SUPER SEAL S-10 is a solvent-based penetrating sealer made of a special hybrid formula designed to protect concrete surfaces from staining, freeze-thaw and salt damage. Siloxane guards the surface concrete while Silane penetrates deeply to protect steel wire and rebar.

SUPER SEAL S10Solvent Based Penetrating Reactive Silane & Siloxane

Penetrates Through Solvent-Based Acrylic Sealed Concrete!

Made in USA

CLEMONS CONCRETE COATINGS505 Cave Road H Nashville TN 37210 H www.ccc-usa.com H Tel: 615-872-9099

Freeze-Thaw Protection

Salt Protection

Non Film Forming/Non Slip

Does not alter appearance of the surface

Low VOC

Made in U.S.A.

CLEMONS CONCRETE COATINGS505 Cave Rd H Nashville TN 37210 H www.ccc-usa.com H Tel: 615-872-9099 H Fax: 615-872-9052

SUPER SEAL S10

Colors will vary on each surface. Sample before proceeding.

DISCLAIMER: Since manufacturer has no control over handling, use or storage; no guarantee expressed or implied, is offered. The suitability of the product for use shall be solely up to the user. Manufacturer retains the right to venue.

TOOLS & MATERIALS REQUIREDH Solvent-resistant pump sprayer, brush, or roller of appropriate nap length H Pressure washer (cured concrete only) H Eye protection, rubber gloves, paper mask H A1 Solvent or Xylene for clean up

SURFACE PREPARATIONCured concrete: surface should be clean and dry. Use 3000 psi power washer to clean the surface. Remove oil and grease spots with Clemons CLEANER DEGREASER. Allow 24 hours to dry before sealing. Smooth concrete should be etched with Clemons’ ETCH & CLEAN followed with Clemons’ CLEANER DEGREASER and rinsed with clean water.

APPLICATIONSurface temperature should be between 50ºF and 90ºF. This product can be applied with a solvent-resistant pump sprayer, brush, or roller of the appropriate nap length. Cross rolling should be performed for all application methods. When applying over a Cure & Seal membrane, use a roller to even out the resin film after applying SUPER SEAL S10. Do not allow the material to puddle. After 3-5 minutes, move material that isn’t absorbed to more porous areas and apply additional material to areas that are light in color. Due to low viscosity, care should be taken during roller application to avoid puddling. The substrate must be completely dry prior to application. Do not apply this material over waterborne resin coatings. Care should be taken to ensure even coverage rate

NET COVERAGE RATEBroomed Finish: 200 ft2 per gallon Smooth Finish: 300 ft2 per gallon Exposed Aggregate: 100 ft2 per gallon *Very porous surfaces may require two applications

TECHNICAL DATA VOC: <200 g/L Flash Point: 40°F DOT: UN1263 / Paint / 3 / PGIISolvent: Aromatic Petroleum Naphtha & Tert-Butyl AcetateSolids: 10% (higher solids available upon request

CC-SSS10-0515

Penetrating Reactive Silane & Siloxane

HMIS Health 1 Flammability 3 Reactivity 0 Protection G