Setup Guide for Taneer Tools V13.0 (M.Tech)

1. Extract the Taneer Tools

Right Click ( Extract Here2. Go to Taneer Tools_V13_LND

3. Click Setup4. Setup will Continue without any Modifications

5. Click Finish

6. Select only when License manager shows the message select ( local License7. Go on to Next to Continue When the Message Taneer Tools are successfully installed 8. Go to Taneer Tools_V13_LND (where is been Extracted)

9. Go to Legend Folder Copy the Following

TannerTools_13_Calculator TannerTools_13_Corrector

10. Go to Below Steps C: (Program Files: (Taneer Eda:

11. Paste the Selected Items

12. Double Click on TannerTools_13_Corrector

13. After receiving message Press any Key

14. Go to Below Steps: C: (Program Files: (Taneer Eda:15. Double Click on TannerTools_13_Calculator16. Go to Start: ( Programs: ( Taneer Eda: ( Utitlities: ( Computer Id: (Copy the Ethernet Value(not available copy IP Address)17. Write down the Copied value into TannerTools_13_Calculator Editor18. After receiving the License (Lservrc) file press any key19. Go to C: (Program Files: (Taneer Eda: copy the Lservrc file 20. Paste the Lservrc file in following Paths

1) C: (Program Files: (Taneer Eda: ( Taneer Tolls V13.0: 2) C: (Program Files: (Taneer Eda: ( Taneer Tolls V13.0: (px: (WIN 32.2-I686: ( bin: 3) C: (Program Files: (Taneer Eda: ( Taneer Tolls V13.0: ( VerilogA: ( Vacomp: ( bin: 21. Close all opened Files

22. Click on L-Edit shortcut on Desktop23. Click Setup on Dailog Box

24. Continue to Next steps without any Modifications25. Click finish button

26. Setup successfully Installed