Technical Specifications Setup Guide - Devex Systems
Transcript of Technical Specifications Setup Guide - Devex Systems
Setup Guide
X Thermostat TS500Electronic Timer Thermostat
Table of ContentsTechnical SpecificationsInstaller Guide
Dimensions
Included in the box
Installer Guide
Technical specifications
Dimensions
Mounting Instructions
TS 500 setup
Home screen information
Timer setup
X Thermostat TS 500 3m 15 kOhms NTC sensor
User Guide
2
4
2
2
3
4
5
6
Included in the box 1
1 2
5/83 Bassett StreetMONA VALE NSW 2103
PO Box 707MONA VALE NSW 1660
Phone: 1800 636 091Fax: 02 9997 7852
email: [email protected]
Sensing TypeMountingMeasuring accuracyOperating temperatureSetting temperature rangeElectrical protectionMain switchPower supplyOutputType of external sensor
Air / Floor / Air-FloorSurface mounted0.1°C0ºC - 50°C5ºC - 35°CClass II - IP21Two poles 16A230Vac +/- 10% 50Hz
NTC - 15 kOhms at 25°CRelay 16A 250Vac resistive load
118
56
4280
MON24
18 6
12
?
copy
add
The installation wizard will give you step by stepinstructions.
Mounting Instructions Home screen information Timer setup User GuideTS 500 Setup
Min 20cm
~1,50m
1. Thermostat should bepositioned within theseconstraints
Fix the backcover plateto the steel frame usingthe four corner holes.
Swiping dots (number can varydepending on your configuration).Click to access additional information.
Measured temperature When in doubt, refer to the helpbutton to guide you throughthe setup
Tap the appropriate set up
Tap CANCEL for previous screen
The green arrows are used toscroll up or down throughavailable selections
Tap OK for next screen
Tap "copy" to copy the currentcurrent programming (in thiscase for Monday) to any otherday of the week.
Heating schedule appears onthe clock once setup complete(i.e. heat on, every Monday 6-9am). To edit or delete, tap the red schedule.
Error icon. Clickfor additional information
Desired temperatureTo turn off theheating, insure the Timer is OFF beforetoggling to OFF
Note: The thermostat cannot be mechanicallyswitched off. However, it will consume minimalelectricity in sleep mode.
Timer icon appearswhen on
2.
653 4
Set up heating type
OKCANCEL
underfloor heating
overhead heating
radiator panels
Change floor sensor
OKCANCEL
15KTo add a heating schedule, tap "add"
Wire the thermostat accordingto this wiring diagram
3.
(default)
25.0°27.0°
ON
Menu Timer