Sparkle Ortho-JetProduct IdentificationFast curing orthodontic acrylic resin

Package ContentsREF 2920 Net Wt. 100gREF 2930 Net Wt. 454gREF 2950 Net Wt. 2.3kgREF 2928 Net Vol. 6x30ml; Net Wt. 100g;

glass dropper; powder dispenser cap Intended PurposeThis product is intended for the fabrication of orthodontic appliances. When used as instructed,product is 100% effective.

Storage Conditions/InstructionsKeep away from heat, sparks and openflame. Keep container closed when notin use. Store in original container. Storebetween 36°F and 90°F (2°C and 32°C).

Operating/Handling InstructionsLiquid may cause skin irritation. Avoidcontact with skin, eyes and clothing.Wear protective gloves, safety glasseswith side shields or chemical splashgoggles. Avoid prolonged breathing ofvapors. Use with adequate ventilation.Do not smoke in the presence of opencontainers. See Material Safety DataSheet for complete information. MSDSis available at www.langdental.com orby contacting manufacturer.

Warning: flammable liquid. Contains: MethylMethacrylate Monomer, Inhibited. Flash Point: 52.7°F(12°C), (T.C.C.) NFPA, NPCA-HMIS #: H-2,F-3, R-2.

F - Highly Flammable

Xn - Harmful

ContraindicationsSparkle Ortho-Jet is contraindicated in patients withallergies to chemicals.

Other Materials/Equipment Needed1. Tin foil substitute solution2. Orthodontic wire3. Sticky wax4. Arbor band or stone5. Acrylic sealant or pumice and high shine6. Pressure curing unit, optional

Instructions for Use1. On a prepared model, bend wire in conventionalmanner.

2. Attach wire to model with sticky wax.

3. Place model in water and soak for five minutes.

4. Remove model from water and blow off excesswater. Paint a thin coat of tin foil substitute solutionon model and let dry for about one minute.

5. Moisten surface with Ortho-Jet liquid. Then applySparkle powder from dispenser bottle. Alternate liquid and powder until desired shape and thicknessis achieved. Always begin and end with liquid for bestresults.

6. Allow acrylic to gel for approximately two minutes.Cure acrylic, while still on model an additional 10minutes, either on bench or, for better results, inpressure pot at 30 psi.

7. Remove from model after acrylic is cured and trimusing an arbor band or stone. Grind to a smooth finish.

8. Polish using an acrylic sealant or pumice and highshine.

L

DisposalDispose of unused material in accordance with local,state, and national legislation.

WarrantyManufacturer warrants this product to be free frommanufacturing defects for one year from date of purchase. Warranty is void if product is used for otherthan intended purpose or other than instructed.

Lang Dental Mfg. Co., Inc.Wheeling, IL 60090-0969www.LangDental.com Made in USAPh 847-215-6622Fax 847-215-6678

Authorized Representative in EU:MediMark® Europe BP 233238033 Grenoble Cedex France

LDD 29 REV.4