TECHNICAL TRAINING 2008
description
Transcript of TECHNICAL TRAINING 2008
Technical Training 2008Technical Training 2008
TECHNICAL TRAINING TECHNICAL TRAINING
20082008
Technical Training 2008Technical Training 2008
Mini Chiller Panel Controller
V2.0
Technical Training 2008Technical Training 2008
Content
1. Mini Chiller Panel Controller V2.0
2. Inverter Parameter
3. Inverter Display
4. Other Information
Technical Training 2008Technical Training 2008
Mini Chiller Panel Controller V2.0
Main Board
Control Module, MC01 1 CP
Control Module, Inverter
Control Module, MC01 2 CPHandset, CH_XX2.0
WCCH
Chiller Panel V2.0
Control Module, MC01 HP TC2CP
Double Comp.
Tandem Comp.
Inverter
Single Comp.
Chiller Panel vs Main Board
Technical Training 2008Technical Training 2008
Mini Chiller Panel Controller V2.0
OutlineMAIN MENU
OPERATING MENU
TIMERS MENU
ALARM MENU
DISPLAY MENU
SETTING MENU SET PANEL ID
CHANGE PASSWORD
PANEL OPTION
SET PARAMETER GENERAL
SENSOR (OMITTED)
REGULATOR
COMPRESSOR
CONDENSER DEFROST
COOL MODE ANTIFREEZE
ALARM & CONTACT (P4~P19 OMITTED)
INVERTER
V2 EXV OPENING
V3 COMPRESSOR MANUAL SETTING
V4 EXV MANUAL SETTING
V5 DEFROST MODE
V1 COMPRESSOR FREQUENCY
Technical Training 2008Technical Training 2008
Mini Chiller Panel Controller V2.0
OutlineMAIN MENU
OPERATING MENU
SETTIGN MENU
TIMERS MENU
ALARM MENU
DISPLAY MENU DEFROST SENSOR
DISCHARGE SENSOR
COMP. RUN TIME
INVERTER CHILLER EXV OPENING
CURRENT
DC VOLTAGE
SUCTION SENSOR
BPHE IN SENSOR
BPHE OUT SENSOR
CONDENSER IN SENSOR
COMPRESSOR FREQUENCY
Technical Training 2008Technical Training 2008
Condenser Coil 1
Acc
Acc
Liq Rvr
Liq Rvr
BPHE FS
Condenser Coil 2
DischTemp 2
(Disch Comp 2)
DischTemp 1
(Disch Comp 1)
InvComp
StdComp
SuctTemp
(Suction)
HP1
HP2
LP2
LP1
Cond InTemp 1
(Condenser)
Cond OutTemp 1
(Def Comp 1)
BPHE OutTemp
(BPHE Out)
BPHE InTemp
(BPHE In)
EWT (Water In)
LWT (Water Out)
Pump
Cond OutTemp 2
(Def Comp 2)
FilterDrier
Heating Cap Tube
Check valve
Cooling Cap Tube
Check valve
FilterDrier
EXV
O/A Temp(Outdoor Air)
Summary Pages-Screen 3
Display Menu-Defrost Sensor
Display Menu-Inverter Chiller
Display Menu-Discharge Sensor
5ACV100CR
4WV
4WV
Schematic diagram
Inverter chiller schematic diagram
Technical Training 2008Technical Training 2008
Inverter Parameter
Technical Training 2008Technical Training 2008
Inverter Parameter
These parameter are only available when the Chiller Panel Controller V2.0 is connected to an Inverter Mini Chiller Model
V1 Cp Freq : 0Hz
V2 EXV : 0
V3 Cp Manual : Disable
V4 EXV Manual : Disable
V5 Def Mode : Disable
V1 : Compressor FrequencyIt allows to set the inverter compressor frequency (max frequency varies according to models)
V2 : EXV It allows to set the EXV opening (0~480 pulsation)
Technical Training 2008Technical Training 2008
Inverter Parameter
V1 Cp Freq : 0Hz
V2 EXV : 0
V3 Cp Manual : Disable
V4 EXV Manual : Disable
V5 Def Mode : Disable
V3 : Cp ManualThis parameter enables automatic or manual setting for compressor frequencyEnable : Manual setting is possibleDisable: Compressor frequency auto-run
V4 : EXV Manual This parameter enables automatic or manual setting for EXV openingEnable : Manual setting is possibleDisable: EXV opening auto-run
Technical Training 2008Technical Training 2008
Inverter Parameter
V1 Cp Freq : 0Hz
V2 EXV : 0
V3 Cp Manual : Disable
V4 EXV Manual : Disable
V5 Def Mode : Disable
