Tech Tip - Kingpin · 01/January/2006 Page 6 Revision A TECH TIP PFM0001E Figure 7: Support Board....
Transcript of Tech Tip - Kingpin · 01/January/2006 Page 6 Revision A TECH TIP PFM0001E Figure 7: Support Board....
01/January/2006 Page 1 Revision A
CAB DOLLYAuthor: Randy Baumann
All information, illustrations and specifications are basedon the best information available at the time of publication.The author cannot guarantee the accuracy of theinformation contained in this publication. Corrections arewelcomed, and can be submitted to [email protected].
NOTE: This cab dolly was designed to be used with a late1930’s—mid 1940’s Chevrolet® and GMC® trucks,but with modification, it may be adapted for use inother applications.
This cab dolly can be useful to support and move the cabwhile it is removed from the frame. It also provides a stablework platform for repairing the cab.
A410001A
Figure 1: Front View
Chevrolet is a registered trademark of the Chevrolet Motor Division of the General Motors Corporation.
GMC is a registered trademark of the GMC Truck Division of the General Motors Corporation.
A410003A
Figure 2: Side/Rear View
01/January/2006 Page 2 Revision A
TECH TIP
CABDOLLY
Figure 3: Assembly Drawing
01/January/2006 Page 3 Revision A
TECH TIP
PFM0001B
Figure 4: Top Plate
01/January/2006 Page 4 Revision A
TECH TIP
PFM0001C
Figure 5: Side Board
01/January/2006 Page 5 Revision A
TECH TIP
PFM0001D
Figure 6: End Board
01/January/2006 Page 6 Revision A
TECH TIP
PFM0001E
Figure 7: Support Board
01/January/2006 Page 7 Revision A
TECH TIP
PFM0001F
Figure 8: Bottom Board