Spiral Rope Chain
-
Upload
angelo-silva -
Category
Documents
-
view
213 -
download
0
Transcript of Spiral Rope Chain
-
7/30/2019 Spiral Rope Chain
1/3
This is a beautiful and impressive stitch, but easy to learn and relatively fast to work up. Color combinations like silver core beads
with black outers or gold and dark purple, as shown above, are particularly striking. This stitch makes an excellent strap for an amulet
bag, a nice braided necklace, or a striking bracelet, among many other uses.
Materials:
Size A Nymo is recommended, as the outer beads take some stress.
#12 or smaller beading needle
Two or more colors of Delicas or 11/0 or larger seed beads
Begin with 3 ft of size A Nymo(tm). You can use a shorter working length, but know that this stitch eats up a lot of thread quickly.
There are instructions below on how to add a new thread. The beads used in the core should have large(ish) holes, as the thread must
make several passes through them. Delicas and size 11/0 Czech or Japanese seeds tend to work best. Choose two contrasting colors,
or a light and dark of the same hue, one for the core, and one for the outer beads. Lastly, use a thread color that matches your beads
best. The thread does tend to show slightly in this stitch, at least in my experience.
1) Load on four core beads and three outer beads. Bring them down near the end of your thread, leaving about a 4 inch tail. See
Figure 1 below.
2) Bring your needle back through the core beads only, from behind, and pull the beads into a closed loop. See Figure 2. Be sure youpinch the tail thread tightly between your fingers, up against the beads, to keep them from slipping off. You'll need to hold it for
several stitches.
Wholesale Korean Jewelry
www.cnvp-jewelry.com
Korean Jewelry Wholesale Min Order $100 mixed,Factory Price!
Close Ad
na's Beads -- Spiral Rope Chain http://www.angelfire.com/co2/beltana/s
3 29/03/20
-
7/30/2019 Spiral Rope Chain
2/3
3) Load one core bead and three outers. Again from behind, bring your needle into just the top three core beads, as well as the core
bead you just added (making 4 beads total). Pull snugly so that the outer beads touch the core, and slide them over so that their sides
touch the first set of outer beads. See figure 3.
4) Repeat step 3 until your chain is as long as you want it. Keep in mind that the core stitch "moves up" one bead per pass. You are
always going to go into the topmost three beads plus the newly-added bead on each pass (4 beads every time). It will take 6 to 8
repeats before you begin to see the spiraling effect. You will have to hold the tail of the chain for several repeats or the thread could
pull through. Weave the tail and your working end back into the chain when you are done.
Add new thread by leaving a few inches of your old working thread at the top, and securely weave in a new thread one to two inches
below the stop point up to the top, leaving a tail where you began. You can weave these tails back in later to hide them, too. Snugtension on this stitch doesn't seem to distort it, as it can on brick and peyote stitch. But then, maybe you pull harder than I do, so use
your best judgement.
This stitch lends itself well to a "freeform" version, similar to freeform peyote. You can randomly substitute larger beads, gemstone
chips, crystal beads or small seashells in place of a set of the outer beads. Also, you can use smaller beads than 11/0, but remember
that because of the number of passes the thread makes, you'll have to use accordingly thinner thread. This could make longer pieces
weaker.
Ending this piece can be done with adding one more round of three outer beads only--no more core beads at this point--then moving
up through the topmost two core beads and adding two outers, move up to the topmost core bead and add one bead, etc. It usually
takes two or three single beads at the top to fully fill it in, so you'll go through that last core bead 5 or 6 times total.. Then you can
add a larger bead to the top and string a loop of 9 or 11 seed beads, to which you can add a clasp. Here is a work in progress in which
I am just about to add this loop. Note, if you can see them, the white threads along the piece that indicate where I ended and added
thread. See below.
na's Beads -- Spiral Rope Chain http://www.angelfire.com/co2/beltana/s
3 29/03/20
-
7/30/2019 Spiral Rope Chain
3/3
If you have a question, e-mail me using the address (reproduced in text format only) found on this site's home page: HOME. I'llget back to you as quickly as I can.
All images and instruction format are Deborah Walker, 2000 and may not be reprinted or reproduced in any form, save for personal
educational purposes, without express written consent of the author. These instructions MAY NOT be used on other web pages, nor
may they be copied in any manner or distributed in classes without prior permission and payment of a fee to the author.
Compartilhe com a Oi
Plus.Google.com/Oi
Suba Todas as Suas Fotos no Google+ Do Seu Oi. Confira e CompartilheSponsored by
na's Beads -- Spiral Rope Chain http://www.angelfire.com/co2/beltana/s
3 29/03/20