supercritical anti solvent
-
Upload
maryam-kazemi -
Category
Health & Medicine
-
view
49 -
download
0
Transcript of supercritical anti solvent
![Page 1: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/1.jpg)
![Page 2: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/2.jpg)
In the name of GodApplication of supercritical
antisolvent method in drug encapsulation
Maryam kazemi Ph.D student of pharmaceutics
Shiraz university of medical sciences
![Page 3: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/3.jpg)
The ideal drug delivery method:
Safe InertComfortable for patient Biocompatible Easily administered or removable High drug loading Using biodegradable polymers for drug en-capsulation is one of the best ways to achieved this ideal method .
![Page 4: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/4.jpg)
Supercritical fluid properties:
• SCF is a solvent
• Tempreture & pressure are greater than its critical T , P.
• It remains as a single phase
![Page 5: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/5.jpg)
![Page 6: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/6.jpg)
The best SCF is CO2:• Non toxic
• Inert
• Low critical T=304 k & low critical P =7.38 MPa.
• Poor solubility for many polymers & drugs /rapid mixing with the solvent.
• Low viscosity like a gas , Its density similar to the liquid
• Its ability to provide a non degrading and nonoxidizing environment for sensitive compounds.
![Page 7: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/7.jpg)
Limitation of SCF:
Non biocompatibility or toxicity of the polymers.
Unwanted by product of degradation .
Higher cost
![Page 8: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/8.jpg)
![Page 9: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/9.jpg)
The anti solvent application
Bleich and coworkers firstly discovered .
CO2= anti solvent percipitation of the solute from an organic solvent.
![Page 10: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/10.jpg)
The base of this technique is:
• Dissolving a large volume of a SCF by an organic solvent .
• Reciprocal miscibility of the SCF CO2 & an organic solvent
• The low afinity of SCF for solute.
![Page 11: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/11.jpg)
Mechanism of SAS• SC Co2 is pumped in to the high pressure vessel to a
specific pressure .
• Solution (drug+biodegredable polymer+organic solvent ) is sprayed in the reactor via a suitable nozzle.
• CO2 diffused in the solvent evaporated in the gas phase & the solvent diffuses rapidly from the solution droplet in to the bulk SCF percipitation the solute.
![Page 12: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/12.jpg)
![Page 13: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/13.jpg)
![Page 14: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/14.jpg)
• Formed particles are collected on a filter
Washed with SCF to remove the resitual solvent
SCF dissolving into the liquid droplet
Evaporation of the organic solvent in the SCF phase
Later percipitate
![Page 15: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/15.jpg)
Disadvantages of this method
• Long washing period aggregation particlesTo minimize :intensivly mixing SAS & solution Method : Using Ultra sonic nozzles 10-100 kHZIncrease mass transfer between SCF & solution
Smaller droplet
![Page 16: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/16.jpg)
![Page 17: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/17.jpg)
Effects of the process parameters on the particle size in the supercritical antisolvent (SAS) process
Effects of pressure:
At higher pressure, obtained smaller particle size. At higher pressure, the deforming pressure forces must be increased to break the droplets into smaller particles. Moreover, particle nucleation and its growth are other important factors affecting particle size. Rapid mass transfer of antisol-vent and solvent causes high supersaturations for the solute. High su-persaturation results in rapid nucleation and growth of more than one particle per primary droplet.
At lower pressure, obtained smaller particle size. In a situation above the critical condition, reduction in pressure is observed to decrease the solu-bility which then results in higher maximum supersaturation in the reac-tor; therefore, smaller particles are produced.
Pressure variations have no significant effect on particle size because the free intermolecular volume of the polymer will be occupied at the saturation pressure.
![Page 18: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/18.jpg)
Effects of temperature
At higher temperature smaller size and more spherical particles obtained. But the temperature must be lower than the Tg of the polymer.
At lower temperaturesmaller particle size,obtained due to higher volatility.
![Page 19: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/19.jpg)
Effects of chemical composition of the organic solvent Particle size decreases with increase in volatility of the solvent. Particle size decreased by using a stronger solvent. Solubility of the biodegradable polymer in the or-
ganic solvent must be higher than the solubility of its drug Contents.
![Page 20: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/20.jpg)
Effects of chemical composition of the drug
Lower solubility of the drug in a supercritical fluid enhances rapid precipitation.
Enhancement of drug lipophilicity reduces the loading drug efficiency in the SAS process
![Page 21: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/21.jpg)
Effects of chemical composition of the biodegradable polymer
The crystalline polymer forms smaller particle size with narrower particle size distribution.
Drug stability in amorphous polymers is higher than in crystalline polymers
![Page 22: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/22.jpg)
Effects of the nozzle geometry
A smaller nozzle diameter reduces the particle size and produces more spherical-shaped particles.
The effect of the nozzle diameter is not highly significant.
Co-axial nozzle, is especially designed for improvement of the morphology.
![Page 23: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/23.jpg)
Effects of flow rates of CO2 and liquid phase
Increasing the ratio of CO2 flow rate over the organic solution flow rate reduces particle size.
![Page 24: supercritical anti solvent](https://reader035.fdocuments.us/reader035/viewer/2022070515/587b05ee1a28ab93488b749f/html5/thumbnails/24.jpg)
• References:
• M. Kalani, R. Yunus, Application of supercritical antisolvent method in drug encapsulation: a review, International Jour-nal of nanomedicine 6 (2011) 1429‐1442.