SSTB-EXPL11 2011 Ford ExplorerSecureStor Vault Mounting Instuctions

CAUTION: Always check before drilling or screwing to be certain not to hit anything(fuel tank, lines, wiring, etc) beneath the carpet, the transmission hump or under thevehicle.

Rear Mounting: Lift rear seats upright. Remove rear threshold plastic trim. Screw smallbracket into floor under plastic threshold using luggage clip boltsas shown in Figure1. Notch out plastic trim as shown in Figure 2. Replace plastic trim andstow seats to level the floor.

Attach flat brackets to the bottom of the supplied rail using 3/8” hardware and leave loose forrail adjustment. Attach flat bracket to the short rear mounting bracket w/ 3/8” hardware.(Figure 3)

Front Mounting: Remove seat belt attachment near floor. Install “L” bracket under the seatbelt bracket and tighten. (Figure 4) Lower seats back to flat position

Install the vault in the vehicle, align rail and seat belt bracket with pems in side of vault.Tighten all bracket and rail hardware when properly positioned. Attach SecureStor vault with3/8 hardware and tighten securely.

Be certain spare tire jack is accessible before installing vault. For access to spare tire,wing bolts can be substituted for 3/8” bolts. Remove wing bolts and slide vault forward.

04/11

Figure 1

Figure 4

Notch plastictrim here

Factory tie-downbolts

Figure 2

Figure 3

“L” bracketunder factoryseat belt bolt

Wing boltsfor spare tireremoval

Wing boltsfor spare tireremoval