V5 : Def ModeThis parameter enables automatic intelligent or standard defrosting settingEnable : Manual setting for defrosting is possible in Parameter D1~D6Disable: Intelligent defrosting (auto-run)
Technical Training 2008Technical Training 2008
Inverter Display
Technical Training 2008Technical Training 2008
Inverter Display
These parameter are only available when the Chiller Panel Controller V2.0 is connected to an Inverter Mini Chiller Model
Inverter Chiller
Comp : 45Hz
EXV : 500
Comp Amp : 9.7A
DC Bus : 385V
Compressor FrequencyIt shows the operating inverter compressor frequency (Hz)
EXV It shows the operating EXV opening (pulse)
Comp AmpIt shows the operating inverter compressor running current (A)
Screen 1
Technical Training 2008Technical Training 2008
Inverter Display
DC BusIt shows the operating DC voltage in the inverter system (V)
Inverter Chiller
Comp : 45Hz
EXV : 500
Comp Amp : 9.7A
DC Bus : 385V Screen 1
Technical Training 2008Technical Training 2008
Inverter Display
SuctionIt shows the inverter compressor suction temperature (°C)
BPHE InIt shows the refrigerant inlet temperature at the BPHE during Cooling Mode. During Heating Mode, the value shows refrigerant outlet temperature at BPHE (°C)
Inverter Chiller
Suction : 15.5°C
BPHE In : 45.9°C
BPHE Out : 18.3°C
Condenser : 28.4°C Screen 2
Technical Training 2008Technical Training 2008
Inverter Display
BPHE OutIt shows the refrigerant outlet temperature at the BPHE during Cooling Mode. During Heating Mode, the value shows refrigerant inlet temperature at the BPHE (°C)
CondenserIt shows the inverter condenser coil inlet temperature (°C)
Inverter Chiller
Suction : 15.5°C
BPHE In : 45.9°C
BPHE Out : 18.3°C
Condenser : 28.4°C Screen 2
Technical Training 2008Technical Training 2008
Other Information
Technical Training 2008Technical Training 2008
Other Information
If the Chiller Panel V2.0 is connected to a Non Inverter Mini Chiller, the following information will display “--”
V1 Cp Freq : --
V2 EXV : --
V3 Cp Manual : --
V4 EXV Manual : --
V5 Def Mode : --
Inverter Parameter V1~V5
Inverter Chiller
Comp : --
EXV : --
Comp Amp : --
DC Bus : --
Inverter Chiller
Suction : --
BPHE In : --
BPHE Out : --
Condenser : --
Display Menu for Inverter Chiller
Screen 1 Screen 2
Technical Training 2008Technical Training 2008
Other Information
Alarm & Contact Parameter P1~P3 will display
P1 FS Confirm : 5s
P2 FS Delay : 180s
P3 LP Delay : 30s
P4 CO Reset : ManualP5 HP Reset : AutoP6 LP Reset : AutoP7 FO Reset : ManualP8 PO Reset : ManualP9 FS Reset : ManualP10 Aux Reset : ManualP11 A/F Reset : ManualP12 CO Contact : NormalP13 HP Contact : NormalP14 LP Contact : NormalP15 FO Contact : NormalP16 PO Contact : NormalP17 FS Contact : NormalP18 EA Contact : NormalP19 DE Contact : Normal
Parameter P4~P19 and Sensor Parameter had been omittedS1 Water Enter : 0.0°CS2 Water Leave : 0.0°CS3 Air Sensor : 0.0°CS4 Defrost 1 : 0.0°CS5 Defrost 2 : 0.0°CS6 Defrost 3 : 0.0°CS7 Defrost 4 : 0.0°CS8 Cp Dish 1 : 0.0°CS9 Cp Dish 2 : 0.0°CS10 Cp Dish 3 : 0.0°CS11 Cp Dish 4 : 0.0°C
Technical Training 2008Technical Training 2008
Other Information
If the Chiller Panel V1.0 is connected to an inverter mini chiller, there shall be no Inverter features.
Alarm & Contact P4~P19 and Sensor Parameter will display “00”
Technical Training 2008Technical Training 2008
Thank YouThank You