.0/24C. 172.16.0.0/24D. 10.10.10.0/24E. 172.16.0.0/16F. 10.10.0.0/16

Answer: D, E

www.testchief.com Q: 3 EIGRP has been configured to operate over Frame Relaymultipoint connections. What should the bandwidth command be set to?

A. the CIR rate of the lowest speed connection multiplied by the number of circuitsB. the CIR rate of the lowest speed connectionC. the CIR rate of the highest speed connectionD. the sum of all the CIRs divided by the number of connections


- 5 -

Answer: A

www.testchief.com Q: 4 What is the difference between the IPv6 addresses ::/0 and::/128?

A. ::/0 is the default route, and ::/128 is the unspecified address.B. ::/0 is the unicast address, and ::/128 is the anycast address.C. ::/0 is the anycast address, and ::/128 is the multicast address.D. ::/0 is the unicast address, and ::/128 is the multicast address.E. ::/0 is the unspecified address, and ::/128 is the multicast address.F. ::/0 is the anycast address, and ::/128 is the default address.

Answer: A

www.testchief.com Q: 5 How is authentication handled with OSPFv3?

A. OSPFv3 for IPv6 authentication is supported by IPv6 IPsec.B. OSPFv3 for IPv6 authentication is supported by MD5 authentication.C. OSPFv3 for IPv6 authentication is supported by IPv4 IPsec.D. OSPFv3 for IPv6 authentication is supported by SHA-1 authentication.

Answer: A

www.testchief.com Q: 6 Which three are characteristics of IPv6? (Choose three.)

A. An IPv6 address is 128 bits long.B. An IPv6 header contains the header checksum field.C. An IPv6 header is 20 bits long.D. An IPv6 header contains the next header field.E. IPv6 routers send RA messages.F. An IPv6 header contains the protocol field.

Answer: A, D, E


- 6 -

www.testchief.com Q: 7 Which IPv6 address correctly compresses the IPv6 unicastaddress 2001:0:0:0:0DB8:0:0:417A? Select the best response.

A. 2001:0DB8:417AB. 2001::0DB8::417AC. 2001:::0DB8::417AD. 2001:0DB8:0:0:417AE. 2001::DB8:0:0:417AF. 2001:::0DB8:0:0:417A

Answer: E

www.testchief.com Q: 8 Refer to the exhibit. What two statements are true?(Choose two.)


- 7 -

A. This is the designated router (DR) on the FastEthernet 0/0 link.


- 8 -

B. The output was generated by the show ip interface command.C. The router was configured with the commands:router ospf 1network 172.16.6.0 0.0.0.255 area 1D. The IP address of the backup designated router (BDR) isFE80::205:5FFF:FED3:5808.E. Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command.F. OSPF version 2 has been enabled to support IPv6.

Answer: D, E

www.testchief.com Q: 9 Refer to the exhibit. On the basis of the output from theshow ipv6 interface command, what two statements must be true? (Choose two.)Select 2 response(s).


- 9 -

A. Interface Ethernet 0/0 was configured with the ipv6 ospf 1 area 1 command.B. Interface Ethernet 0/0 has been configured with the ipv6 ospf authentication ipsec spi500 md5 command.C. OSPF version 3 is enabled to support IPv6.D. The IP address of the designated router (DR) is FE80::A8BB:CCFF:FE00:6E00E. This is the designated router (DR) on the Ethernet 0/0 link.

Answer: B, C

www.testchief.com Q: 10 What is the IPv6 address FF02::2 used for?

A. all routers in a local segmentB. all routers in an autonomous system


- 10 -

C. all hosts in a local segmentD. all hosts in a particular multicast group

Answer: A

Testchief 642-902 Exam - implementing cisco ip routing

Documents

Transcript of Testchief 642-902 Exam - implementing cisco ip routing