TD Homework
-
Upload
sharifa-mcleod -
Category
Documents
-
view
219 -
download
0
Transcript of TD Homework
-
8/14/2019 TD Homework
1/8
Technical DrawingSectioning
School : Ardenne High SchoolName : Delano SeniorTeacher : Ms. AllisonClass : 114H
-
8/14/2019 TD Homework
2/8
This technique is used to show the exterior and interior of a symmetrical object in a single
projection view. The cutting plane cuts halfway to the axis or center of the object. A quarter of
the object is imagined to be removed. The resulting drawing view is a half outside and half
section view.
-
8/14/2019 TD Homework
3/8
A broken-out section view cuts away a portion of an assembly in a drawing view to expose the
inside. Cross hatching is automatically generated on the sectioned faces of all components. A
broken-out section is part of an existing drawing view, not a separate view. A closed profile,
usually a spline, defines the broken-out section. Material is removed to a specified depth to
expose inner details. Specify the depth by setting a number or by selecting geometry in a
drawing view. You cannot create a broken-out section on a detail, section, or alternate position
view. If you create a broken-out section of an exploded view, you cannot collapse the explodedview.
-
8/14/2019 TD Homework
4/8
Revolved section shows only the features on the cut plane. It is used to depict the section of an
elongated object without the need to show the entire sectional view. Instead of projecting the
section onto an adjacent view, the resulting section obtained from the cutting is revolved 90
and is placed on the same view.
-
8/14/2019 TD Homework
5/8
If the important internal features of an object are not lying on a single plane, a full section may
not be able to show all the details. Offset section is a technique whereby the cutting plane offsets
to pass through various features that would otherwise be missed by a full section. Thick lines
should be used at the change of direction of the cutting plane.
-
8/14/2019 TD Homework
6/8
You can create an aligned section view in a drawing through a model, or portion of a model, that
is aligned with a selected section line segment. The aligned section view is similar to a Section
View, but the section line for an aligned section comprises two or more lines connected at an
angle. The aligned section rotates the cut into the plane of the selected segment. Aligned section
views are typically used for sectioning features that would appear foreshortened in regularsection views.
-
8/14/2019 TD Homework
7/8
Removed section is similar to revolved section in that only the cut plane is shown. However, the
section is placed elsewhere on the drawing.
-
8/14/2019 TD Homework
8/8
Part section is a technique that is used to expose a small part of the interior of an object by
removing a small part of the object. The view is basically an outside view with a small portion
removed. The break line is illustrated with irregular thin continuous lines.